Increased Magmatic Water Content--The Key to Oligo-Miocene Porphyry Cu-Mo   Au Formation in the Eastern Gangdese Belt, Tibet

2014 ◽  
Vol 109 (5) ◽  
pp. 1315-1339 ◽  
Author(s):  
R. Wang ◽  
J. P. Richards ◽  
Z. Hou ◽  
Z. Yang ◽  
S. A. DuFrane
Keyword(s):  
Water Content ◽  
Magmatic Water ◽  
Porphyry Cu ◽  
Magmatic Water Content

scholarly journals Investigating H2O contents in clinopyroxene from explosive versus effusive eruption products from Merapi volcano, Indonesia

2020 ◽  
Author(s):  
Dimitrios Dimitriou ◽  
Valentin Troll ◽  
Franz Weis ◽  
Nadhirah Seraphine ◽  
Frances Deegan ◽  
...  
Keyword(s):  
Water Content ◽  
Extreme Values ◽  
Ftir Analysis ◽  
Dominant Group ◽  
Pyroclastic Deposits ◽  
Merapi Volcano ◽  
Magmatic Water ◽  
Analytical Approaches ◽  
Water Contents ◽  
Magmatic Water Content

<p>The 2010 eruption of Merapi produced pyroclastic deposits and lava flows that are compositionally very similar, raising the question as to the underlying reason of the differences in eruptive styles between the various phases of the 2010 eruptive events. To test whether primary magmatic volatile content is the reason for the different eruption styles, we analyzed magmatic water contents in nominally anhydrous clinopyroxene crystals contained in lava and ash from the 2010 eruptive events. We utilized two analytical approaches: (i) Fourier-transform infrared spectroscopy (FTIR) analysis of fresh clinopyroxene from the ash and lava samples and (ii) FTIR analysis of clinopyroxene both prior to and after experimental re-hydration. By employing calculated partition coefficients, we determined the magmatic water content of the magma from which the various crystals grew. The magmatic water content determined from the unmodified clinopyroxenes from lava samples yield a range of 0.35 wt.% to 2.02 wt.% H<sub>2</sub>O, whereas magmatic water contents determined from untreated clinopyroxene contained in the ash samples range between 0.04 and 3.25 wt.%, with two outliers at 4.62 and 5.19 and wt.%, respectively. In contrast, for the rehydrated crystals the range for lava derived clinopyroxene crystals is between 1.94 and 2.19 wt.% and for ash between 1.74 and 2.66 wt.%, with two crystals at extreme values of 0.85 and 3.20 wt.%. We interpret these results to indicate that crystals from different populations are present in the 2010 eruptive products, with the dominant group reflecting relatively low magmatic H<sub>2</sub>O contents (around 2 wt.%) due to storage in shallow magma reservoirs and pockets at high levels within the Merapi plumbing systems (e.g. top 3 km). The overall higher H<sub>2</sub>O range and the occasionally more extreme values recorded in clinopyroxenes from ash deposits may then represent the presence of a crystal population that last equilibrated at deeper levels and at higher water contents, i.e. these crystals derive from the replenishing magma that activated the shallow portion of the plumbing system during the 2010 events. While this is work in progress, our results so far seem to suggest that the pyroclastic deposits of the 2010 Merapi eruption may contain a higher fraction of clinopyroxene derived from ‘deeper magma’ with higher H<sub>2</sub>O contents then what we have detected in associated lavas.</p>

scholarly journals Importance of Magmatic Water Content and Oxidation State for Porphyry-Style Au Mineralization: An Example from the Giant Beiya Au Deposit, SW China

Minerals ◽  
2018 ◽  
Vol 8 (10) ◽  
pp. 441 ◽  
Author(s):  
Xinshang Bao ◽  
Liqiang Yang ◽  
Wenyan He ◽  
Xue Gao
Keyword(s):  
Water Content ◽  
Oxidation State ◽  
Water Saturation ◽  
High Water ◽  
Parent Magma ◽  
High Water Content ◽  
Average Temperature ◽  
Metallogenic Belt ◽  
Magmatic Temperature ◽  
Magmatic Water Content

The Beiya Au deposit is the largest Cenozoic Au deposit in the Jinshajiang-Ailaoshan porphyry metallogenic belt. Numerous studies document that high water content and fO2 are vital factors for the generation of Au mineralization. In this belt, only the Wandongshan and Hongnitang districts are considered to be of economic importance, while the other districts, such as Bailiancun, are barren. So in order to reveal the importance of water content and oxidation state for Beiya porphyry-style Au mineralization, the amphiboles and zircons compositions are used to evaluate the physicochemical conditions (e.g., pressure, temperature, fO2, and water content) of the Wandongshan ore-fertile porphyries and Bailiancun ore-barren porphyries observed in the Beiya Au deposit. The results show that the water content of the Wandongshan parent magma (≤4.11 ± 0.4 wt %) are slightly higher than those of the parent magma at Bailiancun (≤3.91 ± 0.4 wt %), while the emplacement pressure of the Wandongshan parent magma (31.5–68.6 MPa) is much lower than that of the parent magma at Bailiancun (142.3–192.8 MPa), indicating that the Wandongshan magma reached water saturation earlier. In addition, the Wandongshan porphyries crystallized from more oxidized magma (average of ΔFMQ = +3.5) with an average temperature of 778 °C compared to the Bailiancun porphyries (average of ΔFMQ = +1.5) with a mean magmatic temperature of 770 °C. The Ce4+/Ce3+ ratio of zircon in the Wandongshan ore-related intrusions (average Ce4+/Ce3+ of 62.00) is much higher than that of the Bailiancun barren porphyries (average Ce4+/Ce3+of 23.15), which further confirmed Wandongshan ore-related magma is more oxidized than the Bailiancun barren magma. Therefore, melts that are more enriched in water and with a high oxidation state will be more fertile to form an economic porphyry-style Au system.

Characterization of frozen hydrated biological specimens by low-loss EELS

1992 ◽  
Vol 50 (2) ◽  
pp. 1572-1573
Author(s):  
Songquan Sun ◽  
Richard D. Leapman
Keyword(s):  
Water Content ◽  
Direct Method ◽  
Internal Standard ◽  
Dry Weight ◽  
Dark Field ◽  
Protein Solutions ◽  
Subcellular Compartment ◽  
Differential Shrinkage ◽  
Electron Energy Loss

Analyses of ultrathin cryosections are generally performed after freeze-drying because the presence of water renders the specimens highly susceptible to radiation damage. The water content of a subcellular compartment is an important quantity that must be known, for example, to convert the dry weight concentrations of ions to the physiologically more relevant molar concentrations. Water content can be determined indirectly from dark-field mass measurements provided that there is no differential shrinkage between compartments and that there exists a suitable internal standard. The potential advantage of a more direct method for measuring water has led us to explore the use of electron energy loss spectroscopy (EELS) for characterizing biological specimens in their frozen hydrated state.We have obtained preliminary EELS measurements from pure amorphous ice and from cryosectioned frozen protein solutions. The specimens were cryotransfered into a VG-HB501 field-emission STEM equipped with a 666 Gatan parallel-detection spectrometer and analyzed at approximately −160 C.

STEM measurement of subcellular water distributions

1993 ◽  
Vol 51 ◽  
pp. 568-569
Author(s):  
R.D. Leapman ◽  
S.Q. Sun ◽  
S-L. Shi ◽  
R.A. Buchanan ◽  
S.B. Andrews
Keyword(s):  
Water Content ◽  
Internal Standard ◽  
Dry Weight ◽  
Dry Mass ◽  
Scanning Transmission Electron Microscope ◽  
Dark Field ◽  
Bulk Water ◽  
Inelastic Electron ◽  
Scanning Transmission ◽  
Annular Dark Field

Recent advances in rapid-freezing and cryosectioning techniques coupled with use of the quantitative signals available in the scanning transmission electron microscope (STEM) can provide us with new methods for determining the water distributions of subcellular compartments. The water content is an important physiological quantity that reflects how fluid and electrolytes are regulated in the cell; it is also required to convert dry weight concentrations of ions obtained from x-ray microanalysis into the more relevant molar ionic concentrations. Here we compare the information about water concentrations from both elastic (annular dark-field) and inelastic (electron energy loss) scattering measurements.In order to utilize the elastic signal it is first necessary to increase contrast by removing the water from the cryosection. After dehydration the tissue can be digitally imaged under low-dose conditions, in the same way that STEM mass mapping of macromolecules is performed. The resulting pixel intensities are then converted into dry mass fractions by using an internal standard, e.g., the mean intensity of the whole image may be taken as representative of the bulk water content of the tissue.

Sign in / Sign up

Export Citation Format

Share Document