An Application of Relative Moment Tensor Inversion to Aftershocks of the June 1998 Hengill Earthquake in Southwest Iceland

2008 ◽  
Vol 98 (2) ◽  
pp. 636-650 ◽  
Author(s):  
L. Hagos ◽  
H. Shomali ◽  
B. Lund ◽  
R. Bothvarsson ◽  
R. Roberts
Keyword(s):  
Moment Tensor ◽  
Moment Tensor Inversion

scholarly journals The waveform inversion of mainshock and aftershock data of the 2006 M6.3 Yogyakarta earthquake

2021 ◽  
Vol 8 (1) ◽  
Author(s):  
Hijrah Saputra ◽  
Wahyudi Wahyudi ◽  
Iman Suardi ◽  
Ade Anggraini ◽  
Wiwit Suryanto
Keyword(s):  
Joint Inversion ◽  
Body Wave ◽  
Moment Tensor ◽  
Near Field ◽  
Source Parameters ◽  
Waveform Inversion ◽  
Moment Tensor Inversion ◽  
Slip Distribution ◽  
Aftershock Distribution ◽  
Velocity Models

AbstractThis study comprehensively investigates the source mechanisms associated with the mainshock and aftershocks of the Mw = 6.3 Yogyakarta earthquake which occurred on May 27, 2006. The process involved using moment tensor inversion to determine the fault plane parameters and joint inversion which were further applied to understand the spatial and temporal slip distributions during the earthquake. Moreover, coseismal slip distribution was overlaid with the relocated aftershock distribution to determine the stress field variations around the tectonic area. Meanwhile, the moment tensor inversion made use of near-field data and its Green’s function was calculated using the extended reflectivity method while the joint inversion used near-field and teleseismic body wave data which were computed using the Kikuchi and Kanamori methods. These data were filtered through a trial-and-error method using a bandpass filter with frequency pairs and velocity models from several previous studies. Furthermore, the Akaike Bayesian Information Criterion (ABIC) method was applied to obtain more stable inversion results and different fault types were discovered. Strike–slip and dip-normal were recorded for the mainshock and similar types were recorded for the 8th aftershock while the 9th and 16th June were strike slips. However, the fault slip distribution from the joint inversion showed two asperities. The maximum slip was 0.78 m with the first asperity observed at 10 km south/north of the mainshock hypocenter. The source parameters discovered include total seismic moment M0 = 0.4311E + 19 (Nm) or Mw = 6.4 with a depth of 12 km and a duration of 28 s. The slip distribution overlaid with the aftershock distribution showed the tendency of the aftershock to occur around the asperities zone while a normal oblique focus mechanism was found using the joint inversion.

scholarly journals Regional Moment Tensor Inversion using Rotational Observations

2020 ◽  
Author(s):  
Gene Aaron Ichinose ◽  
Sean Ricardo Ford ◽  
Robert J. Mellors
Keyword(s):  
Moment Tensor ◽  
Moment Tensor Inversion

scholarly journals HybridMT: A MATLAB/Shell Environment Package for Seismic Moment Tensor Inversion and Refinement

2016 ◽  
Vol 87 (4) ◽  
pp. 964-976 ◽  
Author(s):  
Grzegorz Kwiatek ◽  
Patricia Martínez‐Garzón ◽  
Marco Bohnhoff
Keyword(s):  
Seismic Moment ◽  
Moment Tensor ◽  
Moment Tensor Inversion ◽  
Seismic Moment Tensor

Seismic Moment Tensor Inversion of an Induced Microseismic Event, Offshore Norway: An Insight into the Possible Cause of Wellbore Liner Failure during a Drilling Operation

2021 ◽  
Vol 92 (6) ◽  
pp. 3460-3470
Author(s):  
Zoya Zarifi ◽  
Fredrik Hansteen ◽  
Florian Schopper
Keyword(s):  
Seismic Moment ◽  
Moment Tensor ◽  
Moment Tensor Inversion ◽  
Seismic Moment Tensor ◽  
Isotropic Component ◽  
High Pump ◽  
Dc Component ◽  
Pump Pressure ◽  
Microseismic Event ◽  
Possible Cause

Abstract A microseismic event with Mw∼0.8 was recorded at the Grane oilfield, offshore Norway, in June 2015. This event is believed to be associated with a failure of the wellbore liner in well 25/11-G-8 A. The failure mechanism has been difficult to explain from drilling parameters and operational logs alone. In this study, we analyzed the detected microseismic event to shed light on the possible cause of this event. We inverted for the seismic moment tensor, analyzed the S/P amplitude ratio and radiation pattern of seismic waves, and then correlated the microseismic data with the drilling reports. The inverted seismic moment indicates a shear-tensile (dislocation) event with a strong positive isotropic component (67% of total energy) accompanied by a positive compensated linear vector dipole (CLVD) and a reverse double-couple (DC) component. Drilling logs show a strong correlation between high pump pressure and the occurrence of several microseismic events during the drilling of the well. The strongest microseismic event (Mw∼0.8) occurred during peak pump pressure of 277 bar. The application of high pump pressure was associated with an attempt to release the liner hanger running tool (RT) in the well, which had been obstructed. Improper setting of the liner hanger could have caused the forces from the RT release to be transferred to the liner and might have resulted in ripping and parting of the pipe. The possible direct impact of the ripped liner with the formation or the likely sudden hydraulic pressure exposure to the formation caused by the liner ripping may explain the estimated isotropic component in the moment tensor inversion in the well. This impact can promote slip along the pre-existing fractures (the DC component). The presence of gas in the formation or the funneled fluid to the formation caused by the liner ripping may explain the CLVD component.

Source parameter determination of local earthquakes in Korea using moment tensor inversion of single station data

1999 ◽  
Vol 89 (4) ◽  
pp. 1077-1082 ◽  
Author(s):  
So Gu Kim ◽  
Nadeja Kraeva
Keyword(s):  
Moment Tensor ◽  
Source Parameters ◽  
Moment Tensor Inversion ◽  
P Wave ◽  
Parameter Determination ◽  
Reverse Fault ◽  
3D Tomography ◽  
Single Station ◽  
Slip Event

Abstract The purpose of this investigation is to determine source parameters such as focal mechanism, seismic moment, moment magnitude, and source depth from recent small earthquakes in the Korcan Peninsula using broadband records of three-component single station. It is very important and worthwhile to use a three-component single station in Korea because for most Korean earthquakes it is not possible to read enough first motions of P-wave arrivals because of the poor coverage of the seismic network and the small size (ML 5.0 or less) of the events. Furthermore the recent installation of the very broadband seismic stations in Korea and use of a 3D tomography technique can enhance moment tensor inversion to determine the source parameters of small earthquakes (ML 5.0 or less) that occur at near-regional distances (Δ ≤ 500 km). The focal solution for the Youngwol earthquake of 13 December 1996 is found to be a right-lateral strike slip event with a NE strike, and the Kyongju earthquake of 25 June 1997 is found to be an oblique reverse fault with a slight component of left-lateral slip in the SE direction.

A fast, automated seismic moment tensor inversion approach for mine-induced microseismic data

First Break ◽  
2020 ◽  
Vol 38 (4) ◽  
pp. 75-82
Author(s):  
Lindsay Smith-Boughner ◽  
Irina Nizkous ◽  
Ian Leslie ◽  
Sebastian Braganza ◽  
Ian Pinnock ◽  
...  
Keyword(s):  
Seismic Moment ◽  
Moment Tensor ◽  
Moment Tensor Inversion ◽  
Seismic Moment Tensor ◽  
Microseismic Data
Sign in / Sign up

Export Citation Format

Share Document