Experimental and Analytical Study of the Effects of Free-Stream Turbulence on Turbulent Boundary Layers with Heat Transfer.

1982 ◽  
Author(s):  
M. F. Blair ◽  
D. E. Edwards
2003 ◽  
Vol 125 (2) ◽  
pp. 242-251 ◽  
Author(s):  
Michael J. Barrett ◽  
D. Keith Hollingsworth

A new heat transfer correlation for turbulent boundary layers subjected to free-stream turbulence was developed. The new correlation estimates dimensionless heat transfer coefficients without the use of conventional boundary-layer thickness measures and the associated Reynolds numbers. Using only free-stream parameters (mean velocity, turbulence intensity and length scale), the new correlation collected many authors’ elevated-turbulence, flat-plate Stanton number data to within ±11%. The level of scatter around the new correlation compared well to previous correlations that require additional flow information as input parameters. For a common subset of data, scatter using earlier correlation methods ranged from 5–10%; scatter around the new correlation varied from 6–9% over the same data subset. A length-scale dependence was identified in a Stanton number previously defined using a near-wall streamwise velocity fluctuation, St′. A new near-wall Stanton number was introduced; this parameter was regarded as a constant in a two-region boundary layer model on which the new correlation is based.


2003 ◽  
Vol 125 (2) ◽  
pp. 232-241 ◽  
Author(s):  
Michael J. Barrett ◽  
D. Keith Hollingsworth

Turbulent boundary layers were subjected to grid-generated free-stream turbulence to study the effects of length scale and intensity on heat transfer. Relative to conventional boundary layer thickness measures, test conditions included very small-scale free-stream turbulence. The boundary layers studied ranged from 400–2700 in momentum-thickness Reynolds number and from 450–1900 in enthalpy-thickness Reynolds number. Free-stream turbulence intensities varied from 0.1–8.0%. Ratios of free-stream length scale to boundary-layer momentum thickness ranged from 4.4–32.5. The turbulent-to-viscous length-scale ratios presented are the smallest found in the heat-transfer literature; the ratios spanned from 115–1020. The turbulent-to-thermal ratios (using enthalpy thickness as the thermal scale) are also the smallest reported; the ratios ranged from 3.2–12.3. Relative to clean-free-stream expectations based on the momentum- and enthalpy-thickness Reynolds numbers, the skin friction coefficient increased by up to 16%, and the Stanton number increased by up to 46%.


1989 ◽  
Vol 111 (1) ◽  
pp. 71-77 ◽  
Author(s):  
P. M. Ligrani ◽  
A. Ortiz ◽  
S. L. Joseph ◽  
D. L. Evans

Heat transfer effects of longitudinal vortices embedded within film-cooled turbulent boundary layers on a flat plate were examined for free-stream velocities of 10 m/s and 15 m/s. A single row of film-cooling holes was employed with blowing ratios ranging from 0.47 to 0.98. Moderate-strength vortices were used with circulating-to-free stream velocity ratios of −0.95 to −1.10 cm. Spatially resolved heat transfer measurements from a constant heat flux surface show that film coolant is greatly disturbed and that local Stanton numbers are altered significantly by embedded longitudinal vortices. Near the downwash side of the vortex, heat transfer is augmented, vortex effects dominate flow behavior, and the protection from film cooling is minimized. Near the upwash side of the vortex, coolant is pushed to the side of the vortex, locally increasing the protection provided by film cooling. In addition, local heat transfer distributions change significantly as the spanwise location of the vortex is changed relative to film-cooling hole locations.


1994 ◽  
Vol 116 (1) ◽  
pp. 23-28 ◽  
Author(s):  
K. Dullenkopf ◽  
R. E. Mayle

The effect of free-stream turbulence and moving wakes on augmenting heat transfer in accelerating laminar boundary layers is considered. First, the effect of free-stream turbulence is re-examined in terms of a Nusselt number and turbulence parameter, which correctly account for the free-stream acceleration and a correlation for both cylinders in crossflow and airfoils with regions of constant acceleration is obtained. This correlation is then used in a simple quasi-steady model to predict the effect of periodically passing wakes on airfoil laminar heat transfer. A comparison of the predictions with measurements shows good agreement.


2016 ◽  
Vol 802 ◽  
pp. 79-107 ◽  
Author(s):  
Eda Dogan ◽  
Ronald E. Hanson ◽  
Bharathram Ganapathisubramani

The scale interactions occurring within a turbulent boundary layer are investigated in the presence of free-stream turbulence. The free-stream turbulence is generated by an active grid. The free stream is monitored by a single-component hot-wire probe, while a second probe is roved across the height of the boundary layer at the same streamwise location. Large-scale structures occurring in the free stream are shown to penetrate the boundary layer and increase the streamwise velocity fluctuations throughout. It is speculated that, depending on the extent of the penetration, i.e. based on the level of free-stream turbulence, the near-wall turbulence production peaks at different wall-normal locations than the expected location of $y^{+}\approx 15$ for a canonical turbulent boundary layer. It is shown that the large scales dominating the log region have a modulating effect on the small scales in the near-wall region; this effect becomes more significant with increasing turbulence in the free stream, i.e. similarly increasing $Re_{\unicode[STIX]{x1D706}_{0}}$. This modulating interaction and its Reynolds-number trend have similarities with canonical turbulent boundary layers at high Reynolds numbers where the interaction between the large scales and the envelope of the small scales exhibits a pure amplitude modulation (Hutchins & Marusic, Phil. Trans. R. Soc. Lond. A, vol. 365 (1852), 2007, pp. 647–664; Mathis et al., J. Fluid Mech., vol. 628, 2009, pp. 311–337). This similarity has encouraging implications towards generalising scale interactions in turbulent boundary layers.


Author(s):  
Christoph Gramespacher ◽  
Matthias Stripf ◽  
Hans-Jörg Bauer

Abstract Heat transfer measurements in transitional flat plate boundary layers subjected to surface roughness, strong pressure gradients and free stream turbulence are presented. The surfaces considered, consist of a smooth reference and twenty six deterministic surface topographies that vary in roughness element aspect ratio, height and density. They are designed to cover the full range of roughness regimes from smooth over transitionally rough to fully rough. For each surface, two pressure distributions, characteristic for a suction and a pressure side turbine vane, are investigated. Inlet Reynolds numbers range from 3.0 · 105 to 6.0 · 105 and inlet turbulence intensity is varied between 1% to 8%. Furthermore, different turbulence Reynolds numbers, i.e. turbulence length scales, are realized while the incident turbulence intensity is kept constant. Additionally, the turbulence intensity and Reynolds stress distributions in the free-stream along the flat plate are measured using x-wire probes. Results show a strong influence of roughness and turbulence intensity on the onset of transition. The new data set is used to develop an improved correlation considering the roughness height, density and shape as well as the turbulence intensity and turbulent length scales.


Sign in / Sign up

Export Citation Format

Share Document