Irreducible Water Saturation Has Been Determined As the Key Factor Governing Hydrocarbon Production From Low Permeability Carbonate at the Wattenberg Field in the Denver Julesburg Basin

2008 ◽  
Author(s):  
Yuanhai Yang ◽  
Thomas J. Birmingham
2021 ◽  
Author(s):  
Euripides Papamichos ◽  
Lars Erik Walle ◽  
Andreas Nicolas Berntsen ◽  
Dawid Szewcyk

Abstract Sand onset and sand rate predictions are important in hydrocarbon production to optimize production, increase recovery, and reduce costs and the environmental footprint. Recent laboratory results on Castlegate sandstone from sand production tests in a True Triaxial test system have revealed that stress anisotropy plays an important role not only on sand onset but also in sand rate. The results confirmed our hypothesis that stress anisotropy means earlier sand produced but less sand. The laboratory results also revealed the effect of fluid saturation, i.e., oil, brine or irreducible water saturation on sand onset and sand rate. They allow the calibration of SandPredictor, a field sand prediction model, for stress anisotropy and production before and after water breakthrough. A field case analysis demonstrated the effects and showed the importance of in situ stress anisotropy and watercut on sand mass and rate.


Geofluids ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-14 ◽  
Author(s):  
Xiaoyu Gu ◽  
Chunsheng Pu ◽  
Hai Huang ◽  
Nasir Khan ◽  
Jing Liu ◽  
...  

The microflow equipment monitored with micro X-ray computerized tomography (CT) is employed to investigate the microoccurrence of the irreducible water in a low-permeability sandstone core. By means of image segmentation and the three-dimensional (3D) image reconstruction technique, the visual microdistribution characteristics of irreducible water in two-dimensional (2D) slices and the 3D pore-throat system are quantitatively evaluated. Some interesting findings are list as below. Firstly, due to the variant micro geometric structures of the pore-throat systems, specific core slices showed significantly different irreducible water saturation even though these slices had same areal porosity. Secondly, due to the influence of capillary trapping and the existence of oil-wetting clay (main chlorite), the irreducible water saturation in the throat system (64%) is much larger than that in the pore system (36%). Furthermore, the wetting phase (irreducible water) did not spread all over the surface of the pore-throat network which caused a much more complicated oil-water two-phase interface. Thirdly, in micro scale, the main irreducible water occurrence mode in the pore system is much different from that in the throat system. In the pore system, the irreducible water principally existed in the corner of the pores which are linked through a water film. While in the throat system, the irreducible water occurrence is dominated by the water film. However, 25.5% of the throats are blocked by the irreducible water which cut off the crude oil drainage channels.


2011 ◽  
Vol 346 ◽  
pp. 852-857
Author(s):  
Yu Zhou ◽  
He Kun Guo ◽  
Guo Qi Wei

Irreducible water saturation is one of the fundamental parameters in characterizing reservoir formations, and determined as the key factor in reserve calculation and fluid type identification. Measurement on whole core must be taken to analyze irreducible water saturation of volcanic rocks as a result of lithological diversity, porous structure complexity and strong heterogeneity. A new testing method for whole core is proposed by combining Nuclear Magnetic Resonance and centrifugal tests. This new method measures irreducible water saturation using T2 spectrum of whole core demarcated by T2 cutoff measured on 25mm or 38mm diameter core samples which drilled from the whole core. The new method solved the size and shape restricts, long test cycles and viscous fingering defects of conventional methods. According to the comparison with conventional method, the results of the new method coincide well on homogeneous rocks, and are more accuracy with fractured samples.


1985 ◽  
Vol 25 (06) ◽  
pp. 945-953 ◽  
Author(s):  
Mark A. Miller ◽  
H.J. Ramey

Abstract Over the past 20 years, a number of studies have reported temperature effects on two-phase relative permeabilities in porous media. Some of the reported results, however, have been contradictory. Also, observed effects have not been explained in terms of fundamental properties known to govern two-phase flow. The purpose of this study was to attempt to isolate the fundamental properties affecting two-phase relative permeabilities at elevated temperatures. Laboratory dynamic-displacement relative permeability measurements were made on unconsolidated and consolidated sand cores with water and a refined white mineral oil. Experiments were run on 2-in. [5.1-cm] -diameter, 20-in. [52.-cm] -long cores from room temperature to 300F [149C]. Unlike previous researchers, we observed essentially no changes with temperature in either residual saturations or relative permeability relationships. We concluded that previous results may have been affected by viscous previous results may have been affected by viscous instabilities, capillary end effects, and/or difficulties in maintaining material balances. Introduction Interest in measuring relative permeabilities at elevated temperatures began in the 1960's with petroleum industry interest in thermal oil recovery. Early thermal oil recovery field operations (well heaters, steam injection, in-situ combustion) indicated oil flow rate increases far in excess of what was predicted by viscosity reductions resulting from heating. This suggested that temperature affects relative permeabilities. One of the early studies of temperature effects on relative permeabilities was presented by Edmondson, who performed dynamic displacement measurements with crude performed dynamic displacement measurements with crude and white oils and distilled water in Berea sandstone cores. Edmondson reported that residual oil saturations (ROS's) (at the end of 10 PV's of water injected) decreased with increasing temperature. Relative permeability ratios decreased with temperature at high water saturations but increased with temperature at low water saturations. A series of elevated-temperature, dynamic-displacement relative permeability measurements on clean quartz and "natural" unconsolidated sands were reported by Poston et al. Like Edmondson, Poston et al. reported a decrease in the "practical" ROS (at less than 1 % oil cut) as temperature increased. Poston et al. also reported an increase in irreducible water saturation. Although irreducible water saturations decreased with decreasing temperature, they did not revert to the original room temperature values. It was assumed that the cores became increasingly water-wet with an increase in both temperature and time; measured changes of the IFT and the contact angle with temperature increase, however, were not sufficient to explain observed effects. Davidson measured dynamic-displacement relative permeability ratios on a coarse sand and gravel core with permeability ratios on a coarse sand and gravel core with white oil displaced by distilled water, nitrogen, and superheated steam at temperatures up to 540F [282C]. Starting from irreducible water saturation, relative permeability ratio curves were similar to Edmondson's. permeability ratio curves were similar to Edmondson's. Starting from 100% oil saturation, however, the curves changed significantly only at low water saturations. A troublesome aspect of Davidson's work was that he used a hydrocarbon solvent to clean the core between experiments. No mention was made of any consideration of wettability changes, which could explain large increases in irreducible water saturations observed in some runs. Sinnokrot et al. followed Poston et al.'s suggestion of increasing water-wetness and performed water/oil capillary pressure measurements on consolidated sandstone and limestone cores from room temperature up to 325F [163C]. Sinnokrot et al confirmed that, for sandstones, irreducible water saturation appeared to increase with temperature. Capillary pressures increased with temperature, and the hysteresis between drainage and imbibition curves reduced to essentially zero at 300F [149C]. With limestone cores, however, irreducible water saturations remained constant with increase in temperature, as did capillary pressure curves. Weinbrandt et al. performed dynamic displacement experiments on small (0.24 to 0.49 cu in. [4 to 8 cm3] PV) consolidated Boise sandstone cores to 175F [75C] PV) consolidated Boise sandstone cores to 175F [75C] with distilled water and white oil. Oil relative permeabilities shifted toward high water saturations with permeabilities shifted toward high water saturations with increasing temperature, while water relative permeabilities exhibited little change. Weinbrandt et al. confirmed the findings of previous studies that irreducible water saturation increases and ROS decreases with increasing temperature. SPEJ P. 945


2005 ◽  
Vol 22 (4) ◽  
pp. 611-616 ◽  
Author(s):  
Sung-Sik Lee ◽  
Kyung-Su Hwang ◽  
Bong-Kuk Lee ◽  
Dong-Pyo Hong ◽  
Ryoich Kuboi

2021 ◽  
Author(s):  
Hao Xu ◽  
Xu Lian ◽  
Ingrid Slette ◽  
Hui Yang ◽  
Yuan Zhang ◽  
...  

Abstract The timing and length of the dry season is a key factor governing ecosystem productivity and the carbon cycle of the tropics. Mounting evidence has suggested a lengthening of the dry season with ongoing climate change. However, this conclusion is largely based on changes in precipitation (P) compared to its long-term average (P ̅) and lacks consideration of the simultaneous changes in ecosystem water demand (measured by potential evapotranspiration, Ep, or actual evapotranspiration, E). Using several long-term (1979-2018) observational datasets, we compared changes in tropical dry season length (DSL) and timing (dry season arrival, DSA, and dry season end, DSE) among three common metrics used to define the dry season: P < P ̅, P < Ep, and P < E. We found that all three definitions show that dry seasons have lengthened in much of the tropics since 1979. Among the three definitions, P < E estimates the largest fraction (49.0%) of tropical land area likely experiencing longer dry seasons, followed by P < Ep (41.4%) and P < P ̅ (34.4%). The largest differences in multi-year mean DSL (> 120 days) among the three definitions occurred in the most arid and the most humid regions of the tropics. All definitions and datasets consistently showed longer dry seasons in southern Amazon (due to delayed DSE) and central Africa (due to both earlier DSA and delayed DSE). However, definitions that account for changing water demand estimated longer DSL extension over those two regions. These results indicate that warming-enhanced evapotranspiration exacerbates dry season lengthening and ecosystem water deficit. Thus, it is necessity to account for the evolving water demand of tropical ecosystems when characterizing changes in seasonal dry periods and ecosystem water deficits in an increasingly warmer and drier climate.


2017 ◽  
Vol 5 (1) ◽  
pp. 19
Author(s):  
Ubong Essien ◽  
Akaninyene Akankpo ◽  
Okechukwu Agbasi

Petrophysical analysis was performed in two wells in the Niger Delta Region, Nigeria. This study is aimed at making available petrophysical data, basically water saturation calculation using cementation values of 2.0 for the reservoir formations of two wells in the Niger delta basin. A suite of geophysical open hole logs namely Gamma ray; Resistivity, Sonic, Caliper and Density were used to determine petrophysical parameters. The parameters determined are; volume of shale, porosity, water saturation, irreducible water saturation and bulk volume of water. The thickness of the reservoir varies between 127ft and 1620ft. Average porosity values vary between 0.061 and 0.600; generally decreasing with depth. The mean average computed values for the Petrophysical parameters for the reservoirs are: Bulk Volume of Water, 0.070 to 0.175; Apparent Water Resistivity, 0.239 to 7.969; Water Saturation, 0.229 to 0.749; Irreducible Water Saturation, 0.229 to 0.882 and Volume of Shale, 0.045 to 0.355. The findings will also enhance the proper characterization of the reservoir sands.


Sign in / Sign up

Export Citation Format

Share Document