Integrating Geology, Hydraulic Fracturing Modeling, and Reservoir Simulation in the Evaluation of Complex Fluvial Tight Gas Reservoirs

2012 ◽  
Author(s):  
Kelly Ramirez ◽  
Patricia Helena Cuba ◽  
Jennifer Lynne Miskimins ◽  
Donna Schmidt Anderson ◽  
Mary Carr
2013 ◽  
Vol 53 (1) ◽  
pp. 363
Author(s):  
Yangfan Lu ◽  
Hassan Bahrami ◽  
Mofazzal Hossain ◽  
Ahmad Jamili ◽  
Arshad Ahmed ◽  
...  

Tight-gas reservoirs have low permeability and significant damage. When drilling the tight formations, wellbore liquid invades the formation and increases water saturation of the near wellbore area and significantly deceases permeability of this area. Because of the invasion, the permeability of the invasion zone near the wellbore in tight-gas formations significantly decreases. This damage is mainly controlled by wettability and capillary pressure (Pc). One of the methods to improve productivity of tight-gas reservoirs is to reduce IFT between formation gas and invaded water to remove phase trapping. The invasion of wellbore liquid into tight formations can damage permeability controlled by Pc and relative permeability curves. In the case of drilling by using a water-based mud, tight formations are sensitive to the invasion damage due to the high-critical water saturation and capillary pressures. Reducing the Pc is an effective way to increase the well productivity. Using the IFT reducers, Pc effect is reduced and trapped phase can be recovered; therefore, productivity of the TGS reservoirs can be increased significantly. This study focuses on reducing phase-trapping damage in tight reservoirs by using reservoir simulation to examine the methods, such use of IFT reducers in water-based-drilled tight formations that can reduce Pc effect. The Pc and relative permeability curves are corrected based on the reduced IFT; they are then input to the reservoir simulation model to quantitatively understand how IFT reducers can help improve productivity of tight reservoirs.


2012 ◽  
Author(s):  
Zillur Rahim ◽  
Hamoud Ali Al-anazi ◽  
Adnan Kanaan ◽  
Ali Hussain Habbtar ◽  
Ahmed M. Omair ◽  
...  

Geophysics ◽  
2013 ◽  
Vol 78 (6) ◽  
pp. KS97-KS108 ◽  
Author(s):  
Indrajit Das ◽  
Mark D. Zoback

Long-period long-duration (LPLD) seismic events are relatively low-amplitude signals that have been observed during hydraulic fracturing in several shale-gas and tight-gas reservoirs. These events are similar in appearance to tectonic tremor sequences observed in subduction zones and transform fault boundaries. LPLD events are predominantly composed of S-waves, but weaker P-waves have also been identified. In some cases, microearthquakes are observed during the events. Based on the similarity with tectonic tremors and our observations of several impulsive S-wave arrivals within the LPLD events, we interpret the LPLD events as resulting from the superposition of slow shear-slip events on relatively large faults. Most large LPLD waveforms appear to start as a relatively slower, low-amplitude precursor, lacking clear impulsive arrivals. We estimate the energy carried by the larger LPLD events to be [Formula: see text] times greater than a [Formula: see text] microseismic event that is typical of the events that occur during hydraulic stimulation. Over the course of the entire stimulation activity of five wells in the Barnett formation (each hydraulically fractured ten times), the LPLD events were found to cumulatively release over an order of magnitude higher energy than microearthquakes. The large size of these LPLD events, compared to microearthquakes, suggests that they represent slip on relatively large faults during stimulation of these extremely low-permeability reservoirs. Moreover, they imply that the accompanying slow slip on faults, probably mostly undetected, is a significant deformation process during multistage hydraulic fracturing.


2009 ◽  
Author(s):  
James Ohioma I. Arukhe ◽  
Roberto Aguilera ◽  
Thomas Grant Harding

2009 ◽  
Author(s):  
Yafes Abacioglu ◽  
Herbert M. Sebastian ◽  
Jubril Babajide Oluwa

2021 ◽  
Vol 11 (4) ◽  
pp. 1761-1780
Author(s):  
Nianyin Li ◽  
Fei Chen ◽  
Jiajie Yu ◽  
Peihong Han ◽  
Jia Kang

AbstractHydraulic fracturing is an important technical means to improve the development effect of low-permeability oil and gas reservoirs. However, for low pressure, low-permeability, tight, and high-clay sandstone gas reservoirs, conventional propped fracturing can cause serious damage to the reservoir and restrict the fracturing effect. The pre-acid fracturing technology combines acid treatment technology with sand-fracturing technology. A pre-acid system that meets special performance requirements is injected before fracturing. The pre-acid reduces the formation fracture pressure and removes clay damage. During acid flowback, the fracturing fluid is promoted to break the gel, dissolve the fracturing fluid residue and polymer filter cake, clean the supporting cracks, and effectively improve the fracturing effect. This study analyzes the process principle and technical advantages of the pre-acid fracturing technology based on the laboratory evaluation of the fracturing damage mechanism of low-permeability tight gas reservoirs. To meet the performance requirements of low-permeability tight gas reservoirs and pre-acid fracturing technology, a set of polyhydrogen acid system with long-lasting slow reactivity, low damage, and low corrosion was developed and used as the pre-fracturing acid. The acid system is mainly composed of the main agent SA601 and the auxiliary agent SA701. Then, on the basis of laboratory experiments, this acid system is used as the fracturing pre-acid to evaluate the fracturing improvement effect. The results show that the fracturing fluid system can better dissolve the fracturing fluid filter cake and remove the fracturing fluid damage.


2021 ◽  
Author(s):  
Abhijith Suboyin ◽  
Md Motiur Rahman ◽  
Mohamed Haroun

Abstract Tight gas reservoirs in the Middle East are renowned for their extremely low porosity and low permeability along with their high heterogeneity. Over the past few decades, hydraulic fracturing has gained significant attention, particularly to stimulate such formations which were previously considered uneconomical and inefficient. Even though over a million hydraulic fracturing operations were conducted across the globe, they are still associated with a considerable amount of risk. Studies have shown that an effective, efficient and economical approach coupled with tailored water management strategies are critical for their successful development, especially in arid regions such as the Middle East. In this research, a realistic field model was constructed and advanced to analyze hydraulic fracture propagation in the presence of natural fractures for a candidate Middle Eastern tight gas reservoir. This flexible simulation model allowed to investigate, identify and characterize the key fracture design parameters that influenced fracture geometry for the candidate field. This further allowed to categorize and propose a unique tailored workflow to highlight the governing parameters for efficient water management strategies for arid regions such as the Middle East. In addition, the results have been extended to current field practices and cases. The constructed model can greatly assist in streamlining hydraulic fracturing operations and water management strategies in regions such as the Middle East, where resources such as water and proppants can be considered as constraints. In addition, the investigation further highlights the strong need and potential opportunities for the key players in the region to leverage their technology for an efficient water management value chain. The variables and the workflow presented in this study further demonstrates how there is no bespoke solution to a ‘best approach’ in such regions. However, a workflow identifying the key dominant categories, such as a tailored one proposed in this study, may assist in the creation of more efficient and practical strategies while contributing to the overall process chain.


Sign in / Sign up

Export Citation Format

Share Document