Simulation of stray radiation from optical window with temperature dependent spectral properties

2021 ◽  
Author(s):  
Hongyu Pan ◽  
chuang sun ◽  
Xue Chen ◽  
Xinlin Xia
Keyword(s):  
Spectral Properties ◽  
Temperature Dependent ◽  
Optical Window ◽  
Stray Radiation

scholarly journals Implications of temperature-dependent near-IR spectral properties of common minerals and meteorites for remote sensing of asteroids

1999 ◽  
Vol 26 (12) ◽  
pp. 1661-1664 ◽  
Author(s):  
J. L. Hinrichs ◽  
P. G. Lucey ◽  
M. S. Robinson ◽  
A. Meibom ◽  
A. N. Krot
Keyword(s):  
Remote Sensing ◽  
Spectral Properties ◽  
Temperature Dependent ◽  
Near Ir

Temperature dependent spectral properties of type-I and quasi type-II CdSe/CdS dot-in-rod nanocrystals

2012 ◽  
Vol 14 (10) ◽  
pp. 3505 ◽  
Author(s):  
Xiaoming Wen ◽  
Amit Sitt ◽  
Pyng Yu ◽  
Yon-Rui Toh ◽  
Jau Tang
Keyword(s):  
Spectral Properties ◽  
Type I ◽  
Type Ii ◽  
Temperature Dependent

A new generation of highly sensitive luminescent thermometers operating in the optical window of biological tissues

2016 ◽  
Vol 4 (24) ◽  
pp. 5559-5563 ◽  
Author(s):  
Lukasz Marciniak ◽  
Artur Bednarkiewicz ◽  
Diana Kowalska ◽  
Wieslaw Strek
Keyword(s):  
High Sensitivity ◽  
Biological Tissues ◽  
Temperature Dependent ◽  
Optical Window ◽  
Highly Sensitive ◽  
New Type ◽  
New Generation ◽  
First Time

A new type of luminescent thermometer based on highly temperature dependent d–d Cr3+ transitions related to barely temperature dependent f–f Nd3+ transitions for bio-application is reported for the first time, showing exceptionally high sensitivity.

(111) Monocrystalline Nickel Films

1972 ◽  
Vol 30 ◽  
pp. 512-513
Author(s):  
T.E. Pratt ◽  
R.W. Vook
Keyword(s):  
Film Thickness ◽  
Deposition Rate ◽  
Room Temperature ◽  
Narrow Range ◽  
High Vacuum ◽  
Residual Pressure ◽  
Temperature Dependent ◽  
Deposition Parameters ◽  
Transmission Electron ◽  
Substrate Temperatures

(111) oriented thin monocrystalline Ni films have been prepared by vacuum evaporation and examined by transmission electron microscopy and electron diffraction. In high vacuum, at room temperature, a layer of NaCl was first evaporated onto a freshly air-cleaved muscovite substrate clamped to a copper block with attached heater and thermocouple. Then, at various substrate temperatures, with other parameters held within a narrow range, Ni was evaporated from a tungsten filament. It had been shown previously that similar procedures would yield monocrystalline films of CU, Ag, and Au.For the films examined with respect to temperature dependent effects, typical deposition parameters were: Ni film thickness, 500-800 A; Ni deposition rate, 10 A/sec.; residual pressure, 10-6 torr; NaCl film thickness, 250 A; and NaCl deposition rate, 10 A/sec. Some additional evaporations involved higher deposition rates and lower film thicknesses.Monocrystalline films were obtained with substrate temperatures above 500° C. Below 450° C, the films were polycrystalline with a strong (111) preferred orientation.

Sign in / Sign up

Export Citation Format

Share Document