RELATIONSHIP BETWEEN SOIL MOISTURE CONTENT AND SOIL SURFACE REFLECTANCE

2005 ◽  
Vol 48 (5) ◽  
pp. 1979-1986 ◽  
Author(s):  
A. L. Kaleita ◽  
L. F. Tian ◽  
M. C. Hirschi
1994 ◽  
Vol 4 (4) ◽  
pp. 225 ◽  
Author(s):  
JC Valette ◽  
V Gomendy ◽  
J Marechal ◽  
C Houssard ◽  
D Gillon

The aim of this study was to analyse the effects of duff thickness and moisture content, and of soil moisture content on the transfer of heat in the soil. The experimental design used intact soil blocks with their duff layer, subjected to controlled fires of variable very low intensities of up to 100 kW m-1. The fuel on the surface was composed of needles and twigs of Pinus pinaster. The maximum temperatures measured within the fuel were of the order of 650 degrees C and were independent of the fireline intensities. For fires with fireline intensity of the order of 30 kW m-1, the presence of the duff layer reduced from 330 degrees C the temperature rise at the soil surface. Duff thickness played only a secondary role, but increasing moisture content reinforced its insulating effect, so that the temperature rise was 2.5 times less at 1 cm depth in the duff when the moisture content exceeded 70% dry weight, than when the moisture content was less than 30%. For more intense fires (> 50 kW m-1) that produced longer-lasting surface heating, duff thickness and moisture content played an important role in significantly reducing the temperature rise at the soil surface (range 140 degrees C to 28 degrees C). Because of low soil thermal conductivity, temperature attenuation with increasing depth was noticed. In the case of low intensity fires (< 30 kW m-1) in the absence of a duff layer, the maximum temperatures were reduced from 350 degrees C at the surface to 7 degrees C at 3.5 cm. The temperature rise in the soil decreased with depth according to a negative exponential relation. The rate constant of this relation was greater when the initial surface temperature and the soil moisture content were higher. For the soil studied, and under the moisture conditions encountered (between 7 and 19% of dry weight), the rate constant could be predicted with acceptable precision (r2 = 0.67), if the surface soil temperature rise and the soil moisture content were known. In these experimental fires, which were carried out when the air temperature did not exceed 20 degrees C, lethal temperatures (> 60 degrees C) were measured in the upper few centimetres of the duff layer in very low-intensity fires, and in the upper few centimetres of the soil (where nutrients are most concentrated and biological activity most intense) in the slightly more intense fires. The fire intensities were always very moderate, and of the order of magnitude df those encountered in the prescribed burns conducted on fuel-breaks of the french Mediterranean area. Their impact on the surface of the forest soil, in terms of lethal temperatures transmitted to the horizon rich in organic matter, are not negligible. In contrast, below 3 to 5 cm depth, prescribed burns, conducted under the conditions of the experiments, would not lead to significant change to nutrients or microfaunal or microfloral activity; in particular, root tips would not be subjected to heat stress sufficient to kill them.


Water ◽  
2019 ◽  
Vol 11 (8) ◽  
pp. 1731 ◽  
Author(s):  
Michał Śpitalniak ◽  
Krzysztof Lejcuś ◽  
Jolanta Dąbrowska ◽  
Daniel Garlikowski ◽  
Adam Bogacz

Climate change induces droughts that are becoming more intensive and more frequent than ever before. Most of the available forecast tools predict a further significant increase in the risk of drought, which indicates the need to prepare solutions to mitigate its effects. Growing water scarcity is now one of the world’s leading challenges. In agriculture and environmental engineering, in order to increase soil water retention, soil additives are used. In this study, the influence of a newly developed water absorbing geocomposite (WAG) on soil water retention and soil matric potential was analyzed. WAG is a special element made from geotextile which is wrapped around a synthetic skeleton with a superabsorbent polymer placed inside. To describe WAG’s influence on soil water retention and soil matric potential, coarse sand, loamy sand, and sandy loam soils were used. WAG in the form of a mat was used in the study as a treatment. Three kinds of samples were prepared for every soil type. Control samples and samples with WAG treatment placed at depths of 10 cm and 20 cm were examined in a test container of 105 × 70 × 50 cm dimensions. The samples had been watered and drained, and afterwards, the soil surface was heated by lamps of 1100 W total power constantly for 72 h. Soil matric potential was measured by Irrometer field tensiometers at three depths. Soil moisture content was recorded at six depths: of 5, 9, 15, 19, 25, and 30 cm under the top of the soil surface with time-domain reflectometry (TDR) measurement devices. The values of soil moisture content and soil matric potential were collected in one-minute steps, and analyzed in 24-h-long time steps: 24, 48, and 72 h. The samples with the WAG treatment lost more water than the control samples. Similarly, lower soil matric potential was noted in the samples with the WAG than in the control samples. However, after taking into account the water retained in the WAG, it appeared that the samples with the WAG had more water easily available for plants than the control samples. It was found that the mechanism of a capillary barrier affected higher water loss from soil layers above those where the WAG had been placed. The obtained results of water loss depend on the soil type used in the profile.


1983 ◽  
Vol 61 (1) ◽  
pp. 241-255 ◽  
Author(s):  
K. A. Baldwin ◽  
M. A. Maun

Measurements were obtained of relative abundance of vegetation, edaphic properties, and microclimate characteristics of some initial stages of the Lake Huron sand-dune sequence at Pinery Provincial Park, Ont. Of the five dune habitats sampled, the oldest (transition zone) was distinguishable from the rest on the basis of greater diversity and abundance of vegetation, higher organic matter content, higher moisture-retaining capacity, enhanced concentrations of available K+ and Mg2+, depleted levels of Ca2+ in the surface soil, reduced air turbulence, and slightly higher air temperatures. The midsummer microclimate of the open dune habitat was characterized by extremely high day temperatures at the soil surface (5 cm) with large diurnal temperature fluctuations. Soil moisture content was generally low in the surface layers of the soil, but at depths greater than 10 cm, it was always plentiful (> 2.5% of soil by weight). Canonical variates analysis showed that the transition zone habitat (800 years old) was separated from younger ones (first dune ridge, slack, high beach) on the first canonical variate (V1), which accounted for about 50% of the total dispersion in the data. The discrimination of the transition zone microclimate on V1 was best characterized by difference in soil moisture content at shallow depths (5 and 10 cm) and wind velocity at 50 and 150 cm above the soil surface.


2020 ◽  
Vol 12 (19) ◽  
pp. 8238
Author(s):  
Jibing Xiong ◽  
Runhua Yu ◽  
Ejazul Islam ◽  
Fuhai Zhu ◽  
Jianfeng Zha ◽  
...  

High soil surface temperature and loosened soil are major limiting factors of plant productivity in arid and semi-arid coal mining areas of China. Moreover, the extensive and illegitimate burning of crop residues is causing environmental pollution; whereas, these residues could be converted to biochar to benefit soil quality. In this study, the effect of wheat straw biochar (WSB) at rates of 0% (control, CK), 1% (low, LB), 2% (medium, MB) and 4% (high, HB) on soil temperature at different depths (5, 10, 15, and 20 cm) and moisture levels (10 and 20%) was investigated under high soil surface temperature of 50 °C and air humidity of 40%. Our data suggested that soil bulk density was inversely, and soil moisture was directly corelated with soil thermal parameters. Moreover, the increasing rate of WSB addition linearly decreased the soil thermal properties. The maximum decrease in soil bulk density at both moisture levels (10% and 20%) was measured in HB treatment compared to respective CKs. The highest decrease in soil thermal conductivity (59.8% and 24.7%) was found under HB treatment in comparison to respective controls (CK10% and CK20% moisture). The soil volumetric heat capacity was also strongly corelated with soil moisture content (r = 0.91). The WSB treatments displayed differential responses to soil temperature. Under 10% soil moisture, temperature of LB, MB and HB treatments was higher as compared to CK at 5–20 cm depth, and MB treated soil had the smallest increase in temperature. At the 15-cm depth, the MB treatment decreased the temperature by 0.93 °C as compared to the CK20%. Therefore, the effect of WSB on soil temperature was influenced by soil moisture content, soil depth and WSB application rates. It suggested that MB treatment could be a useful farming practice for mitigating soil temperature fluctuation.


2021 ◽  
Vol 13 (7) ◽  
pp. 1402
Author(s):  
Chen Gao ◽  
Min Xu ◽  
Hanzeyu Xu ◽  
Wei Zhou

Moisture content in tidal flats changes frequently and spatially on account of tidal fluctuations, which greatly influence the reflectance of the tidal flat surface. Precise prediction of the spatial-temporal variation of tidal flats’ moisture content is an important foundation of surface bio-geophysical information research by remote sensing. In this paper, we first measured the multi-angle reflectance of soil samples obtained from tidal flats in the northeastern Dongtai, Jiangsu Province, China, in the laboratory. Then, based on the particle swarm optimization (PSO) algorithm, we retrieved the photometric characteristics of the soil surface by employing the SOILSPECT bidirectional reflectance model. Finally, the soil moisture content was retrieved by introducing the equivalent water thickness of the soil. The results showed that: (i) A significant correlation existed between the retrieved equivalent water thickness and the measured soil moisture content. The SOILSPECT model is capable of estimating soil moisture with high precision by using multi-angle reflectance. (ii) Retrieved values of single scattering albedo (ω) were consistent with the variation of soil moisture content. The roughness parameter (h) and the asymmetry factor (Θ) were consistent with the structure and particle composition of the soil surface in dry soil samples. (iii) When the soil samples were soaked with water, the roughness parameter (h) and the type of scattering on the soil surface both showed irregular changes. These results support the importance of using the measured soil particle size as one of the parameters for the retrieval of soil moisture content, which is a method that should be used cautiously, especially in tidal flats.


1979 ◽  
Vol 27 (4) ◽  
pp. 284-296
Author(s):  
A.J. Koolen ◽  
F.F.R. Koenigs ◽  
W. Bouten

Using a ground-based radar with a single frequency in the X-band (3 cm wavelength), the feasibility of mapping soil surface roughness and top soil moisture content was investigated. In order to cover the broad range of bare-soil appearances which occur in agricultural practice, the field treatment included a number of tillage types, several degrees of soil structure change which normally occur after tillage, and different soil moisture content. Different angles between the ray beam and the irradiated land (grazing angles) were used. The shape of radar return ( gamma )-grazing angle curves were entirely determined by soil surface roughness, while their positions depended on moisture content. Although this type of radar had limited discrimination ability, mapping of roughness and moisture may be possible under certain conditions. (Abstract retrieved from CAB Abstracts by CABI’s permission)


Weed Science ◽  
1976 ◽  
Vol 24 (1) ◽  
pp. 134-136 ◽  
Author(s):  
Stephen D. Miller ◽  
John D. Nalewaja

Wild oat (Avena fatuaL.) seedlings were exposed to vapors arising from soil treated with triallate [S-(2,3,3-trichloroallyl)diisopropylthiocarbamate]. Vapor from the liquid triallate formulation inhibited seedling growth more than vapor from the granular formulation, and the degree of inhibition was least in Fargo clay, intermediate in Hecla sandy loam and greatest in washed sand. Growth inhibition from vapors of soil-applied liquid or granular triallate increased as soil moisture content and soil temperature increased. The site of effective vapor action on wild oat seedlings was below the soil surface.


2011 ◽  
Vol 28 (1) ◽  
pp. 85-91 ◽  
Author(s):  
Run-chun LI ◽  
Xiu-zhi ZHANG ◽  
Li-hua WANG ◽  
Xin-yan LV ◽  
Yuan GAO

2001 ◽  
Vol 66 ◽  
Author(s):  
M. Aslanidou ◽  
P. Smiris

This  study deals with the soil moisture distribution and its effect on the  potential growth and    adaptation of the over-story species in north-east Chalkidiki. These  species are: Quercus    dalechampii Ten, Quercus  conferta Kit, Quercus  pubescens Willd, Castanea  sativa Mill, Fagus    moesiaca Maly-Domin and also Taxus baccata L. in mixed stands  with Fagus moesiaca.    Samples of soil, 1-2 kg per 20cm depth, were taken and the moisture content  of each sample    was measured in order to determine soil moisture distribution and its  contribution to the growth    of the forest species. The most important results are: i) available water  is influenced by the soil    depth. During the summer, at a soil depth of 10 cm a significant  restriction was observed. ii) the    large duration of the dry period in the deep soil layers has less adverse  effect on stands growth than in the case of the soil surface layers, due to the fact that the root system mainly spreads out    at a soil depth of 40 cm iii) in the beginning of the growing season, the  soil moisture content is    greater than 30 % at a soil depth of 60 cm, in beech and mixed beech-yew  stands, is 10-15 % in    the Q. pubescens  stands and it's more than 30 % at a soil depth of 60 cm in Q. dalechampii    stands.


Sign in / Sign up

Export Citation Format

Share Document