scholarly journals Effective heat unit summation and base temperature on the development of rice plant. I. A method determining base temperature and its application to the vegetative development of rice plant.

1990 ◽  
Vol 59 (2) ◽  
pp. 225-232 ◽  
Author(s):  
Morie EBATA
1985 ◽  
Vol 117 (2) ◽  
pp. 185-192 ◽  
Author(s):  
L. Safranyik ◽  
H. S. Whitney

AbstractThe development and survival of mountain pine beetles axenically reared on standardized diet at 8 constant temperatures (10°–35 °C) were observed. At 32 °and 35 °C, 22 and 18% of the eggs hatched and all larvae died within 10 d of hatching. At the lower temperatures, 60–70% of the eggs hatched. The highest survival for all developmental stages was at 24 °C. At 10° and 15 °C development of all beetles reared in bolts of lodgepole pine or on axenic diet stopped when larvae were fully developed, whereas at 24 °and 27 °C all of the beetles developed normally to the adult stage. Larvae that had stopped developing during rearing at 15 °C resumed development after being transferred to 24 °C, indicating that pupation was limited by temperature. Although mean development times to the larval, pupal, and adult stages all decreased with increasing incubation temperature, heat-unit requirements above a base temperature of 5.6 °C were lowest for individuals reared at 27 °and 24 °C for all developmental stages. At these temperatures, an estimated average of 673 and 674 degree-days above 5.6 °C were required for development from egg to the tanned (dark) adult stage, respectively. The average widths of the prothorax and the sex ratios of axenic beetles were within published ranges. Mean development times and heat-unit requirements at constant temperatures for development to various life stages agreed well with published field and laboratory studies from western Canada.


1962 ◽  
Vol 42 (1) ◽  
pp. 15-21 ◽  
Author(s):  
G. W. Hope

The yearly variation in computed heat unit requirements of Perfection peas was reduced by modifying the method of deriving the units. Coefficients of variation of heat unit sums derived from daily means were lowest when daily maximum temperatures in excess of 60°F. were equated to 60° and when a base temperature of 36°F. was subtracted from the mean.Heat unit sums obtained from daily maxima were as homogeneous as those obtained from daily means.


2012 ◽  
Vol 63 (12) ◽  
pp. 1097 ◽  
Author(s):  
M. Mohammed Yusoff ◽  
D. J. Moot ◽  
B. A. McKenzie ◽  
G. D. Hill

This study quantified the relationship between vegetative development and temperature of ‘Old New Zealand’ faba bean, ‘Milton’ oats, and ‘Feast II’ Italian ryegrass using thermal time (Tt, degree-days) calculations. Each species was sown on five dates in autumn and winter 2008 and three dates in autumn 2009. The linear model for rate of development calculated the Tt requirement of faba bean for 75% emergence as 217 degree-days (base temperature (Tb) = 1.2°C), compared with 132 (Tb = 1.6°C) for oats and 132 (Tb = 1.8°C) for Italian ryegrass. Leaf appearance had a Tb of 2.4°C for faba bean, 3.0°C for oats, and 0.7°C for Italian ryegrass. The mean phyllochron (degree-days leaf–1) was 66 ± 1 for faba bean, 123 ± 3.90 for oats, and 120 ± 4.21 for Italian ryegrass. Soil temperature at 20 mm depth was the most accurate predictor of Tb and the Tt requirements to reach 75% emergence. Conversely, air temperature on-site was required to predict the phyllochron for faba bean because of its elevated growing point. Either air or soil temperature at the experimental site or at a nearby meteorological station could be used to define the phyllochron for oats and Italian ryegrass. These results highlight the importance of both soil and air temperatures to accurately define vegetative development before the processes are included in simulation models for these winter annual forage crops.


2015 ◽  
Vol 66 (4) ◽  
pp. 235 ◽  
Author(s):  
Matthew T. Harrison ◽  
Walter M. Kelman ◽  
Jim M. Virgona

In many regions, livestock are allowed to graze grain crops during their vegetative development, before grain is harvested at crop maturity. Little is known of the effects of grazing on crop microclimate, particularly the effects of defoliation on crown temperatures. Knowledge of such effects is important because temperature is the main factor underpinning crop ontogeny, and ontogeny drives dry matter allocation, leaf appearance rates and the timing of anthesis, which are key determinants of grain yield. The primary aim of this study was to examine the influence of grazing intensity and duration on the crown temperatures of winter wheat crops grown at Canberra, Australia. A secondary aim was to examine the association between crown temperature and phenology. In 2007, wheat cv. Mackellar was grazed at intensity–duration combinations of low–short (LS, 33 sheep/ha for 31 days), heavy–short (HS, 67 sheep/ha for 31 days) or low–long (LL, 33 sheep/ha for 62 days). In 2008, cvv. Mackellar and Naparoo were grazed at the HS intensity-duration. Cubic smoothing splines were fitted to crown temperature data measured between the end of grazing and anthesis to facilitate identification of long-term trends and statistical differences caused by the effects of defoliation on crown temperature. Grazing treatments with greater intensity or longer duration significantly elevated maximum daily crown temperature; differences of 6–7°C were common in the month following grazing. Cubic-spline analysis showed that long-term trends in maximum crown temperature of the HS and LL treatments were significantly greater than corresponding temperatures of controls for the entire post-grazing duration. By contrast, effects of grazing on minimum diurnal crown temperature were small. Increasing biomass removal significantly delayed stem elongation and anthesis. We demonstrate that although initial phenological delays caused by defoliation are large, greater diurnal crown temperature fluctuation in grazed crops leads to greater growing degree-day accumulation between the end of grazing and anthesis. This increases the rate of thermal time accumulation during the post-grazing–anthesis period and is likely prominent in driving greater development rates of grazed crops. We further demonstrate that delays in phenology associated with grazing can be largely accounted for by a thermal time constant, with the LS, HS and LL treatments delaying stem elongation by ~52, 141 and 214 degree-days, respectively, above a base temperature of 0°C. Results from these experiments and interpretations herein will be of use in designing crop-grazing regimes, and in studies examining implications of defoliation on vegetative microclimate and on physiological feedback effects caused by elevated temperature.


HortScience ◽  
1995 ◽  
Vol 30 (4) ◽  
pp. 790D-790
Author(s):  
S. Jenni ◽  
D.C. Cloutier ◽  
G. Bourgeois ◽  
K.A. Stewart

Plant dry weight of muskmelon transplants to anthesis could be predicted from a multiple linear regression based on air and soil temperatures prevailing under 11 mulch and rowcover combinations. The two dependent variables of the regression model consisted of a heat unit formula for air temperatures with a base temperature of 14C and a maximum-reduced threshold at 40C, and a standard growing-degree-day formula for soil temperatures with a base temperature of 12C. Based on 2 years of data, 86.5% of the variation in the dry weight (on a log scale) could be predicted with this model. The base temperature for predicting time to anthesis of muskmelon transplants was established at 6.8C and the thermal time ranged between 335 and 391 degree-days during the 2 years of the experiment.


1998 ◽  
Vol 123 (2) ◽  
pp. 195-201 ◽  
Author(s):  
Sylvie Jenni ◽  
Katrine A. Stewart ◽  
Gaétan Bourgeois ◽  
Daniel C. Cloutier

A simple method to predict time from anthesis of perfect flowers to fruit maturity (full slip) and yield is presented here for muskmelon (Cucumis melo L.) grown in a northern climate. Developmental time for individual muskmelons from anthesis to full slip could be predicted from several heat unit formulas, depending on the temperature data set used. When temperature at 7.5 cm above soil level was used, the heat unit formula resulting in the lowest coefficient of variation (cv=6.9%) accumulated daily average temperatures with a base temperature of 11 °C and an upper threshold of 25 °C. With temperatures recorded at a meteorological station located 2 km from the experimental field, the method showing the lowest cv (8.9%) accumulated daily maximum temperatures with a base temperature of 15 °C. This latter method was improved by including a 60-degree-day lag for second cycle fruit. The proportion of fruit volume at full slip of 22 fruit from the first cycle could be described by a common Richards function (R2=0.99). Although 65% of the plants produced two fruit cycles, fruit from the first cycle represented 72% of total yield in terms of number and mass. The blooming period of productive flowers lasted 34 days, each cycle overlapping and covering an equal period of 19 days. Counting the number of developing fruit >4 cm after 225 degree days from the start of anthesis (when 90% of the plants have at least one blooming perfect flower) could rapidly estimate the number of fruit that will reach maturity.


1997 ◽  
Vol 122 (2) ◽  
pp. 169-174 ◽  
Author(s):  
Robert J. Dufault

The objective of this research was to determine the least variable method to predict the dates of the first and last broccoli (Brassica oleracea L. var Italica) harvests based on heat unit summation using coefficients of variation (cv). The method with the lowest cv for predicting first harvest was to sum, over days from planting to harvest, the difference between the growing season mean (GSM) temperature and a base temperature of 7.2 °C. If the GSM maximum (max) temperature, however, was >26.7 °C, an adjusted max temperature was calculated by first subtracting 26.7 °C from the GSM max temperature and then subtracting the GSM mean temperature. Then the growing degree days (GDDs) were summed by subtracting the base temperature of 7.2 °C from the average of the GSM minimum (min) and adjusted max temperatures. This method produced a cv of 3.96 compared to 4.13 for the standard method of summing over the entire growing season, the mean temperature minus the base temperature of 4.4 °C. The method with the lowest cv for predicting last harvest was to sum, over days from planting to harvest, the difference between the GSM max temperature and a base temperature of 7.2 °C. If the GSM max temperature, however, was >29.4 °C, the base temperature was subtracted from 29.4 °C and not the actual GSM max temperature. This method produced a cv of 3.71 compared to 4.10 for the standard method of summing over the growing season, the mean temperature minus the base of 4.4 °C.


Sign in / Sign up

Export Citation Format

Share Document