scholarly journals An Experimental Observation Related To The Pore Space Between Particles Of Cement In Pastes At Early Ages

1988 ◽  
Vol 137 ◽  
Author(s):  
Hamlin M. Jennings

Cement paste of water:cement ratios less than about 0.3 usually are not workable, but workability can be maintained at these lower water:cement ratios by using superplasticizers. A typical explanation [1] of the mechanism behind the effectiveness of superplasticizers is that they adsorb on the surface of cement particles and adjust the surface charge so that the particles become deflocculated. The individual particles flow more easily than larger flocs.

The proofs of the no-interaction theorem have been given by many authors in the framework of hamiltonian and lagrangian formalism. They are based on the assumption that there is hamiltonian or lagrangian describing the interaction between particles. This paper presents the proof without such an assumption for one, two, three and four particles. We assume the conservation laws for the linear and angular momentum that are the sums of the respective quantities of individual particles. Then there is no interaction, i. e. the worldlines of the individual particles are straight.


When a beam of electric particles is passed through a sheet of matter the energy of the individual particles is reduced. The loss of energy is not the same for all the particles so that particles incident on the foil with the same energy emerge with different energies. This dispersion of the energy caused by the foil is known as the "straggling" of the particles. The straggling of α-particles has been the subject of several experimental investigations, and the theory in this case was adequately developed by Bohr in 1915. In the case of β-particles, however, the straggling was not experimentally investigated until quite recently and no theoretical treatment of the phenomenon has been given, the calculations of Bohr being, as he showed, applicable only to α-particles. The purpose of the work described in this paper is to develop a theory of the straggling of β-particles by thin foils and by means of it to interpret the results of experiment. The paper is arranged as follows. In 2 an account is given of the state of the experimental work on the subject, and in particular the effect of the complications introduced by "scattering" are considered. The formula derived by Bohr for the straggling of electric particles is given in 3 and its inapplicability to β-particles demonstrated. The present calculations of the straggling of β-particles are given in 4. The theory of the straggling of electric particles resolves itself into two parts. The first deals with the dynamics of collisions between electric particles and atoms, and is the same whether we are concerned with the straggling or some other phenomena such as ionisation of "stopping power." This may be called the fundamental theory and its requirements may be summarised in the function ϕ (Q) which express the frequency of collisions in which the electric particle loses energy of amount Q. The second part of the theory is the process of calculating the straggling by means of probability theory from the function ϕ . This may be regarded as the straggling theory proper and it is the main subject of 4. When the present calculations were started it was intended to calculate the straggling on the basis of classical theory only, the value of the function ϕ on this theory being definitely known. However, after some practice with the type of calculation involved it was decided to calculate the straggling for other forms of ϕ . From the results obtained it is possible to deduce the straggling corresponding to any form which ϕ may reasonably have, and if a new theory leads to a value of ϕ different from the classical value, the straggling on the new theory may readily be determined. Alternatively this fuller treatment may be used for the reverse process of calculating from the observed straggling the value of ϕ to which it corresponds. This is considered to be the most convenient procedure and in 5 the form of ϕ which explains the experimental results is deduced. this is compared in 6 with the value of ϕ on classical theory. A brief outline is given in 7 of certain new ideas concerning the nature of collisions of electric particles with electrons and atoms.


1962 ◽  
Vol 35 (4) ◽  
pp. 918-926 ◽  
Author(s):  
P. Mason

Abstract In Part I of this series it was shown how variations in the dynamic Young's modulus with extension could be represented by linear relations for gum rubbers in the region of 0 to 100% extension. The present work uses a similar treatment to examine how the viscoelastic behavior of natural rubber within this extension region is affected by the incorporation of two carbon blacks of widely differing colloidal activity. One of these materials, MT black, consists substantially of spherical particles with a mean diameter of about 0.4 microns: electron microscopy of cut surfaces of the black-rubber compound showed that the individual particles were well-dispersed. The finer material, HAF black, has a mean particle diameter of about 0.04 microns but exists in the rubber compound in a flocculated condition with aggregates up to about 0.3 microns in diameter. The rubber containing the coarse, MT black yielded linear strain relations enabling a direct comparison to be made with the behavior of the gum: the HAF material did not give linear relations for either the dynamic or the equilibrium Young's modulus. To facilitate discussion of this behavior it is desirable to set out more explicitly than in Part I the model underlying the analysis.


Author(s):  
Yijie Wang ◽  
Jun Chen

Abstract Digital in-line holography (DIH) has been applied to measure the 3D position of objects in a variety of applications, including bubbles and droplets in multi-phase flows, tracking particles in turbulence flows, etc. In addition to the 3D position, the morphology and dimension of the individual particles can also be extracted from the recorded hologram. In this study, a lens-less digital in-line holography setup is applied to measure the morphology and size of three kinds of solid particles (Wollastonite Powder, Pearl Mica Powder and Solder Powder), whose sizes range from several to hundreds of micrometers. The statistics of equivalent diameter, aspect ratio and circularity are introduced to describe the morphology and dimension of each kind of particles. Microscopic images of the particles are taken to verify the accuracy of measurements with DIH. The results measured from DIH are in good agreements with results from microscopic images.


Geophysics ◽  
2019 ◽  
Vol 84 (3) ◽  
pp. E173-E188 ◽  
Author(s):  
Sara Johansson ◽  
Matteo Rossi ◽  
Stephen A. Hall ◽  
Charlotte Sparrenbom ◽  
David Hagerberg ◽  
...  

Although many studies have been performed to investigate the spectral induced polarization (SIP) response of nonaqueous phase liquid (NAPL)-contaminated soil samples, there are still many uncertainties in the interpretation of the data. A key issue is that altered pore space geometries due to the presence of a NAPL phase will change the measured IP spectra. However, without any information on the NAPL distribution in the pore space, assumptions are necessary for the SIP data interpretation. Therefore, experimental data of SIP signals directly associated with different NAPL distributions are needed. We used high-resolution X-ray tomography and 3D image processing to quantitatively assess NAPL distributions in samples of fine-grained sand containing different concentrations of tetrachloroethylene and link this to SIP measurements on the same samples. The total concentration of the sample constituents as well as the volumes of the individual NAPL blobs were calculated and used for the interpretation of the associated SIP responses. The X-ray tomography and image analysis showed that the real sample properties (porosity and NAPL distributions) differed from the targeted ones. Both contaminated samples contained less NAPL than expected from the manual sample preparation. The SIP results showed higher real conductivity and lower imaginary conductivity in the contaminated samples compared to a clean sample. This is interpreted as an effect of increased surface conductivity along interconnected NAPL blobs and decreased surface areas in the samples due to NAPL blobs larger than and enclosing grains. We conclude that the combination of SIP, X-ray tomography, and image analysis is a very promising approach to achieve a better understanding of the measured SIP responses of NAPL-contaminated samples.


1999 ◽  
Vol 121 (1) ◽  
pp. 49-53 ◽  
Author(s):  
B. J. Griffiths ◽  
D. T. Gawne ◽  
G. Dong

This paper describes the topographical implications of grit blasted surfaces on plasma sprayed alumina. The transition of the grit blasted surface from raw material to correctly blasted is described in terms of surface heights, height distribution, spacings and texture. The influence of embedded grit is shown to be significant. The individual particles of alumina impacting the surface are classified into two types, these being disc splats and splash splats. Their deposition relationships with regard to surface topography and adhesion is explained with reference to the two types of splat.


Nanoscale ◽  
2017 ◽  
Vol 9 (36) ◽  
pp. 13527-13537 ◽  
Author(s):  
Yinghua Qiu ◽  
Zuzanna Siwy

Surface charge of particles can be probed via an approach curve of individual particles to a pore.


Author(s):  
V. A. Kuzmin ◽  
I. A. Zagrai ◽  
I. A. Desiatkov

The paper deals with the issues related to the effect of slagging within the steam boilers furnaces and shows the determination results on peat ash fusibility of Kirov region deposits. Fusibility properties of peat ash (temperatures of deformation, sphere, hemisphere and flow) from the four industrial areas (Dymny, Pishchalsky, Karinsky, Gorokhovsky) depending on its chemical composition are presented. Melting temperature of the mineral part of the peat, determined by GOST, is averaged and does not reflect the actual melting temperature of the individual particles in fly ash. The existence of such separate particles having a melting temperature below the average melting temperature of the ash makes it difficult to find the operating temperature of the torch to reach the minimum of the furnace slagging during peat combustion. The comparison of melting characteristics of peat ash with the reference literature data is performed. The initial slagging temperature is calculated depending on the ratio of the acidic and basic oxides in peat ash.


2021 ◽  
Vol 9 (2) ◽  
pp. 235-251
Author(s):  
András A. Sipos ◽  
Gábor Domokos ◽  
János Török

Abstract. Abrasion of sedimentary particles in fluvial and eolian environments is widely associated with collisions encountered by the particle. Although the physics of abrasion is complex, purely geometric models recover the course of mass and shape evolution of individual particles in low- and middle-energy environments (in the absence of fragmentation) remarkably well. In this paper, we introduce the first model for the collision-driven collective mass evolution of sedimentary particles. The model utilizes results of the individual, geometric abrasion theory as a collision kernel; following techniques adopted in the statistical theory of coagulation and fragmentation, the corresponding Fokker–Planck equation is derived. Our model uncovers a startling fundamental feature of collective particle size dynamics: collisional abrasion may, depending on the energy level, either focus size distributions, thus enhancing the effects of size-selective transport, or it may act in the opposite direction by dispersing the distribution.


Fluids ◽  
2019 ◽  
Vol 4 (3) ◽  
pp. 172
Author(s):  
Elias Laribi ◽  
Shun Ogawa ◽  
Guilhem Dif-Pradalier ◽  
Alexei Vasiliev ◽  
Xavier Garbet and Xavier Leoncini

Starting from the given passive particle equilibrium particle cylindrical profiles, we built self-consistent stationary conditions of the Maxwell-Vlasov equation at thermodynamic equilibrium with non-flat density profiles. The solutions to the obtained equations are then discussed. It appears that the presence of an azimuthal (poloidal) flow in the plasma can ensure radial confinement, while the presence of a longitudinal (toroidal) flow can enhance greatly the confinement. Moreover in the global physically reasonable situation, we find that no unstable point can emerge in the effective integrable Hamiltonian of the individual particles, hinting at some stability of the confinement when considering a toroidal geometry in the large aspect ratio limit.


Sign in / Sign up

Export Citation Format

Share Document