A Microbial Approach to Cleaning Used Oil-Based Drilling Muds

Author(s):  
N.P. Thurman ◽  
M.T. Heydeman
Keyword(s):  
Used Oil ◽  
Nafta-Gaz ◽  
2021 ◽  
Vol 77 (3) ◽  
pp. 175-186
Author(s):  
Sławomir Błaż ◽  

Invert muds are the most commonly used oil-based drilling muds. The oil to water phase ratio in invert drilling muds ranges from 65/35 up to 90/10, with the most common ones ranging from 70/30 to 80/20. At these oil to water phase ratios, the drilling mud is characterized with high stability and appropriate rheological and structural parameters allowing to adjust drilling mud density in a wide range. One of the disadvantages of invert muds is their cost (due to oil content) and environmental problems associated with waste and management of oily drill cuttings. Taking into account the properties of oil-based muds, the article presents laboratory tests aimed at developing the composition of an invert mud with a limited oil phase content and high internal phase ratio (HIPR). Drilling muds with an o/w ratio less or equal to 50/50 vary from conventional inversion muds in terms of their composition and properties. Due to the higher concentration of the dispersed inner phase, muds have reduced stability and high rheological and structural parameters. Maintaining the appropriate rheological and structural parameters of the drilling mud and its high stability is possible only through the use of appropriate chemicals adapted to the emulsion system with a specific oil to water phase ratio. In the drilling muds of this type it is also possible, due to the higher concentration of the internal phase, to partially adjust the density of the mud with the water phase, such as salt solutions, thus limiting the solids content (weighting agents) in the mud. The developed mud system should be more economical, have a reduced toxicity, while maintaining the operational advantages of invert mud. These types of muds can be used during the drilling of reactive shale formations, salt layers, gypsum and anhydrite layers, as well as for drilling productive horizons and for reconstruction works carried out in oil and gas wells.


2021 ◽  
Vol 10 (2) ◽  
pp. 390-395
Author(s):  
Nanthini Sridewi ◽  
Siti Nurbariah ◽  
Syahida Ahmad

Aim: Used oil-based drilling muds (OBDMs) are toxic to marine organisms due to the fluid’s complex chemical nature. The illegal dumping of used OBDMs is still rampant in many parts of the world despite of the stringent laws and regulations pertaining to its disposal. To date, study of the assessment of heavy metal content in used OBDMs from the Malaysian oil and gas industry has been limited. Furthermore, the study of the toxic effect of OBDMs using a zebrafish embryo model has never been reported before. Therefore, in this research, the used oil-based drilling muds (OBDMs) were analyzed for their heavy metal content and toxicity against Zebrafish embryos. Methods: Used OBDMs were collected from an Anchor Handling Tug Supply (AHTS) vessel mud tank from Kemaman, Terengganu. The heavy metal content in the mud was analyzed using ICP-AES. Zebrafish embryos were exposed to OBDMs of varying concentrations (i.e., 0.25 mg/ml, 0.125 mg/ml, 0.06 mg/ml, 0.03 mg/ml, 0.015 mg/ml, 0.0076 mg/ml, 0.0034 mg/ml and 0.0019 mg/ml). The toxicity and teratogenicity of the mud on zebrafish embryos were assessed every 24 hours, for 96 hours, using endpoints like embryo mortality, heart rate and hatching rate. Results: The heavy metal content of used OBDMs had the highest concentration of barium (Ba) 2360 ppm, followed by lead (Pb) 120 ppm, zinc (Zn) 104 ppm, arsenic (As) 9 ppm, and chromium (Cr) 16 ppm, with cadmium (Cd) concentration of less than 1 ppm being the lowest. The Ba (2360 mg/L) concentration in the OBDM sample exceeded the concentration of Ba in normal marine sediment reported to be around 2000 mg/L. The 96 h LC50 of the OBDM in zebrafish embryos was reported to be 0.005 mg/mL (5 ppm). Zebrafish embryos that were exposed to high concentrations of OBDMs exhibited a lower hatching rate and reduced heart rate than the control group. Conclusion: The findings of this study are indicative of the highly toxic nature of used OBDMs and its dosage-dependent teratogenicity effects on zebrafish embryo. Knowledge of the potential environmental impacts of OBDMs released into the marine environment can be the basis for prudent decision-making that will help minimize environmental damage.


Author(s):  
A.A. Klimova ◽  
◽  
A.S. Mishunina ◽  
S.V. Azarova ◽  
D.E. Fominykh ◽  
...  
Keyword(s):  

Tribotest ◽  
2000 ◽  
Vol 7 (1) ◽  
pp. 61-74 ◽  
Author(s):  
Czeslaw Kajdas
Keyword(s):  

2012 ◽  
pp. 23-32
Author(s):  
Norzita Ngadi ◽  
Hajar Alias ◽  
Siti Aktar Ishak

In this study, production of biodiesel from new and used palm and soybean oils was carried out using a transesterification method. The effect of catalyst amount used towards the percentage yield, soap content and heat of combustion of the biodiesel produced was investigated. The soap content and heat combustion of the biodiesel were determined using titration (AOCS Cc-95) and heat calorimeter bomb (ASTM D240-09), respectively. The results showed that catalyst concentration of 0.5 w/w% gave the best result in terms of yield of biodiesel produced from both palm and soybean oils. However, the quality of biodiesel (i.e. soap content and heat of combustion) produced from palm and soybean oils behaved differently towards catalyst concentration. Overall, both oils (palm and soybean), either new or used oil apparently showed no significant difference in term of yield or qualities of biodiesel produced. This indicates that the used oil has high potential as an economical and practical future source of biodiesel.


2007 ◽  
Author(s):  
Takeyoshi Taguchi ◽  
Mitsuru Yoshii ◽  
Kohzo Shinoda

Sign in / Sign up

Export Citation Format

Share Document