Magnetic field observations in the near-field the 28 June 1992 Mw 7.3 Landers, California, earthquake

1994 ◽  
Vol 84 (3) ◽  
pp. 792-798 ◽  
Author(s):  
M. J. S. Johnston ◽  
R. J. Mueller ◽  
Y. Sasai

Abstract Recent reports suggest that large magnetic field changes occur prior to, and during, large earthquakes. Two continuously operating proton magnetometers, LSBM and OCHM, at distances of 17.3 and 24.2 km, respectively, from the epicenter of the 28 June 1992 Mw 7.3 Landers earthquake, recorded data through the earthquake and its aftershocks. These two stations are part of a differentially connected array of proton magnetometers that has been operated along the San Andreas fault since 1976. The instruments have a sensitivity of 0.25 nT or better and transmit data every 10 min through the GOES satellite to the USGS headquarters in Menlo Park, California. Seismomagnetic offsets of −1.2 ± 0.6 and −0.7 ± 0.7 nT were observed at these sites. In comparison, offsets of −0.3 ± 0.2 and −1.3 ± 0.2 nT were observed during the 8 July 1986 ML 5.9 North Palm Springs earthquake, which occurred directly beneath the OCHM magnetometer site. The observations are generally consistent with seismomagnetic models of the earthquake, in which fault geometry and slip have the same from as that determined by either inversion of the seismic data or inversion of geodetically determined ground displacements produced by the earthquake. In these models, right-lateral rupture occurs on connected fault segments in a homogeneous medium with average magnetization of 2 A/m. The fault-slip distribution has roughly the same form as the observed surface rupture, and the total moment release is 1.1 × 1020 Nm. There is no indication of diffusion-like character to the magnetic field offsets that might indicate these effects result from fluid flow phenomena. It thus seems unlikely that these earthquake-generated offsets and those produced by the North Palm Springs earthquake were generated by electrokinetic effects. Also, there are no indications of enhanced low-frequency magnetic noise before the earthquake at frequencies below 0.001 Hz.

2021 ◽  
Vol 2021 ◽  
pp. 1-11
Author(s):  
Gao Xiang ◽  
Du Bo-cheng ◽  
Wang Qi-long

Tri-axis magnetometers are widely used to measure magnetic field in engineering of the magnetic localization technology. However, the magnetic field measurement precision is influenced by the nonorthogonal error of tri-axis magnetometers. A locating model of the alternating magnetic dipole in the near-field zone with single-component magnetometers was proposed in this paper. Using the vertical component of the low-frequency magnetic field acquired by at least six single-component magnetometers, the localization of an alternating magnetic dipole could be attributed to the solution for a class of nonlinear unconstrained optimization problem. In order to calculate the locating information of alternating magnetic dipole, a hybrid algorithm combining the Gauss–Newton algorithm and genetic algorithm was applied. The theoretical simulation and field experiment for the localization of alternating magnetic dipole source were carried out, respectively. The positioning result is stable and reliable, indicating that the locating model has better performance and could meet the requirements of actual positioning.


Jurnal Teknik ◽  
2018 ◽  
Vol 7 (1) ◽  
Author(s):  
Mauludi Manfaluthy

WHO (World Health Organization) concludes that not much effect is caused by electric field up to 20 kV / m in humans. WHO standard also mentions that humans will not be affected by the magnetic field under  100 micro tesla and that the electric field will affect the human body with a maximum standard of 5,000 volts per meter. In this study did not discuss about the effect of high voltage radiation SUTT (High Voltage Air Channel) with human health. The research will focus on energy utilization of SUTT radiation. The combination of electric field and magnetic field on SUTT (70-150KV) can generate electromagnetic (EM) and radiation waves, which are expected to be converted to turn on street lights around the location of high voltage areas or into other forms. The design of this prototype works like an antenna in general that captures electromagnetic signals and converts them into AC waves. With a capacitor that can store the potential energy of AC and Schottky diode waves created specifically for low frequency waves, make the current into one direction (DC). From the research results obtained the current generated from the radiation is very small even though the voltage is big enough.Keywords : Radiance Energy, Joule Thief, and  LED Module.


Sign in / Sign up

Export Citation Format

Share Document