Heteroepitaxial Si1-x-yGex Cy Layer Growth on (100)Si by Atmospheric Pressure Chemical Vapor Deposition

1995 ◽  
Vol 399 ◽  
Author(s):  
Z. Atzmon ◽  
A. E. Bair ◽  
T. L. Alford ◽  
D. Chandrasekhar ◽  
David J. Smith ◽  
...  

ABSTRACTThin heteroepitaxial films of Si1-x-yGexCy have been grown on (100)Si substrates using atmospheric pressure chemical vapor deposition at 550 and 700°C. The crystallinity, composition and microstructure of the SiGeC films were characterized using Rutherford backscattering spectrometry (ion channeling), secondary-ion-mass-spectrometry and cross-sectional transmission electron microscopy. SiGeC films with up to 2% C were grown at 700°C with good crystallinity and very few interracial defects, while misfit dislocations at the SiGe/Si interface were observed for SiGe films grown under the same conditions. This difference indicates that the presence of carbon in the SiGe matrix increases the critical thickness of the grown layers. SiGeC thin films (>110 nm) with up to 3.5% C were grown at 550°C with good crystallinity. The crystallinity of the films grown at lower temperature (550°C) was less sensitive to the flow rate of the C source (C2H4), which enabled growth of single crystal SiGeC films with higher C content.

1996 ◽  
Vol 11 (4) ◽  
pp. 989-1001 ◽  
Author(s):  
Joshua N. Musher ◽  
Roy G. Gordon

Near stoichiometric titanium nitride (TiN) was deposited from tetrakis(dimethylamido)titanium (TDMAT) and ammonia using atmospheric pressure chemical vapor deposition. Experiments were conducted in a belt furnace; static experiments provided kinetic data and continuous operation uniformly coated 150-mm substrates. Growth rate, stoichiometry, and resistivity are examined as functions of deposition temperature (190−420 °C), ammonia flow relative to TDMAT (0−30), and total gas-flow rate (residence time 0.3−0.6 s). Films were characterized by sheet resistance measurements, Rutherford Backscattering Spectrometry, and X-Ray Photoelectron Spectrometry. Films deposited without ammonia were substoichiometric (N/Ti, 0.6−0.75), contained high levels of carbon (C/Ti = 0.25−0.40) and oxygen (O/Ti = 0.6−0.9), and grew slowly. Small amounts of ammonia (NH3/TDMAT ≥ 1) brought impurity levels down to C/Ti, 0.1 and O/Ti = 0.3−0.5. Ammonia increased the growth rates by a factor of 4−12 at temperatures below 400 °C. Films 500 Å thick had resistivities as low as 1600 μΩ-cm when deposited at 280 °C and 1500 μΩ-cm when deposited at 370 °C. Scanning electron micrographs indicate a smooth surface and poor step coverage for films deposited with high ammonia concentrations.


1990 ◽  
Vol 204 ◽  
Author(s):  
Roy G. Gordon ◽  
David M. Hoffman ◽  
Umar Riaz

ABSTRACTThe atmospheric-pressure chemical vapor deposition of gallium nitride films from hexakis(dimethylamido)digallium, Ga2(NMe2)6, and ammonia precursors at 200 °C with growth rates up to 1000 Å/min is described. The films were characterized by transmission electron microscopy, X-ray photoelectron spectroscopy and Rutherford backscattering spectrometry. Rutherford backscattering analysis showed that the N/Ga ratio was 1.12–1.17. The films were crystalline with ≃ 5–15 nm crystallites.


2003 ◽  
Vol 15 (9) ◽  
pp. 1763-1765 ◽  
Author(s):  
Naoyuki Takahashi ◽  
Yusuke Nakatani ◽  
Takuma Yatomi ◽  
Takato Nakamura

2016 ◽  
Vol 5 (2) ◽  
pp. 56
Author(s):  
Keiji Komatsu ◽  
Pineda Marulanda David Alonso ◽  
Nozomi Kobayashi ◽  
Ikumi Toda ◽  
Shigeo Ohshio ◽  
...  

<p class="1Body">MgO films were epitaxially grown on single crystal MgO substrates by atmospheric-pressure chemical vapor deposition (CVD). Reciprocal lattice mappings and X-ray reflection pole figures were used to evaluate the crystal quality of the synthesized films and their epitaxial relation to their respective substrates. The X-ray diffraction profiles indicated that the substrates were oriented out-of-plane during MgO crystal growth. Subsequent pole figure measurements showed how all the MgO films retained the substrate in-plane orientations by expressing the same pole arrangements. The reciprocal lattice mappings indicated that the whisker film showed a relatively strong streak while the continuous film showed a weak one. Hence, highly crystalline epitaxial MgO thin films were synthesized on single crystal MgO substrates by atmospheric-pressure CVD.</p>


RSC Advances ◽  
2015 ◽  
Vol 5 (55) ◽  
pp. 44142-44148 ◽  
Author(s):  
Jun Pu ◽  
Lei Tang ◽  
Chaowei Li ◽  
Taotao Li ◽  
Lin Ling ◽  
...  

The facile and scalable technique is demonstrated, which grow graphene with controllable layers on copper foil substrates using the etching effect of H2 in atmospheric pressure chemical vapor deposition (APCVD).


Sign in / Sign up

Export Citation Format

Share Document