Solar disinfection as low-cost technologies for clean water production

2018 ◽  
Vol 6 (3) ◽  
Author(s):  
Arie Herlambang

Clean water to poor communities who live in crowded municipal area is stillexpensive and a luxury. This condition is evidenced by the number of people whouse ground water for their daily water, because water taps still seems expensivefor them. Diarrheal disease is still relatively high for Indonesia, where nearly 16thousand people suffer from diarrhea due to poor sanitation. To help the poor inthe city, there are several alternative technologies that can be applied to publicaccess to clean water and adequate low-cost, including ground water treatmenttechnology with a filter system equipped with an ultraviolet sterilizer, or ozonegenerators, or using ultrafiltration, if possible can also use the reverse osmosismembrane that for fresh water. Arsinum is the best alternative should be chosenfor fulfilled potable water in slump area.Keywords : Sanitation, water treatment technology, portable water, low-cost, slump area


2021 ◽  
pp. 129099
Author(s):  
Ruofei Zhu ◽  
Mingming Liu ◽  
Yuanyuan Hou ◽  
Dan Wang ◽  
Liping Zhang ◽  
...  

2017 ◽  
Vol 18 (3) ◽  
pp. 843-852
Author(s):  
Travis D. Gardner ◽  
Joe D. Guggenberger

Abstract Ceramic pot filters (CPFs) are an effective point of use water treatment device in developing nations due to their low cost and effectiveness. CPFs are gravity fed, typically making water production a major limiting factor to a CPF's lifetime and acceptability. Directly connecting CPFs to in-line pumping systems or systems with an elevated storage tank would allow filter usage for constant water treatment at increased pressures, increasing the quantity of treated water. Ceramic disks were manufactured for testing in a specially designed housing apparatus. Filters of varying thicknesses and clay to sawdust mass ratios were manufactured to fit tightly. Flowrate and microbiological removal efficacy (logarithmic reduction value (LRV)) were determined over the testing period at various pressures. Flowrate values ranged from 2.44 to 9.04 L per hour, significantly higher than traditional CPF technology. LRVs ranged from 1.1 to 2.0, lower than traditional CPF technology but still effective at removing most Escherichia coli and total coliform bacteria. Filters proved effective at removing total and fecal coliforms at pressures less than 70 kilopascals. The optimum filter had a thickness of 3.2 cm and clay to sawdust ratio of 6:1 by mass. Filters proved to be ineffective if flowrates were above 5 L/h.


2011 ◽  
Vol 14 (01) ◽  
pp. 120-128 ◽  
Author(s):  
Guanglun Lei ◽  
Lingling Li ◽  
Hisham A. Nasr-El-Din

Summary A common problem for oil production is excessive water production, which can lead to rapid productivity decline and significant increases in operating costs. The result is often a premature shut-in of wells because production has become uneconomical. In water injectors, the injection profiles are uneven and, as a result, large amounts of oil are left behind the water front. Many chemical systems have been used to control water production and improve recovery from reservoirs with high water cut. Inorganic gels have low viscosity and can be pumped using typical field mixing and injection equipment. Polymer or crosslinked gels, especially polyacrylamide-based systems, are mainly used because of their relatively low cost and their supposed selectivity. In this paper, microspheres (5–30 μm) were synthesized using acrylamide monomers crosslinked with an organic crosslinker. They can be suspended in water and can be pumped in sandstone formations. They can plug some of the pore throats and, thus, force injected water to change its direction and increase the sweep efficiency. A high-pressure/high-temperature (HP/HT) rheometer was used to measure G (elastic modulus) and G" (viscous modulus) of these aggregates. Experimental results indicate that these microspheres are stable in solutions with 20,000 ppm NaCl at 175°F. They can expand up to five times their original size in deionized water and show good elasticity. The results of sandpack tests show that the microspheres can flow through cores with permeability greater than 500 md and can increase the resistance factor by eight to 25 times and the residual resistance factor by nine times. The addition of microspheres to polymer solutions increased the resistance factor beyond that obtained with the polymer solution alone. Field data using microspheres showed significant improvements in the injection profile and enhancements in oil production.


2020 ◽  
Vol 8 (43) ◽  
pp. 22728-22735
Author(s):  
Xu Ma ◽  
Zheng Deng ◽  
Zhuoyi Li ◽  
Danke Chen ◽  
Xinyi Wan ◽  
...  

A Fenton active Zr–Fc MOF-based membrane was designed for efficiently producing clean water from VOC contaminated water via the solar evaporation process.


2020 ◽  
Vol 3 (1) ◽  
Author(s):  
Katarzyna Janowska ◽  
Vittorio Boffa ◽  
Mads Koustrup Jørgensen ◽  
Cejna Anna Quist-Jensen ◽  
Fabien Hubac ◽  
...  

2020 ◽  
Vol 7 (5) ◽  
pp. 1902236 ◽  
Author(s):  
Zhongjian Xie ◽  
Yanhong Duo ◽  
Zhitao Lin ◽  
Taojian Fan ◽  
Chenyang Xing ◽  
...  
Keyword(s):  

Author(s):  
Pedro Cisterna-Osorio ◽  
Sergio Quijada-Vera ◽  
Daniela Ruiz-Duran ◽  
Rodrigo Peirano-Cuevas ◽  
Pamela Ortiz-Briones

Climate change is having drastic consequences in Chile. The lack of water in various regions is causing environmental impacts on ecosystems, including the decrease in the productive activities of rural economies and the deterioration in the quality of life of the inhabitants that occupy the affected physical spaces. In this paper, we propose a sustainable, low-cost treatment of wastewater and its reuse as an adaptation and mitigation policy, patented in 2019, that consists of a wastewater disinfection system based on solar energy. This system can work in both continuous and discontinuous modes. The water passes through a canal of reflective material in the continuous regime, and in the batch regime, the water remains in the canal. The panels are located parallel to the lateral faces of the canal. These panels concentrate the radiation in the canal through reflection. The trapezoidal geometry of the disinfectant canal deflects the radiation and reflects in the direction of the front walls of the canal, radiating what is returned and vice versa. The fraction of the radiation reflected outside the canal reaches the reflective side panels that return the radiation to the canal. The synergy of these three considerations increases the radiation in the canal area, augmenting the elimination of the bacterial load. In the trapezoidal reflective canal without panels, only 5% of the measured radiation exceeded the atmospheric radiation, eliminating 83% of the coliforms. The incorporation of panels surpassed the atmospheric radiation over 36% of the measured radiations, and the removal of coliforms exceeded 99.7%.


Sign in / Sign up

Export Citation Format

Share Document