Magnetic Sensors with Picotesla Magnetic Field Sensitivity at Room Temperature

2008 ◽  
Author(s):  
Sy-Hwang Liou
Keyword(s):  
Magnetic Field ◽  
Room Temperature ◽  
Magnetic Sensors ◽  
Field Sensitivity

Magnetoelectric Sensors With Directly Integrated Charge Sensitive Readout Circuit—Improved Field Sensitivity and Signal-to-Noise Ratio

2011 ◽  
Vol 11 (10) ◽  
pp. 2260-2265 ◽  
Author(s):  
Zhao Fang ◽  
Ninad Mokhariwale ◽  
Feng Li ◽  
Suman Datta ◽  
Q. M. Zhang
Keyword(s):  
Room Temperature ◽  
Signal To Noise Ratio ◽  
Low Noise ◽  
Magnetic Sensors ◽  
Readout Circuit ◽  
Signal To Noise ◽  
Low Frequencies ◽  
Field Sensitivity ◽  
Piezoelectric Layers ◽  
Noise Ratio

The large magnetoelectric (ME) coupling in the ME laminates makes them attractive for ultrasensitive room temperature magnetic sensors. Here ,we investigate the field sensitivity and signal-to-noise ratio (SNR) of ME laminates, consisting of magnetostrictive and piezoelectric layers (Metglas and piezopolymer PVDF were used as the model system), which are directly integrated with a low noise readout circuit. Both the theoretical analysis and experimental results show that increasing the number of piezoelectric layers can improve the SNR, especially at low frequencies. We also introduce a figure of merit to measure the overall influence of the piezolayer properties on the SNR and show that the newly developed piezoelectric single crystals of PMN-PT and PZN-PT have the promise to achieve a very high SNR and consequently ultra-high sensitivity room temperature magnetic sensors. The results show that the ME coefficients used in early ME composites development works may not be relevant to the SNR. The results also show that enhancing the magnetostrictive coefficient, for example, by employing the flux concentration effect, can lead to enhanced SNR.

Magnetic Emission Mapping for Passive Integrated Components Characterisation

2003 ◽  
Author(s):  
O. Crépel ◽  
Y. Bouttement ◽  
P. Descamps ◽  
C. Goupil ◽  
P. Perdu ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Mobile Phone ◽  
Printed Circuit Board ◽  
Magnetic Sensors ◽  
Circuit Board ◽  
Magnetic Disturbance ◽  
Passive Components ◽  
Printed Circuit ◽  
Integrated Inductor ◽  
The Magnetic Field

Abstract We developed a system and a method to characterize the magnetic field induced by circuit board and electronic component, especially integrated inductor, with magnetic sensors. The different magnetic sensors are presented and several applications using this method are discussed. Particularly, in several semiconductor applications (e.g. Mobile phone), active dies are integrated with passive components. To minimize magnetic disturbance, arbitrary margin distances are used. We present a system to characterize precisely the magnetic emission to insure that the margin is sufficient and to reduce the size of the printed circuit board.

scholarly journals All organic multiferroic magnetoelectric complexes with strong interfacial spin-dipole interaction

2021 ◽  
Vol 5 (1) ◽  
Author(s):  
Yuying Yang ◽  
Zhiyan Chen ◽  
Xiangqian Lu ◽  
Xiaotao Hao ◽  
Wei Qin
Keyword(s):  
Magnetic Field ◽  
Light Intensity ◽  
Room Temperature ◽  
Incident Light ◽  
Dipole Interaction ◽  
Interfacial Interaction ◽  
Magnetoelectric Coupling ◽  
Incident Light Intensity ◽  
Organic Ferromagnets ◽  
Magnetoelectric Coefficient

AbstractThe organic magnetoelectric complexes are beneficial for the development on flexible magnetoelectric devices in the future. In this work, we fabricated all organic multiferroic ferromagnetic/ferroelectric complexes to study magnetoelectric coupling at room temperature. Under the stimulus of external magnetic field, the localization of charge inside organic ferromagnets will be enhanced to affect spin–dipole interaction at organic multiferroic interfaces, where overall ferroelectric polarization is tuned to present an organic magnetoelectric coupling. Moreover, the magnetoelectric coupling of the organic ferromagnetic/ferroelectric complex is tightly dependent on incident light intensity. Decreasing light intensity, the dominated interfacial interaction will switch from spin–dipole to dipole–dipole interaction, which leads to the magnetoelectric coefficient changing from positive to negative in organic multiferroic magnetoelectric complexes.

scholarly journals Review of Multi-Physics Modeling on the Active Magnetic Regenerative Refrigeration

2021 ◽  
Vol 26 (2) ◽  
pp. 47
Author(s):  
Julien Eustache ◽  
Antony Plait ◽  
Frédéric Dubas ◽  
Raynal Glises
Keyword(s):  
Magnetic Field ◽  
Low Temperatures ◽  
Room Temperature ◽  
State Of The Art ◽  
Vapor Compression ◽  
Crucial Step ◽  
Potential Alternative ◽  
Vapor Compression Refrigeration ◽  
Preliminary Study ◽  
Physics Modeling

Compared to conventional vapor-compression refrigeration systems, magnetic refrigeration is a promising and potential alternative technology. The magnetocaloric effect (MCE) is used to produce heat and cold sources through a magnetocaloric material (MCM). The material is submitted to a magnetic field with active magnetic regenerative refrigeration (AMRR) cycles. Initially, this effect was widely used for cryogenic applications to achieve very low temperatures. However, this technology must be improved to replace vapor-compression devices operating around room temperature. Therefore, over the last 30 years, a lot of studies have been done to obtain more efficient devices. Thus, the modeling is a crucial step to perform a preliminary study and optimization. In this paper, after a large introduction on MCE research, a state-of-the-art of multi-physics modeling on the AMRR cycle modeling is made. To end this paper, a suggestion of innovative and advanced modeling solutions to study magnetocaloric regenerator is described.

Synthesis of polyethylene/nickel–carbon stimuli-responsive material under magnetic field at room temperature: Effect of the filler on the properties

2018 ◽  
Vol 99 ◽  
pp. 378-383 ◽  
Author(s):  
Muhammad Nisar ◽  
Pascal S. Thue ◽  
Cesar A. Heck ◽  
J.L. Salazar Cuaila ◽  
J. Geshev ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Temperature Effect ◽  
Room Temperature ◽  
Stimuli Responsive

The Study of p-n and Schottky Junction for Magnetodiode

2011 ◽  
Vol 378-379 ◽  
pp. 663-667 ◽  
Author(s):  
Toempong Phetchakul ◽  
Wittaya Luanatikomkul ◽  
Chana Leepattarapongpan ◽  
E. Chaowicharat ◽  
Putapon Pengpad ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Electrical Properties ◽  
Simulation Model ◽  
Hall Effect ◽  
Schottky Junction ◽  
Field Sensitivity ◽  
Field Response ◽  
Type Semiconductor ◽  
Simulation Results ◽  
P Type

This paper presents the simulation model of Dual Magnetodiode and Dual Schottky Magnetodiode using Sentaurus TCAD to simulate the virtual structure of magneto device and apply Hall Effect to measure magnetic field response of the device. Firstly, we use the program to simulate the magnetodiode with p-type semiconductor and aluminum anode and measure electrical properties and magnetic field sensitivity. Simulation results show that sensitivity of Dual Schottky magnetodiode is higher than that of Dual magnetodiode.

Mechanically Driven Dissolution of Sn in Near-Equiatomic Bcc FeCo

2012 ◽  
Vol 194 ◽  
pp. 187-193 ◽  
Author(s):  
J.M. Loureiro ◽  
Benilde F.O. Costa ◽  
Gerard Le Caër ◽  
Bernard Malaman
Keyword(s):  
Magnetic Field ◽  
Solid Solutions ◽  
Room Temperature ◽  
Hyperfine Magnetic Field ◽  
Ternary Alloys ◽  
119Sn Mössbauer Spectroscopy ◽  
X Ray Diffraction ◽  
Mechanically Alloyed ◽  
Powder Mixtures ◽  
X Ray

Ternary alloys, (Fe50−x/2Co50−x/2)Snx(x ≤ 33 at.%), are prepared by mechanical alloying from powder mixtures of the three elements. As-milled alloys are studied by X-ray diffraction and 57Fe and 119Sn Mössbauer spectroscopy. The solubility of Sn in near-equiatomic bcc FeCo is increased from ~0.5 at. % at equilibrium to ~20 at.% in the used milling conditions. The average 119Sn hyperfine magnetic field at room temperature is larger, for any x, than the corresponding fields in mechanically alloyed Fe-Sn solid solutions.

Sign in / Sign up

Export Citation Format

Share Document