Ordering of InGaAs Quantum Dots Grown by Molecular Beam Epitaxy under As2 gas flux

2015 ◽  
Vol 1792 ◽  
Author(s):  
Mourad Benamara ◽  
Yuriy I. Mazur ◽  
Peter Lytvyn ◽  
Morgan E. Ware ◽  
Vitaliy Dorogan ◽  
...  

ABSTRACTThe influence of the substrate temperature on the morphology and ordering of InGaAs quantum dots (QD), grown on GaAs (001) wafers by Molecular Beam Epitaxy (MBE) under As2 flux has been studied using Transmission Electron Microscopy (TEM), Atomic Force Microscopy (AFM) and Photoluminescence (PL) measurements. The experimental results show that lateral and vertical orderings occur for temperatures greater than 520°C and that QDs self-organize in a 6-fold symmetry network on (001) surface for T=555°C. Vertical orderings of asymmetric QDs, along directions a few degrees off [001], are observed on a large scale and their formation is discussed.

2011 ◽  
Vol 2011 ◽  
pp. 1-15 ◽  
Author(s):  
Garima Thakur ◽  
Miodrag Micic ◽  
Yuehai Yang ◽  
Wenzhi Li ◽  
Dania Movia ◽  
...  

Nanoparticles have enormous potential in diagnostic and therapeutic studies. We have demonstrated that the amyloid beta mixed with and conjugated to dihydrolipoic acid- (DHLA) capped CdSe/ZnS quantum dots (QDs) of size approximately 2.5 nm can be used to reduce the fibrillation process. Transmission electron microscopy (TEM) and atomic force microscopy (AFM) were used as tools for analysis of fibrillation. There is a significant change in morphology of fibrils when amyloidβ(1–42) (Aβ(1–42)) is mixed or conjugated to the QDs. The length and the width of the fibrils vary under modified conditions. Thioflavin T (ThT) fluorescence supports the decrease in fibril formation in presence of DHLA-capped QDs.


2002 ◽  
Vol 722 ◽  
Author(s):  
David J. Smith ◽  
Daming Huang ◽  
Michael A Reshchikov ◽  
Feng Yun ◽  
T. King ◽  
...  

AbstractWe have investigated a novel approach for improving GaN crystal quality by utilizing a stack of quantum dots (QDs) in GaN grown on sapphire substrates by molecular beam epitaxy. The GaN films were grown on GaN/AlN buffer layers containing multiple QDs and characterized using x-ray diffraction, photoluminescence, atomic force microscopy, and transmission electron microscopy. The density of the dislocations in the films was determined by defect delineation wet chemical etching and atomic force microscopy. It was found that the insertion of a set of multiple GaN QD layers in the buffer layer effectively reduced the density of the dislocations in the epitaxial layers. As compared to a density of ∼1010cm-2in typical GaN films grown on AlN buffer layers, a density of ∼3×107cm-2was demonstrated in GaN films grown with the QD layers. Transmission electron microscopy observations confirmed termination of threading dislocations by the QD layers.


2002 ◽  
Vol 737 ◽  
Author(s):  
Susan Y. Lehman ◽  
Alexana Roshko ◽  
Richard P. Mirin ◽  
John E. Bonevich

ABSTRACTThree samples of self-assembled In0.44Ga0.56As quantum dots (QDs) grown on (001) GaAs by molecular beam epitaxy (MBE) were studied using atomic force microscopy (AFM) and high-resolution transmission electron microscopy (TEM) in order to characterize the height, faceting, and densities of the QDs. The cross-sectional TEM images show both pyramidal dots and dots with multiple side facets. Multiple faceting has been observed only in dots more than 8.5 nm in height and allows increased dot volume without a substantial increase in base area. Addition of a GaAs capping layer is found to increase the diameter of the QDs from roughly 40 nm to as much as 200 nm. The areal QD density is found to vary up to 50 % over the central 2 cm x 2 cm section of wafer and by as much as 23 % on a length scale of micrometers.


1995 ◽  
Vol 378 ◽  
Author(s):  
G. Kissinger ◽  
T. Morgenstern ◽  
G. Morgenstern ◽  
H. B. Erzgräber ◽  
H. Richter

AbstractStepwise equilibrated graded GexSii-x (x≤0.2) buffers with threading dislocation densities between 102 and 103 cm−2 on the whole area of 4 inch silicon wafers were grown and studied by transmission electron microscopy, defect etching, atomic force microscopy and photoluminescence spectroscopy.


Sign in / Sign up

Export Citation Format

Share Document