X-ray Photoelectron Spectroscopy of the Interface Between Diamond Films and Tantalum Substrates

1993 ◽  
Vol 317 ◽  
Author(s):  
M.M. Waitew ◽  
S. Ismat Shah
Keyword(s):  
Photoelectron Spectroscopy ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Diamond Growth ◽  
Plasma Chemical ◽  
X Ray ◽  
Plasma Chemical Vapor Deposition ◽  
Stages Of Growth ◽  
Diamond Peak

ABSTRACTDiamond films were deposited in a microwave plasma chemical vapor deposition (MPCVD) system on Ta substrates using a mixture of hydrogen and methane gases. The films were grown for varying lengths of time to provide samples with no diamond growth to a continuous diamond film. These films were analyzed using X-ray photoelectron spectroscopy (XPS) in order to understand the time dependent interactions between the substrate and the incoming carbon flux. Photoelectron peaks in the Ta 4f, C Is and Ols regions have been analyzed. In the initial stages of growth, a layer of carbide forms on the substrate. As the substrate becomes supersaturated with carbon, graphite starts to form on the surface. A diamond peak begins to appear after about 30 Minutes of deposition.

Evolution of surface relief of epitaxial diamond films upon growth resumption by microwave plasma chemical vapor deposition

CrystEngComm ◽  
2020 ◽  
Vol 22 (12) ◽  
pp. 2138-2146 ◽  
Author(s):  
G. Shu ◽  
V. G. Ralchenko ◽  
A. P. Bolshakov ◽  
E. V. Zavedeev ◽  
A. A. Khomich ◽  
...  
Keyword(s):  
Vapor Deposition ◽  
Surface Relief ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Diamond Growth ◽  
Plasma Chemical ◽  
Plasma Chemical Vapor Deposition ◽  
Step Growth ◽  
Growth Features

Homoepitaxial diamond growth may proceed with stops and resumptions to produce thick crystals. We found the resumption procedure to take place in a complex way, via a disturbance of step growth features, followed by the recovery after a certain time.

Synthesis of Crystalline Carbon Nitride by Microwave Plasma Chemical Vapor Deposition

2005 ◽  
Vol 480-481 ◽  
pp. 71-76 ◽  
Author(s):  
Jin Chun Jiang ◽  
Wen Juan Cheng ◽  
Yang Zhang ◽  
He Sun Zhu ◽  
De Zhong Shen
Keyword(s):  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Photoelectron Spectroscopy ◽  
Carbon Nitride ◽  
Microwave Plasma ◽  
Chemical Vapor ◽  
Chemical Vapor Deposition Method ◽  
Plasma Chemical ◽  
X Ray ◽  
Plasma Chemical Vapor Deposition

Carbon nitride films were grown on Si substrates by a microwave plasma chemical vapor deposition method, using mixture of N2, CH4 and H2 as precursor. Scanning electron microscopy shows that the films consisted of a large number of hexagonal crystallites. The dimension of the largest crystallite is about 3 µm. The X-ray photoelectron spectroscopy suggests that nitrogen and carbon in the films are bonded through hybridized sp2 and sp3 configurations. The X-ray diffraction pattern indicates that the major part of the films is composed of α-, β-, pseudocubic C3N4 and graphitic C3N4. The Raman peaks match well with the calculated Raman frequencies of α- and β-C3N4, revealing the formation of the α- and β-C3N4 phase.

Multivariable study on homoepitaxial diamond growth using isotopically enriched carbon-13 gas mixtures

2009 ◽  
Vol 24 (2) ◽  
pp. 493-498 ◽  
Author(s):  
Gopi K. Samudrala ◽  
Yogesh K. Vohra
Keyword(s):  
Microwave Plasma ◽  
Chemical Vapor ◽  
Nitrogen Vacancy ◽  
Diamond Growth ◽  
Plasma Chemical ◽  
Rocking Curve ◽  
X Ray ◽  
Plasma Chemical Vapor Deposition ◽  
Force Microscopy ◽  
Atomic Force

We report our observations on the homoepitaxial diamond growth by microwave plasma chemical vapor deposition (MPCVD) experiments on Type Ib diamond substrates conducted by varying three independent variables. In a feed gas mixture of H2, N2, O2, and 13CH4, the amount of nitrogen was varied in the range of 0 to 4000 ppm, the amount of methane was varied from 2% CH4/H2 to 6% CH4/H2, and the substrate temperature was varied in the range of 850 to 1200 °C. We used isotopically enriched carbon-13 methane gas as the source of carbon in the plasma to clearly distinguish the grown diamond layer from the underlying substrate using Raman spectroscopy. The x-ray rocking curve measurements confirmed the homoepitaxial nature of the deposited layers with a slight increase in the full width at half-maximum for sample grown with the highest nitrogen content in the plasma. Optical and atomic force microscopy revealed dramatic changes in surface morphology with variation in each parameter. The nitrogen incorporation in carbon-13 diamond layers was monitored through photoluminescence spectroscopy of nitrogen–vacancy complexes. A twentyfold increase in diamond growth rate was clearly achieved in this multivariable study.

Morphology of heavily B-doped diamond films

1993 ◽  
Vol 8 (11) ◽  
pp. 2845-2857 ◽  
Author(s):  
Koichi Miyata ◽  
Kazuo Kumagai ◽  
Kozo Nishimura ◽  
Koji Kobashi
Keyword(s):  
Vapor Deposition ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
X Ray Diffraction ◽  
Plasma Chemical ◽  
X Ray ◽  
Plasma Chemical Vapor Deposition ◽  
Si Substrates ◽  
Surface Morphologies

B-doped diamond films were synthesized by microwave plasma chemical vapor deposition using a mixture of methane (0.5% or 1.2%) and diborane (B2H6) below 50 ppm on either Si substrates or undoped diamond films that had been synthesized using 0.5% or 1.2% methane. The surface morphologies of the synthesized films were observed by Secondary Electron Microscopy, and the infrared absorption and Raman spectra were measured. It was found that when diborane concentration was low, B-doped films preferred (111) facets. On the other hand, high diborane concentrations resulted in a deposition of needle-like material that was identified as graphite by x-ray diffraction.

Growth of highly (111)-oriented, highly coalesced diamond films on platinum (111) surface: A possibility of heteroepitaxy

1996 ◽  
Vol 11 (12) ◽  
pp. 2955-2956 ◽  
Author(s):  
Yoshihiro Shintani
Keyword(s):  
Electron Microscopy ◽  
Vapor Deposition ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
X Ray Diffraction ◽  
Plasma Chemical ◽  
X Ray ◽  
Plasma Chemical Vapor Deposition ◽  
Scanning Electron

A highly (111)-oriented, highly coalesced diamond film was grown on platinum (111) surface by microwave plasma chemical vapor deposition (MPCVD). Scanning electron microscopy and x-ray diffraction analyses revealed that the (111) diamond facets were azimuthally oriented epitaxially with respect to the orientation of the Pt(111) domain underneath, with the neighboring facets of diamond being coalesced with each other. The film was confirmed as diamond using Raman spectroscopy.

CRYSTALLINE CARBON NITRIDE FILMS GROWN BY MICROWAVE PLASMA CHEMICAL VAPOR DEPOSITION

2002 ◽  
Vol 16 (06n07) ◽  
pp. 1091-1095 ◽  
Author(s):  
W. T. ZHENG ◽  
X. WANG ◽  
T. DING ◽  
X. T. LI ◽  
W. D. FEI ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Photoelectron Spectroscopy ◽  
Carbon Nitride ◽  
Microwave Plasma ◽  
Chemical Vapor ◽  
Plasma Chemical ◽  
X Ray ◽  
Plasma Chemical Vapor Deposition

The carbon nitride films were deposited on single crystalline Si(001) and polycrystalline diamond substrates using microwave plasma chemical vapor deposition (MPCVD) with CH4+N2 as well as CH4+NH3 mixtures as the reactive gas source, respectively. Different CH4/N2 and CH4/NH3 gas ratios were tested. The results showed that carbon nitride films with different nitrogen content could more readily be obtained using a mixture of CH4/N2 rather than CH4/NH3. The films grown by different CH4/N2 ratios showed different morphology, which was revealed by scanning electron microscopy (SEM). The crystalline carbon nitride films containing silicon were realized using a CH4:N2 = 1:100 ratio. X-ray photoelectron spectroscopy (XPS), Auger electron microscopy (AES), Raman spectroscopy, and X-ray diffraction were used to characterize the composition and chemical bonding of the deposited films.

scholarly journals Evolution of High-Quality Homoepitaxial CVD Diamond Films Induced by Methane Concentration

Coatings ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 888
Author(s):  
Pengfei Zhang ◽  
Weidong Chen ◽  
Longhui Zhang ◽  
Shi He ◽  
Hongxing Wang ◽  
...  
Keyword(s):  
Methane Concentration ◽  
Flat Surface ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Plasma Chemical ◽  
High Quality ◽  
Effect Analysis ◽  
Plasma Chemical Vapor Deposition ◽  
Atomically Flat

In this paper, we successfully synthesized homoepitaxial diamond with high quality and atomically flat surface by microwave plasma chemical vapor deposition. The sample presents a growth rate of 3 μm/h, the lowest RMS of 0.573 nm, and the narrowest XRD FWHM of 31.32 arcsec. An effect analysis was also applied to discuss the influence of methane concentration on the diamond substrates.

Sign in / Sign up

Export Citation Format

Share Document