Rapid Determination of the Fly Ash Content of Construction Materials

1995 ◽  
Vol 17 (1) ◽  
pp. 69 ◽  
Author(s):  
RD Hooton ◽  
SM Schlorholtz ◽  
W Dubberke
1995 ◽  
Vol 17 (1) ◽  
pp. 55 ◽  
Author(s):  
RD Hooton ◽  
RD Hooton ◽  
CA Rogers

1979 ◽  
Vol 23 ◽  
pp. 45-55 ◽  
Author(s):  
Jacques Renault

AbstractThe intensity of Compton scattering, Fe, and Ca chatacteristic radiation can be used to estimate the amount of ash in coal by Xray fluorescence spectroscopy. Mo, W, and Cr radiation were used to study a suite of New Mexico coals, and the best results were obtained with Mo and W X-ray tubes. If the actual concentrations of Fe2O3 and CaO and the mass absorption coefficient, μ*, at the Compton wavelength of scattered Mo K radiation can be determined, the regression equation:%Ash - 24.2μ* - 6.28(%Fe2O3) - 1.96(%CaO) - 3.4estimates the ash content with an average error of 0.5% ash at 0.71Å.


1985 ◽  
Vol 39 (3) ◽  
pp. 470-472
Author(s):  
H. D. Pandey ◽  
M. S. Prasad

This paper describes a simple graphical calibration procedure for rapid determination of ash content in coal samples. The results obtained with this procedure are compared with those obtained earlier with the use of a regression equation. The two results are found to be in agreement.


2020 ◽  
Author(s):  
Fedor Kapustin ◽  
Vladislav Ufimtsev ◽  
Andrey Vishnevsky ◽  
Irina Fomina ◽  
Alexey Kapustin ◽  
...  

The system of dry ash–slag removal at the Reftinskaya state district power plant which provides capture, storage and shipment of fly ash to the consumers is considered in this study. The results of determination of chemical and phase composition, physical properties, melting temperature and activity of natural radionuclides of ash which is form during burning of stone coal of Ekibastuz basin are presented. Ash is acidic, superfine and refractory one with a low content of combustible substance. As to composition and properties it satisfies the requirements of Russian Standard no. 25818 and ships to consumers under Technical Conditions 5717–004–79935691–2009. The results of laboratory tests and industrial production of building materials and products on the basis of ash of Reftinskaya state district power plant are presented. It is shown that ash is used in the production of Portland cement, heavy and cellular autoclave concrete, dry mixes and can also be used as part of fly ash non-fired and agloporite gravel, ceramic bricks. The features of their production, basic physical and mechanical properties of building materials and products are described. It is shown that the introduction of a new system of dry ash removal at the state district power plant contributes to the expansion of directions and increase in the volume of ash recycling. Keywords: Reftinskaya state district power plant, dry ash removal, fly ash, composition, properties, use, construction materials and products


1976 ◽  
Vol 20 ◽  
pp. 431-436
Author(s):  
J. A. Cooper ◽  
B. D. Wheeler ◽  
G. J. Wolfe ◽  
D. M. Bartell ◽  
D. B. Schlafke

A procedure using tube excited energy dispersive x-ray fluorescence analysis with interelement corrections has been developed for multielement analysis of major and trace elements and ash content of coal, coke, and fly ash. The procedure uses pressed pellets and an exponential correction for interelement effects. The average deviations ranged from about 0.0003% for V at an average concentration of about .003% to 0.1% for S at an average concentration of 4%. About 25 elements were measured and 100 second minimum detectable concentrations ranged from about one part per million for elements near arsenic to about one tenth of one percent for sodium.


2021 ◽  
Vol 11 (24) ◽  
pp. 11601
Author(s):  
Panagiota P. Giannakopoulou ◽  
Aikaterini Rogkala ◽  
Paraskevi Lampropoulou ◽  
Maria Kalpogiannaki ◽  
Petros Petrounias

The need for environmentally friendly construction materials is growing more and more these days. This paper investigates byproducts from Greece, such as magnesite tailings from Evoia and fly ash from Kardia (Ptolemais), in order to evaluate their suitability as cement additives. For this purpose, the raw materials were tested and studied regarding their mineralogical and chemical components for their morphological characteristics. Different cement specimens of various mixtures of raw materials were produced and tested. These raw materials are considered suitable for cement additives. The effect of nano MgO content seems to have played a more critical role in the physicomechanical performance of produced cement compared to that of the fly ash content. Furthermore, more satisfactory results in the physicomechanical properties of the produced cement gave samples of group II containing 3–4% of nano MgO. Nano MgO content up to 4% seems to have negative influence on the compressive strength of the produced cement, simultaneously reducing its durability. The increase of nano MgO content leads to the increase of the expansion of the produced cement specimens. In the early stage, the expansion rate was intensively larger. With the consumption of nano MgO, the expansion in the later stage gradually slowed down and tended to stabilize.


Sign in / Sign up

Export Citation Format

Share Document