Beyond conventional capacity design

2010 ◽  
pp. 213-220 ◽  
Author(s):  
I Anastasopoulos
Keyword(s):  
Capacity Design

Study on Power Fluctuation Dispatch and Capacity Design of Short Period Power Fluctuation Compensation System in Consideration of Power Loss

2014 ◽  
Vol 134 (1) ◽  
pp. 57-63
Author(s):  
Akihiro Teguri ◽  
Shunsuke Kawachi ◽  
Jumpei Baba ◽  
Eisuke Shimoda ◽  
Takayuki Sugimoto
Keyword(s):  
Power Loss ◽  
Compensation System ◽  
Capacity Design ◽  
Power Fluctuation ◽  
Short Period

Influence of Massive Substructures on Capacity Design Method

2016 ◽  
Vol 106 (10) ◽  
pp. 357-362
Author(s):  
Yudong MAO ◽  
Jianzhong LI
Keyword(s):  
Design Method ◽  
Capacity Design

scholarly journals Analytical Investigation of Tension Loaded Deformed Rebar Anchors in Concrete

CivilEng ◽  
2021 ◽  
Vol 2 (2) ◽  
pp. 442-458
Author(s):  
Sandip Chhetri ◽  
Rachel A. Chicchi
Keyword(s):  
Test Data ◽  
Parametric Study ◽  
Failure Modes ◽  
Experimental Testing ◽  
Analytical Investigation ◽  
Failure Behavior ◽  
Capacity Design ◽  
Simulation Results

Experimental testing of deformed rebar anchors (DRAs) has not been performed extensively, so there is limited test data to understand their failure behavior. This study aims to expand upon these limited tests and understand the behavior of these anchors, when loaded in tension. Analytical benchmark models were created using available test data and a parametric study of deformed rebar anchors was performed. Anchor diameter, spacing, embedment, and number of anchors were varied for a total of 49 concrete breakout simulations. The different failure modes of anchors were predicted analytically, which showed that concrete breakout failure is prominent in the DRA groups. The predicted concrete breakout values were consistent with mean and 5% fractile concrete capacities determined from the ACI concrete capacity design (CCD) method. The 5% fractile factor determined empirically from the simulation results was kc = 26. This value corresponds closely with kc = 24 specified in ACI 318-19 and ACI 349-13 for cast-in place anchors. The analysis results show that the ACI CCD formula can be conservatively used to design DRAs loaded in tension by applying a kc factor no greater than 26.

Capacity Design and Service Quality Control in a Queuing System

1977 ◽  
Vol 25 (4) ◽  
pp. 651-661 ◽  
Author(s):  
S. D. Deshmukh ◽  
Suresh Jain
Keyword(s):  
Quality Control ◽  
Service Quality ◽  
Queuing System ◽  
Capacity Design

Capacity design: Early history

2018 ◽  
Vol 47 (14) ◽  
pp. 2887-2896 ◽  
Author(s):  
Michael N. Fardis
Keyword(s):  
Early History ◽  
Capacity Design
Sign in / Sign up

Export Citation Format

Share Document