Determination of structure-property relationships for 3-aminopropyltriethoxysilane films using x-ray reflectivity

2013 ◽  
Vol 28 (8) ◽  
pp. 1118-1128 ◽  
Author(s):  
Sandip U. Argekar ◽  
Terence L. Kirley ◽  
Dale W. Schaefer

Abstract

Author(s):  
Linqi Shi ◽  
Zipei Sun ◽  
Jiajie Tian ◽  
Yaodong Huang ◽  
Jiben Meng

Four naphthopyran derivatives, namely, 3,3-bis(naphthalen-1-yl)-3H-naphtho[2,1-b]pyran, C33H22O, NP1, 3,3-bis([1,1′-biphenyl]-4-yl)-3H-naphtho[2,1-b]pyran, C37H26O, NP2, 3,3-bis(4-phenoxyphenyl)-3H-naphtho[2,1-b]pyran, C37H26O2, NP3, and 3,3-bis(4-methoxy-2-methylphenyl)-3H-naphtho[2,1-b]pyran, C29H26O3, NP4, were synthesized and their photochromic properties investigated. NP1–NP4 exhibited good photochromism in different solutions and in poly(methyl methacrylate) (PMMA) film under UV light irradiation. Solvatochromism and the electronic and steric effects of the substituent group on photochromism were analyzed and decolouration curves were found to fit a monoexponential kinetic decay in most cases. Single-crystal X-ray analysis of NP1 and NP2 revealed the structure–property relationships. Good fatigue resistance of NP1, both in solution and in the PMMA film, endows it with potential value for applications.


2004 ◽  
Vol 844 ◽  
Author(s):  
David J. Scurr ◽  
Stephen J. Eichhorn

ABSTRACTThis study uses various characterisation techniques on the razor shell (Ensis siliqua), to relate the shell's microstructure to its mechanical properties. Scanning electron microscopy (SEM) has shown that the outer and inner regions of the shell are composed of simple and complex crossed lamellar microstructures respectively. These layers are interspersed by prismatic layers of a completely different crystallographic orientation. Nanoindentation and microhardness measurements have shown that the structure is anisotropic, and Raman band shifts have been observed within these indented/deformed areas of shell, showing that the microstructure deforms rather than generating surface damage. The use of energy variable synchrotron X-ray diffraction has shown that the calcium carbonate crystals of the shell are preferentially orientated as a function of depth and that opposing residual stresses exist at the outer and inner regions of the shell. This study has analysed several microstructural features of the shell and provided an insight into how they prevent failure of the material.


1990 ◽  
Vol 123 ◽  
pp. 463-468
Author(s):  
M. Matsuoka ◽  
N. Kawai ◽  
T. Imai ◽  
M. Yamauchi ◽  
A. Yoshida ◽  
...  

AbstractWe propose an X-ray all sky monitor for Japanese Experimental Module (JEM) on the space station. Considering practical circumstances, we show as a case study that the all sky monitor with slit hole cameras is most promising for monitoring the short-term and long-term X-ray transients. We call this all sky monitor as MAXI (Monitor of All-sky X-ray Image). Position determination of gamma-ray bursts could be achieved with accuracy less than one degree observing the X-ray component of the burst. Weak X-ray sources such as active galactic nuclei could be also monitored with time resolution less than one day. The X-ray all sky monitor will work to discover X-ray novae and transient phenomena and give us the alarm for further detailed observations. The obtained data will be also used for archival study.


2006 ◽  
Vol 21 (2) ◽  
pp. 125-131 ◽  
Author(s):  
J. H. Dunsmuir ◽  
S. Bennett ◽  
L. Fareria ◽  
A. Mingino ◽  
M. Sansone

For research facilities with access to synchrotron X-ray sources, X-ray absorption microtomography (XMT) has evolved from an experimental imaging method to a specialized, if not yet routine, microscopy for imaging the three-dimensional (3D) distribution of linear attenuation coefficients and, in some cases, elemental concentration with micron spatial resolution. Recent advances in source and detector design have produced conventional X-ray source instruments with comparable spatial resolution but with lower throughput and without element specific imaging. Both classes of instrument produce 3D images for analysis. We discuss an integrated approach for the implementation of analytical XMT to support basic research into the structure-property relationships of a variety of materials. The essential components include instrumentation for collecting quantitative 3D images, a 3D image processing environment to address questions as to the quantity, composition, geometry, and relationships among the features in one or more images, and visualization to provide insight and communicate results. We give examples of image analysis of resolved and unresolved pore spaces of sandstones.


2016 ◽  
Vol 3 (10) ◽  
pp. 1306-1316 ◽  
Author(s):  
M. Węcławik ◽  
A. Gągor ◽  
R. Jakubas ◽  
A. Piecha-Bisiorek ◽  
W. Medycki ◽  
...  

Two hybrid crystals imidazolium iodoantimonate(iii) and iodobismuthate(iii) have been synthesized and characterized in a wide temperature range (100–350 K) by means of X-ray diffraction, dielectric spectroscopy, proton magnetic resonance, FT-IR spectroscopy and optical observations.


2013 ◽  
Vol 13 (12) ◽  
pp. 5383-5390 ◽  
Author(s):  
Takatsugu Endo ◽  
Hyuma Masu ◽  
Kozo Fujii ◽  
Takeshi Morita ◽  
Hiroko Seki ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document