An Experimental Study on Interactions between Imbibed Fracturing Fluid and Organic-Rich Tight Carbonate Source Rocks

Author(s):  
Feng Liang ◽  
Bitao Lai ◽  
Jilin Zhang ◽  
Hui-Hai Liu ◽  
Weichang Li
2018 ◽  
Author(s):  
Stefan Steiner ◽  
Laurent Mosse ◽  
Ishan Raina

SPE Journal ◽  
2018 ◽  
Vol 23 (06) ◽  
pp. 2133-2146 ◽  
Author(s):  
Feng Liang ◽  
Bitao Lai ◽  
Jilin Zhang ◽  
Hui-Hai Liu ◽  
Weichang Li

Summary Carbonate reservoirs dominate oil (70%) and gas (90%) reserves in the Middle East, and imbibition is the main mechanism for fracturing-fluid uptake during the hydraulic-fracturing stimulation process. Because of the highly heterogeneous nature of tight carbonate source rocks, it is crucial to understand the effects of imbibed fluid on the mechanical, morphological, and flow properties of carbonate rocks. Although the influence of imbibed fluids on the wettability of carbonate reservoir has been studied extensively, research regarding the effects of imbibed fluids on the texture and mineralogy of carbonate rocks is still very limited. This paper aims to provide a conceptual approach and work flow to characterize and quantify microstructure and mineralogy changes in carbonate rocks caused by imbibed fluids. A thin section of a low-permeability organic-rich carbonate-rock sample [7×7×0.3 mm (length×width×thickness)] was used in the study. The sample was submerged into 2%-KCl (pH = 7.1) fluid from one end to simulate the spontaneous-imbibition process. A scanning electron microscope (SEM) was used to capture the sample's morphological changes before and after spontaneous imbibition. Energy-dispersive-spectroscopy (EDS) maps were measured before and after fluid treatment to investigate changes in various elemental distribution. In addition, inductively coupled plasma (ICP) equipped with an optical-emission-spectrometer (OES) detector was used to quantify dissolved-ion concentration in the treatment fluid. Permeability and porosity were measured using core plugs with dimensions of 1.0×1.5 in. (diameter×length) before and after fluid treatment. During the imbibition process, approximately one-half of the sample was submerged in the treatment fluid. The SEM images for the thin-section sample showed three zones with distinct fluid-uptake characteristics. In Zone I, which was fully submerged in the testing fluid, a significant amount of mineral dissolution was observed. In Zone III, which was above the testing-fluid level, considerable mineral precipitation was detected. While in the transition zone just above the water/air interface (Zone II between the previous two zones), only a minor level of mineral dissolution was observed. Elemental-distribution changes resulting from the fluid treatment were identified by EDS analysis in all three zones. Gypsum and calcite crystals dissolved into imbibed fluids upon reaction. Gypsum was found reprecipitated on the rock surface in the zones above fluid level. The observed gypsum formation likely resulted from the dissolution of the gypsum from the rock matrix, then reprecipitation later from the imbibition experiment caused by water evaporation. Absolute-permeability and porosity measurements for core-plug samples have shown that both were increased after the imbibition process.


2006 ◽  
Vol 51 (23) ◽  
pp. 2885-2891 ◽  
Author(s):  
Xinhua Geng ◽  
Ansong Geng ◽  
Yongqiang Xiong ◽  
Jinzhong Liu ◽  
Haizu Zhang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document