Utilizing alternate target deposition to increase the magnetoelectric effect at room temperature in a single phase M-type hexaferrite

2017 ◽  
Vol 7 (2) ◽  
pp. 97-101 ◽  
Author(s):  
Hessam Izadkhah ◽  
Saba Zare ◽  
Sivasubramanian Somu ◽  
Fabrizio Lombardi ◽  
Carmine Vittoria
Keyword(s):  
Room Temperature ◽  
Single Phase ◽  
Magnetoelectric Effect ◽  
Image Position

Abstract

Magnetoelectric Properties in Nickel Ferrite – Niobate Relaxor Bulk Composites

2012 ◽  
Vol 77 ◽  
pp. 215-219
Author(s):  
Piotr Guzdek
Keyword(s):  
Magnetic Field ◽  
Nickel Ferrite ◽  
Room Temperature ◽  
Single Phase ◽  
Magnetoelectric Effect ◽  
Multiferroic Materials ◽  
Fundamental Interest ◽  
Practical Applications ◽  
Magnetoelectric Properties ◽  
Properties Of Composites

Magnetoelectric effect in multiferroic materials is widely studied for its fundamental interest and practical applications. The magnetoelectric effect observed for single phase materials like Cr2O3, BiFeO3, Pb(Fe0.5Nb0.5)O3is usually small. A much larger effect can be obtained in composites consisting of magnetostrictive and piezoelectric phases. This paper investigates the magnetostrictive and magnetoelectric properties of nickel ferrite Ni0.3Zn0.62Cu0.08Fe2O4- relaxor Pb(Fe0.5Nb0.5)O3bulk composites. The magnetic properties of composites shows a dependence typical of such composite materials, i.e. it consists of a dominating signal from ferrimagnetic phase (ferrite) and a weak signal from paramagnetic (antiferromagnetic) phase (relaxors). Magnetoelectric effect at room temperature was investigated as a function of static magnetic field (300-7200 Oe) and frequency (10 Hz-10 kHz) of sinusoidal modulation magnetic field. The magnetoelectric effect increase slightly before reaching a maximum at HDC= 750 Oe and then decrease. The magnetoelectric coefficient increases continuously as frequency is raised, although this increase is less pronounced in the 1-10 kHz range.

On the occurrence of a metastable tetragonal t′-phase in a ZrO2−13.6 mole % MgO ceramic and its microscopic thermal evolution

1993 ◽  
Vol 8 (3) ◽  
pp. 605-610 ◽  
Author(s):  
M.C. Caracoche ◽  
P.C. Rivas ◽  
A.F. Pasquevich ◽  
A.R. López García ◽  
E. Aglietti ◽  
...  
Keyword(s):  
Thermal Behavior ◽  
Room Temperature ◽  
Oxygen Vacancies ◽  
Single Phase ◽  
Thermal Evolution ◽  
Hyperfine Interactions ◽  
Correlation Technique ◽  
Cubic Field ◽  
Time Differential ◽  
T Phase

The time-differential perturbed angular correlation technique has been used to investigate the thermal behavior of a ZrO2−13.6 mole % MgO ceramic between room temperature and 1423 K. Two different quadrupole hyperfine interactions corresponding to a tetragonal structure have been found to result on cooling the ceramic from the single-phase cubic field. One of them agrees with that depicting the pure t-ZrO2 tetragonal phase and the other one has been interpreted as describing a high-MgO-content nontransformable t'–ZrO2 phase. As temperature increases, the latter gives rise to a similar but fluctuating interaction related to the oxygen vacancies mobility and which shows a thermal behavior analogous to that already reported for the stabilized cubic ZrO2. Above 1100 K these dynamic t'-sites transform into pure tetragonal ones which behave ordinarily, suffering the t → m phase transition when cooling to room temperature. Differences found between TDPAC results and information drawn from other techniques are discussed.

Impedance Spectroscopy Study of LiTaO3 Powder Synthesized via Sol-Gel Method

2012 ◽  
Vol 545 ◽  
pp. 275-278 ◽  
Author(s):  
Lili Widarti Zainuddin ◽  
Norlida Kamarulzaman
Keyword(s):  
Room Temperature ◽  
Single Phase ◽  
Sol Gel ◽  
Rhombohedral Structure ◽  
Spectroscopy Study ◽  
X Ray Diffraction ◽  
Gel Method ◽  
X Ray ◽  
Sol Gel Method ◽  
Impedance Spectroscopy Study

A ceramics sample of LiTaO3 was prepared using a sol-gel method. The sample is annealed at 750 °C for 48 hours. X-ray diffraction analysis indicate the formation of single phase, rhombohedral structure. An ac impedance study was used to analyse the conductivity of LiTaO3 at room temperature and at various temperatures.

Magnetic Ordering in Relation to the Room-Temperature Magnetoelectric Effect ofSr3Co2Fe24O41

2011 ◽  
Vol 106 (8) ◽  
Author(s):  
Minoru Soda ◽  
Taishi Ishikura ◽  
Hiroyuki Nakamura ◽  
Yusuke Wakabayashi ◽  
Tsuyoshi Kimura
Keyword(s):  
Room Temperature ◽  
Magnetoelectric Effect ◽  
Magnetic Ordering

scholarly journals Equimolar Yttria-Stabilized Zirconia and Samaria-Doped Ceria Solid Solutions

Ceramics ◽  
2018 ◽  
Vol 1 (2) ◽  
pp. 343-352 ◽  
Author(s):  
Reginaldo Muccillo ◽  
Daniel de Florio ◽  
Eliana Muccillo
Keyword(s):  
Tetragonal Phase ◽  
Room Temperature ◽  
Single Phase ◽  
Rietveld Analysis ◽  
X Ray Diffraction ◽  
Ceramic Powders ◽  
Stabilized Zirconia ◽  
X Ray ◽  
Ceria Solid Solutions ◽  
Attrition Milling

Compositions of (ZrO2)0.92(Y2O3)0.08 (zirconia: 8 mol % yttria—8YSZ) and (CeO2)0.8(Sm2O3)0.2 (ceria: 20 mol % samaria—SDC20) ceramic powders were prepared by attrition milling to form an equimolar powder mixture, followed by uniaxial and isostatic pressing. The pellets were quenched to room temperature from 1200 °C, 1300 °C, 1400 °C and 1500 °C to freeze the defects configuration attained at those temperatures. X-ray diffraction analyses, performed in all quenched pellets, show the evolution of the two (8YSZ and SDC20) cubic fluorite structural phases to a single phase at 1500 °C, identified by Rietveld analysis as a tetragonal phase. Impedance spectroscopy analyses were carried out in pellets either quenched or slowly cooled from 1500 °C. Heating the quenched pellets to 1000 °C decreases the electrical resistivity while it increases in the slowly cooled pellets; the decrease is ascribed to annealing of defects created by lattice micro-tensions during quenching while the increase to partial destabilization of the tetragonal phase.

scholarly journals Structure and electric properties of cerium substituted SrBi1.8Ce0.2Nb2O9 and SrBi1.8Ce0.2Ta2O9 ceramics

2016 ◽  
Vol 10 (3) ◽  
pp. 183-188 ◽  
Author(s):  
Mohamed Afqir ◽  
Amina Tachafine ◽  
Didier Fasquelle ◽  
Mohamed Elaatmani ◽  
Jean-Claude Carru ◽  
...  
Keyword(s):  
Dielectric Constant ◽  
Solid State ◽  
Room Temperature ◽  
Single Phase ◽  
Solid State Reaction Method ◽  
X Ray Diffraction ◽  
Reaction Method ◽  
X Ray ◽  
Lcr Meter ◽  
Curie Temperature Tc

SrBi1.8Ce0.2Nb2O9 (SBCN) and SrBi1.8Ce0.2Ta2O9 (SBCT) powders were prepared via solid-state reaction method. X-ray diffraction analysis reveals that the SBCN and SBCT powders have the single phase orthorhom-bic Aurivillius structure at room temperature. The contribution of Raman scattering and FTIR spectroscopy of these samples were relatively smooth and resemble each other. The calcined powders were uniaxially pressed and sintered at 1250?C for 8 h to obtaine dense ceramics. Dielectric constant, loss tangent and AC conductivity of the sintered Ce-doped SrBi2Nb2O9 and SrBi2Ta2O9 ceramics were measured by LCR meter. The Ce-doped SBN (SBCN) ceramics have a higher Curie temperature (TC) and dielectric constant at TC (380?C and ?? ~3510) compared to the Ce-doped SBT (SBCT) ceramics (330?C and ?? ~115) when measured at 100Hz. However, the Ce-doped SBT (SBCT) ceramics have lower conductivity and dielectric loss.

scholarly journals Ferromagnetic Order in the Intermetallic Alloys laNi5-xMgx

2012 ◽  
Vol 29 (1) ◽  
pp. 50
Author(s):  
D.N Ba ◽  
L.T Tai ◽  
N.T Trung ◽  
N.T Huy
Keyword(s):  
Magnetic Properties ◽  
Curie Temperature ◽  
Room Temperature ◽  
Single Phase ◽  
Chemical Doping ◽  
Intermetallic Alloys ◽  
X Ray Diffraction ◽  
X Ray ◽  
Ferromagnetic Order ◽  
Diffraction Patterns

The influences of the substitution of Ni with Mg on crystallographic and magnetic properties of the intermetallic alloys LaNi5-xMgx (x ≤ 0.4) were investigated. The X-ray diffraction patterns showed that all samples were of single phase, and the lattice parameters, a and c, decreased slightly upon chemical doping. LaNi5 is well known as an exchange-enhanced Pauli paramagnet. Interestingly, in LaNi5-xMgx, the ferromagnetic order existed even with a small amount of dopants; the Curie temperature reached the value of room temperature for x = 0.2, and enhanced with increasing x.

Synthesis and Luminescence Properties of Chalcopyrite-Type CuAlS2

2006 ◽  
Vol 301 ◽  
pp. 177-180 ◽  
Author(s):  
Yuichiro Kuroki ◽  
Tomoichiro Okamoto ◽  
Masasuke Takata
Keyword(s):  
Diffraction Analysis ◽  
Room Temperature ◽  
Single Phase ◽  
Elevated Temperatures ◽  
Emission Peak ◽  
Maximum Intensity ◽  
X Ray Diffraction ◽  
Ultraviolet Emission ◽  
X Ray ◽  
Copper Aluminum

Copper aluminum disulfide (CuAlS2) powders were synthesized in an evacuated ampoule at elevated temperatures. X-ray diffraction analysis revealed that the powders heated at temperatures higher than 800oC were single-phase CuAlS2. In the cathodoluminescence (CL) spectra measured at room temperature, the powders heated at temperatures higher than 600oC exhibited a visible emission peak at approximately 1.8 eV and a distinct ultraviolet emission peak at 3.45 eV. The powder heated at 700oC showed the maximum intensity of ultraviolet emission which is considered to be associated with excitons.

EFFECT OF ION-ENERGY ON THE PROPERTIES OF AMORPHOUS GaN FILMS PRODUCED BY ION-ASSISTED DEPOSITION

2001 ◽  
Vol 15 (28n29) ◽  
pp. 1355-1360 ◽  
Author(s):  
UDAY LANKE ◽  
ANNETTE KOO ◽  
SIMON GRANVILLE ◽  
JOE TRODAHL ◽  
ANDREAS MARKWITZ ◽  
...  
Keyword(s):  
Room Temperature ◽  
Single Phase ◽  
Thermal Evaporation ◽  
Ion Beam ◽  
Atomic Ratio ◽  
Nuclear Reaction Analysis ◽  
Ion Energy ◽  
X Ray ◽  
Nitrogen Ions ◽  
Nitrogen Ion

Amorphous GaN films were deposited on various substrates viz. Si (100), quartz, glass, Al, stainless steel and glassy carbon by thermal evaporation of gallium in the presence of energetic nitrogen ions from a Kaufman source. The films were deposited at room temperature and 5 × 10-4 mbar nitrogen partial pressure. The effect of a low energy nitrogen ion beam during the synthesis of films was investigated for energies 40 eV and 90 eV. The N:Ga atomic ratio, bonding state, microstructure, surface morphology, and electrical properties of the deposited a-GaN films were studied by different characterisation techniques. The films are found to be X-ray amorphous in nature, which is confirmed by Raman spectroscopy. Rutherford Backscattering Spectroscopy (RBS) and Nuclear Reaction Analysis (NRA) indicate the N:Ga atomic ratio in the films. The 400-750 eV energy range is thought to be optimal for the production of single-phase amorphous GaN . The effect of ion-energy on optical, Raman, and electrical conductivity measurements of the films is also presented.

Sign in / Sign up

Export Citation Format

Share Document