scholarly journals IAPSO Standard Seawater: Definition of the Uncertainty in the Calibration Procedure, and Stability of Recent Batches

2007 ◽  
Vol 24 (10) ◽  
pp. 1785-1799 ◽  
Author(s):  
Sheldon Bacon ◽  
Fred Culkin ◽  
Nigel Higgs ◽  
Paul Ridout
Keyword(s):  
Reference Material ◽  
Potassium Chloride ◽  
Manufacturing Process ◽  
Calibration Procedure ◽  
Conductivity Ratio ◽  
Coverage Factor ◽  
Expanded Uncertainty ◽  
Significant Variability ◽  
Definition Of

Abstract Standard seawater (SSW) has been employed by oceanographers as a reference material in the determination of salinity for over a century. In all that time, this is the first study to determine the uncertainty of the SSW manufacturing process. SSW is calibrated in reference to carefully prepared solutions of potassium chloride (KCl). All uncertainties in the preparation and measurement of KCl solutions and of new SSW are calculated. The expanded uncertainty of the SSW conductivity ratio is found to be 1 × 10−5, based on a coverage factor of 2, at the time of manufacture. There is no discernible “within batch” variability. No significant variability of quality within or between batches of KCl is found. Measurement of SSW “offsets” from the label conductivity ratio as long as 5 yr after the SSW batch manufacture are reported, and no significant change in label conductivity ratio for SSW batches P130 through P144 outside the expanded uncertainty of 1 × 10−5 is found. This last result is in contrast to some other studies, and herein are suggestions as to why this may be the case.

The Determination of the Efficiency of Energy Dispersive X-Ray Spectrometers by a New Reference Material

2006 ◽  
Vol 12 (5) ◽  
pp. 406-415 ◽  
Author(s):  
Marco Alvisi ◽  
Markus Blome ◽  
Michael Griepentrog ◽  
Vasile-Dan Hodoroaba ◽  
Peter Karduck ◽  
...  
Keyword(s):  
Reference Material ◽  
Electron Probe ◽  
Detection Efficiency ◽  
Calibration Procedure ◽  
Energy Dispersive ◽  
X Ray ◽  
Line Intensities ◽  
Operator Assistance ◽  
Scanning Electron

A calibration procedure for the detection efficiency of energy dispersive X-ray spectrometers (EDS) used in combination with scanning electron microscopy (SEM) for standardless electron probe microanalysis (EPMA) is presented. The procedure is based on the comparison of X-ray spectra from a reference material (RM) measured with the EDS to be calibrated and a reference EDS. The RM is certified by the line intensities in the X-ray spectrum recorded with a reference EDS and by its composition. The calibration of the reference EDS is performed using synchrotron radiation at the radiometry laboratory of the Physikalisch-Technische Bundesanstalt. Measurement of RM spectra and comparison of the specified line intensities enables a rapid efficiency calibration on most SEMs. The article reports on studies to prepare such a RM and on EDS calibration and proposes a methodology that could be implemented in current spectrometer software to enable the calibration with a minimum of operator assistance.

scholarly journals Reference materials for optic nanosensor systems: reduced glutathione and chloramphenicol

2021 ◽  
Vol 17 (1) ◽  
pp. 59-69
Author(s):  
A. A. Yushina ◽  
M. K. Alenichev
Keyword(s):  
Light Scattering ◽  
Reference Material ◽  
Dynamic Light Scattering ◽  
Reference Materials ◽  
Reduced Glutathione ◽  
Point Of Care ◽  
Sampling Site ◽  
Coverage Factor ◽  
Expanded Uncertainty ◽  
Certified Value

The research provides enterprise reference material (ERM) development approach for nanosensor system on the basis of dynamic light scattering and fluorescence for qualitative and quantitative determination of nutrition pollutant - chloramphenicol antibiotic (laevomycetin), as well as marker of ischaemic stroke and a number of other diseases - reduced glutathione.ERM candidate materials were chosen chloramphenicol and reduced glutathione. The attestation procedure based on calculating-experimental approach by preparation procedure was used to determine the certified value of ERM. During the tests there were determined metrological characteristics of reference material. The certified value of ERM for reduced glutathione mass fraction is 98,5 %, the expanded uncertainty of certified value with coverage factor k=2 is ± 0,3 %. The certified value of ERM for chloramphenicol mass concentration is 10,0 g/dm3, the expanded uncertainty of certified value with coverage factor k = 2 is ± 4,0 %.The implementation of the developed ERMs showed their appropriateness for optic nanosensor systems calibration on the base of dynamic light scattering and fluorescence.We suppose that the developed enterprise reference materials further may be certified as CRM (certified reference material) and used for verification, calibration and graduation of compact detection devices of the «point of care diagnostics» type under development, which are intended for express analysis on the sampling site directly.

Determination of the Total Ginsenosides in Ginseng Using the UV Spectrophotometer and Evaluation of the Measurement Uncertainty

2012 ◽  
Vol 490-495 ◽  
pp. 1290-1295
Author(s):  
Min Zhang ◽  
Yu Xia Jane Qin ◽  
Dan Chen ◽  
Ping Yang
Keyword(s):  
Measurement Uncertainty ◽  
Linear Equation ◽  
Linear Relation ◽  
Theoretical Basis ◽  
Coverage Factor ◽  
Expanded Uncertainty ◽  
High Quality ◽  
Good Linear ◽  
Coefficient Corrélation

Using the Ultraviolet Visible Spectroscopical Photometry method, the Ginsenosides content was detected, and evaluated the measuring uncertainty of the Ginsenosides content, analyzed the main source of the uncertainty components, finally evaluated and calculated the uncertainty components. The results showed that, when the Ginsenosides content is in the range of 20-120g, there is a good linear relation, and the linear equation is A=0.0216+0.00556C, r=0.9961 (coefficient correlation). For example, when the content of Ginsenosides is 4.60%, the expanded uncertainty of Ginsenosides measurement is U=0.408%, the coverage factor is 2 (k=2). This study provides a reliable theoretical basis for an effective and high quality method of Ginsenosides content measurement

Development of a method for multielemental determination in water by EDXRF with radioisotopic source of 238Pu.

2019 ◽  
Vol 7 (2A) ◽  
Author(s):  
Camilo Fuentes Serrano ◽  
Juan Reinaldo Estevez Alvares ◽  
Alfredo Montero Alvarez ◽  
Ivan Pupo Gonzales ◽  
Zahily Herrero Fernandez ◽  
...  
Keyword(s):  
Thin Layer ◽  
Expanded Uncertainty ◽  
Considerable Decrease ◽  
X Ray ◽  
Precipitation Efficiency ◽  
Method Of Determination ◽  
Sensitivity Curves ◽  
Order Of Magnitude ◽  
Metrological Parameters

A method for determination of Cr, Fe, Co, Ni, Cu, Zn, Hg and Pb in waters by Energy Dispersive X Ray Fluorescence (EDXRF) was implemented, using a radioisotopic source of 238Pu. For previous concentration was employed a procedure including a coprecipitation step with ammonium pyrrolidinedithiocarbamate (APDC) as quelant agent, the separation of the phases by filtration, the measurement of filter by EDXRF and quantification by a thin layer absolute method. Sensitivity curves for K and L lines were obtained respectively. The sensitivity for most elements was greater by an order of magnitude in the case of measurement with a source of 238Pu instead of 109Cd, which means a considerable decrease in measurement times. The influence of the concentration in the precipitation efficiency was evaluated for each element. In all cases the recoveries are close to 100%, for this reason it can be affirmed that the method of determination of the studied elements is quantitative. Metrological parameters of the method such as trueness, precision, detection limit and uncertainty were calculated. A procedure to calculate the uncertainty of the method was elaborated; the most significant source of uncertainty for the thin layer EDXRF method is associated with the determination of instrumental sensitivities. The error associated with the determination, expressed as expanded uncertainty (in %), varied from 15.4% for low element concentrations (2.5-5 μg/L) to 5.4% for the higher concentration range (20-25 μg/L).

State Failure and the Political Violence Phenomenon: A Comparative Analysis of Iraq and Syria Cases

2016 ◽  
Vol 4 (2) ◽  
pp. 170 ◽  
Author(s):  
K. Eylem Özkaya Lassalle
Keyword(s):  
Cold War ◽  
Political Violence ◽  
State Failure ◽  
The Political ◽  
Collective Violence ◽  
Short Run ◽  
Definition Of ◽  
The Cold War

The concept of failed state came to the fore with the end of the Cold War, the collapse of the USSR and the disintegration of Yugoslavia. Political violence is central in these discussions on the definition of the concept or the determination of its dimensions (indicators). Specifically, the level of political violence, the type of political violence and intensity of political violence has been broached in the literature. An effective classification of political violence can lead us to a better understanding of state failure phenomenon. By using Tilly’s classification of collective violence which is based on extent of coordination among violent actors and salience of short-run damage, the role played by political violence in state failure can be understood clearly. In order to do this, two recent cases, Iraq and Syria will be examined.

DEFINITION OF TIME SPENT ON REPAIR OF BUS TRANSMISSION UNITS TAKING INTO ACCOUNT TECHNOLOGICAL EQUIPMENT RELIABILITY

2020 ◽  
Vol 2020 (9) ◽  
pp. 29-33
Author(s):  
Sergey Bulatov
Keyword(s):  
Negative Impact ◽  
Probabilistic Method ◽  
Technological Equipment ◽  
Quality And Safety ◽  
Transmission Unit ◽  
Equipment Reliability ◽  
Hours Of Work ◽  
Definition Of ◽  
Time Decrease

The paper purpose is the effectiveness estimation in the technological equipment use, taking into account its reliability and productivity for defective transmission units of buses. The problem consists in the determination of time to be spent on repair of bus transmission units taking into account technological equipment reliability. In the paper there is used a probabilistic method for the prediction bus transmission units, and also a method of the dynamics of averages which allow ensuring minimum of costs for units downtime during repair and equipment cost. The need for repair of transmission units (gear box) arises on an average after 650 hours, the average productivity of the bench makes 4.2 bus / hour. The bench fails on the average after 4600 hours of work, the average time of the bench makes 2 hours. In such a way the solution of the problem specified allows analyzing the necessity of time decrease for transmission unit repair to avoid long downtimes of buses in repair areas without negative impact upon high repair quality and safety during the further operation.

Tests of jackhammers (formation of bench techniques)

2020 ◽  
pp. 28-32
Author(s):  
V.S. Vanaev
Keyword(s):  
Impact Energy ◽  
Bench Tests ◽  
Measuring Complex ◽  
Energy Indicators ◽  
Definition Of ◽  
Determination Of Parameters ◽  
Dynamic Indicators

Development of complex determination of parameters of jackhammers at bench tests is studied. The modern support of tests of jackhammers for the purpose of definition of their energy, vibration and noise indicators is considered. Descriptions of the SORP universal bench and UIPU measuring complex are given. Keywords jackhammer, bench, tests, processing object, energy indicators, impact energy, dynamic indicators [email protected]

Actual issues of valuation of businesses of the economic entity

2017 ◽  
Vol 31 (2) ◽  
pp. 156-162 ◽  
Author(s):  
O. V. Schneider
Keyword(s):  
Discount Rate ◽  
Accurate Prediction ◽  
Economic Activities ◽  
Business Valuation ◽  
Economic Entity ◽  
The World ◽  
Definition Of

The article summarizes the main approaches in the definition of business valuation the economic entity. In the process of business valuation, taking into account the risks of financial and economic activities necessary to obtain information on what stage the owner implements the business will receive income. The most difficult task is the impossibility of accurate prediction in determining the level of income and the determination of a discount rate capitalization of future incomes due to the instability of the economy, both in the country and around the world.

Development and Certification of Formononetin Reference Material for Quality Control of Functional Foods and Botanical Supplements

2019 ◽  
Vol 15 (5) ◽  
pp. 553-559
Author(s):  
Ningbo Gong ◽  
Baoxi Zhang ◽  
Kun Hu ◽  
Zhaolin Gao ◽  
Guanhua Du ◽  
...  
Keyword(s):  
Quality Control ◽  
Reference Material ◽  
Functional Foods ◽  
Certified Reference Materials ◽  
Coulometric Titration ◽  
Pharmaceutical Formulations ◽  
Uncertainty Estimation ◽  
Expanded Uncertainty ◽  
Scanning Calorimetry ◽  
Botanical Supplements

Background: Formononetin is a common soy isoflavonoid that can be found abundantly in many natural plants. Previous studies have shown that formononetin possesses a variety of activities which can be applied for various medicinal purposes. Certified Reference Materials (CRMs) play a fundamental role in the food, traditional medicine and dietary supplement fields, and can be used for method validation, uncertainty estimation, as well as quality control. Methods: The purity of formononetin was determined by Differential Scanning Calorimetry (DSC), Coulometric Titration (CT) and Mass Balance (MB) methods. Results: This paper reports the sample preparation methodology, homogeneity and stability studies, value assignment, and uncertainty estimation of a new certified reference material of formononetin. DSC, CT and MB methods proved to be sufficiently reliable and accurate for the certification purpose. The purity of the formononetin CRM was therefore found to be 99.40% ± 0.24 % (k = 2) based on the combined value assignments and the expanded uncertainty. Conclusion: This CRM will be a reliable standard for the validation of the analytical methods and for quality assurance/quality control of formononetin and formononetin-related traditional herbs, food products, dietary supplements and pharmaceutical formulations.

Sign in / Sign up

Export Citation Format

Share Document