scholarly journals Study of inheritance of some agronomic and morphological traits in burley tobacco by graphic analysis of diallel cross

2011 ◽  
Vol 50 (No. 4) ◽  
pp. 162-167 ◽  
Author(s):  
J. Butorac ◽  
J. Beljo ◽  
J. Gunjača

The mode of inheritance of yield, topping height, leaf number, days to flowering, leaf length and width was studied by means of graphic analysis in a half diallel cross test of four burley tobacco varieties (Saturn, TN 86, Bs 92 and Bols 100) in 1998 and 1999. The trial was set up according to the RCBD at four replications in the experimental field of Tobacco Institute Zagreb in Pitomača. Overdominance in inheritance of all studied traits, except leaf length and width in 1998, was found by the graphic method. No interallelic interaction and epistasis were present as seen from testing regression coefficients for all investigated traits and years. The distribution of parental genotypes on a scatter diagram along the expected regression line points to the genetic divergence of the parents. Parent Bs 92 appeared to have the most dominant alleles for yield and leaf length and parent Saturn for topping height, leaf number and leaf width.

1979 ◽  
Vol 30 (2) ◽  
pp. 251 ◽  
Author(s):  
N Thurling ◽  
LDV Das

A l0 x 10 complete diallel cross of spring rape cultivars was sown at three different times in the field to obtain basic information on the genetic control of pre-anthesis development. Analyses of variance of the diallel cross data indicated that both duration of the vegetative phase and leaf number at initiation were highly heritable in all sowings although dominance effects were also significant. No significant reciprocal differences were detected. Variance v. covariance (Vr–Wr) graphs for duration of the vegetative phase indicated that neither gene interaction nor correlated gene distribution was important. The order of parents along the regression line varied greatly between sowings. Late-flowering parents were found to possess a much higher frequency of recessive genes in the April and September sowings than in the June sowing when temperatures during early development were generally lower. It is suggested that this variation in the disposition of parents in the Vr–Wr graphs may reflect differences in genes for vernalization requirement which are expressed most strongly under higher temperatures. In the case of number of leaves formed prior to initiation, the slope of the regression line deviated significantly from unity in the first and second sowings, but the magnitude of this deviation declined with successive delays in sowing. Gene interaction and/or correlated gene distributions were apparently significant under certain conditions. The order of parents along the regression line also varied with sowing date, but not in as regular a manner as with duration of the vegetative phase. Differences in duration of the vegetative phase and leaf number between the Japanese cultivar Isuzu and all other parents in the September sowing appeared to be determined by one gene, or at most a small number of major genes.


2016 ◽  
Vol 41 (3) ◽  
pp. 565-577 ◽  
Author(s):  
MZA Talukder ◽  
ANM S Karim ◽  
S Ahmed ◽  
M Amiruzzaman

Combining ability and heterosis were studied in a 7×7 half diallel cross in maize for grain yield and yield contributing characters. Significant general and specific combining ability variances were observed for all the characters studied. The significant estimates of GCA and SCA variances suggested the importance of both additive and non-additive gene actions for the expression studied traits. In these studies, variances due to SCA were higher than GCA for all charactesr, which revealed the predominance of non additive gene action (dominance and epistasis) for controlling these traits. Parents P1 and P4 were excellent general combiner for days to tasseling and silking while P1 and P5 for early maturity. P4 for short height and, P4 and P7 for higher thousand kernel weight. The parents P4 and P6 having good combining abilities for yield. Heterosis estimation was carried out using two commercial varieties NK40 and 900MG. When standard commercial check NK40 was used, the percent heterosis for kernel yield varied from -51.39 to 12.53%. Among the 21 F1s, 3crosses exhibited significant positive heterosis for kernel yield. The highest heterosis was exhibited by the cross P4×P6 (12.43%), P6×P7 (10.89%) and P2×P3 (9.87%) respectively. Compared with 900MG as check, the percent heterosis for kernel yield varied from -53.73 to 7.01%. Among the 21 F1s, none of the crosses exhibited significant positive heterosis for kernel yield. The highest heterosis were exhibited by the crosses P4×P6 (7.01%), P6 x P7 (5.55%) and P2×P3 (4.57%). The crosses showed significant positive SCA values could be used for variety development after verifying them across the agro-ecological zones of Bangladesh.Bangladesh J. Agril. Res. 41(3): 565-577, September 2016


Helia ◽  
2017 ◽  
Vol 40 (66) ◽  
Author(s):  
Mohamed Ali Abd El-Satar

AbstractA half diallel cross between five divergent sunflower genotypes was evaluated under two contrast locations of Kafr El-Hamam (fovourable soil as a control) and Tag Al-Ezz (as salt affected soil) Agricultural Research Stations using randomized complete block design with three replications. High significance variation among genotypes and their components was detected for all studied traits at both and combined locations. Selection in early generations would be effective at both locations for improving days to 50 % flowering, days to physiological maturity, plant height, head diameter, No. of green leaves plant


2019 ◽  
Vol 2 (2) ◽  
pp. 43-51
Author(s):  
Nuryulsen Safridar, Sri Handayani

This study aims to determine the volume of water and the concentration of the nutrient solution and the right good plant to plant growth of lettuce (lactuca sativa L). This research has been carried out in the garden experiment Jabal Ghafur Faculty of Agriculture, University of Sigli. Runs from February to April 2017. This study used a raft floating hydroponics system. Research using completely randomized design (CRD) factorial pattern that is factor of the volume of water and nutrient concentration factor of good-plant. Treatment of the water volume (V) consists of three levels ie (V1) 4 liters of water, (V2) 8 liters of water and (V3) 12 liters of water. Good treatment-plant nutrient concentrations (N) consists of three levels ie (N1) 600 ppm (N2) of 800 ppm and (N3) 1000 ppm, with three replications so overall deplore 27 experimental unit. The volume of water very significant effect on plant height and leaf length aged 10, 20 and 30 days after planting, leaf number aged 20 and 30 days after planting, heavy wet stover age 30 HST, significantly affect the amount of leaf age 10 HST. Good-plant nutrients very significant effect on plant height ages of 20 and 30 days after planting, leaf number and length of leaf age 30 HST, significant effect on plant height HST age 10, age 20 HST leaf length, weight of wet age 30 HST stover.  Keywords: lettuce, hydroponics, water volume and concentration of good-plant nutrients


Genetika ◽  
2017 ◽  
Vol 49 (3) ◽  
pp. 1001-1014 ◽  
Author(s):  
Hasanalideh Haghighi ◽  
Ezatollah Farshadfar ◽  
Mehrzad Allahgholipour

In order to study the combining ability, genetic parameters and gene actions of yield, yield components and quality characters in rice, fifteen F2 generation of a 6?6 diallel cross, excluding reciprocals, was grown in a randomized complete block design (RCBD) with three replications. The results of analysis of variance showed significant differences between the genotypes for grain yield (GY), 100-grain weight (HGW), number of panicles per plant (PN), panicle length (PL), number of full grains per panicle (FGN) and for quality characters including amylose content (AC) and gel consistency (GC). The results of combining ability analysis revealed that general combining ability (GCA) and specific combining ability (SCA) were significant for characters GY, FGN, GC, AC, HGW and PN indicating the involvement of additive and non-additive effects in their inheritance, however high amounts of Bakers ratio remarked that additive gene effect had more portion in controlling these traits. The best combiners for GY, HGW, FGN, PN and PL, were RI18447-2, IR 50, Daylamani, RI18430-46 and Daylamani respectively. For AC and GC, the best combiner was Daylamani. Hayman's graphs showed that regression line passed below the origin cutting Wr axis in the negative region for HGW, PN, PL and GC, indicating the presence of over dominance. Estimates of genetic parameters showed significant amount of H1 and H2, and non-significant amount of D for the characters GY, PN, PL and GC, which confirmed the existence of dominance in the inheritance of these traits.


2015 ◽  
Vol 46 (4) ◽  
pp. 590-592 ◽  
Author(s):  
Cibele Mantovani ◽  
Kathia Fernandes Lopes Pivetta

ABSTRACT: The objective of this paper was to evaluate the effects of different honey concentrations in culture media, in comparison to sucrose medium, for the in vitro development of the epiphytic Encyclea cordigera orchid, in order to improve the process of propagation of the species. The in vitro germination was prepared on a reduced Murashige & Skoog (MS) medium. After 90 days, the seedlings were divided into different treatments, where they remained for another 90 days. Six treatments were set up (30g L-1 of sucrose; 15, 30, 45, and 60g L-1 of honey; and absence of any carbohydrates) in a completely randomized design. Plants were removed from the vials 270 days after the start of the experiment, and the number of roots, length of the largest leaf, length of the longest root, number of leaves, and fresh and dry masses were evaluated. Data concerning the number of leaves and roots were (x+1)1/2 transformed and subjected to an analysis of variance (ANOVA); the means were compared by a Tukey's test set at 5% probability. Medium containing 60g L-1 of honey proved to be superior to the sucrose medium traditionally used, favoring the in vitro growth and development of Encyclea cordigera. This medium can therefore be recommended for the propagation of this species, which is usually cultivated as an ornamental plant.


1979 ◽  
Vol 25 (3) ◽  
pp. 432-438 ◽  
Author(s):  
P J Cornbleet ◽  
N Gochman

Abstract The least-squares method is frequently used to calculate the slope and intercept of the best line through a set of data points. However, least-squares regression slopes and intercepts may be incorrect if the underlying assumptions of the least-squares model are not met. Two factors in particular that may result in incorrect least-squares regression coefficients are: (a) imprecision in the measurement of the independent (x-axis) variable and (b) inclusion of outliers in the data analysis. We compared the methods of Deming, Mandel, and Bartlett in estimating the known slope of a regression line when the independent variable is measured with imprecision, and found the method of Deming to be the most useful. Significant error in the least-squares slope estimation occurs when the ratio of the standard deviation of measurement of a single x value to the standard deviation of the x-data set exceeds 0.2. Errors in the least-squares coefficients attributable to outliers can be avoided by eliminating data points whose vertical distance from the regression line exceed four times the standard error the estimate.


Biometrika ◽  
2020 ◽  
Author(s):  
Seonghyun Jeong ◽  
Subhashis Ghosal

Summary We study posterior contraction rates in sparse high-dimensional generalized linear models using priors incorporating sparsity. A mixture of a point mass at zero and a continuous distribution is used as the prior distribution on regression coefficients. In addition to the usual posterior, the fractional posterior, which is obtained by applying Bayes theorem with a fractional power of the likelihood, is also considered. The latter allows uniformity in posterior contraction over a larger subset of the parameter space. In our set-up, the link function of the generalized linear model need not be canonical. We show that Bayesian methods achieve convergence properties analogous to lasso-type procedures. Our results can be used to derive posterior contraction rates in many generalized linear models including logistic, Poisson regression and others.


1979 ◽  
Vol 21 (1) ◽  
pp. 57-63 ◽  
Author(s):  
Wai-Koon Tan ◽  
Geok-Yong Tan ◽  
P. D. Walton

Twenty-one progenies and the parents of a 7 × 7 half diallel cross of smooth bromegrass (Bromus inermis Leyss.) were evaluated at four locations in Alberta in each of two years, for genetic variation and genetic by environment interactions in the expression of their yield potentials. Years, locations and their interactions were highly significant in the combined analysis of variance. Combining ability analysis revealed that general combining ability (GCA) and specific combining ability (SCA) were both important in the expression of yield, including spring, fall and annual yield, whereas GCA was more important than SCA for yield per area. Although the genotype × environment interactions were all highly significant, variation accounted for by combining ability effects was generally higher than the interaction effects of GCA and SCA respectively, with environments. High average GCA effects for spring, fall and annual yield were demonstrated for the clones UA5, UA9 and B42. These together with the high average SCA effects suggested that the three clones could be included in a synthetic to develop high yielding cultivars. The results suggested that recurrent selections involving multi-location and multi-year testing seems necessary in breeding for high yielding bromegrass cultivars in Alberta.


Sign in / Sign up

Export Citation Format

Share Document