Despite significant advances in marine streamer design, seismic data are often plagued by coherent noise having approximately linear moveout across stacked sections. With an understanding of the characteristics that distinguish such noise from signal, we can decide which noise‐suppression techniques to use and at what stages to apply them in acquisition and processing. Three general mechanisms that might produce such noise patterns on stacked sections are examined: direct and trapped waves that propagate outward from the seismic source, cable motion caused by the tugging action of the boat and tail buoy, and scattered energy from irregularities in the water bottom and sub‐bottom. Depending upon the mechanism, entirely different noise patterns can be observed on shot profiles and common‐midpoint (CMP) gathers; these patterns can be diagnostic of the dominant mechanism in a given set of data. Field data from Canada and Alaska suggest that the dominant noise is from waves scattered within the shallow sub‐buttom. This type of noise, while not obvious on the shot records, is actually enhanced by CMP stacking. Moreover, this noise is not confined to marine data; it can be as strong as surface wave noise on stacked land seismic data as well. Of the many processing tools available, moveout filtering is best for suppressing the noise while preserving signal. Since the scattered noise does not exhibit a linear moveout pattern on CMP‐sorted gathers, moveout filtering must be applied either to traces within shot records and common‐receiver gathers or to stacked traces. Our data example demonstrates that although it is more costly, moveout filtering of the unstacked data is particularly effective because it conditions the data for the critical data‐dependent processing steps of predictive deconvolution and velocity analysis.
Dynamic Speckle Illumination Digital Holographic Microscopy by Doubly Scattered System