scholarly journals Effect of Anolyte pH on the Performance of a Dual-Chambered Microbial Fuel Cell Operated with Different Biomass Feed

2021 ◽  
Vol 2021 ◽  
pp. 1-8
Author(s):  
Md. Abdul Halim ◽  
Md. Owaleur Rahman ◽  
Mohammad Ibrahim ◽  
Rituparna Kundu ◽  
Biplob Kumar Biswas
Keyword(s):  
Wastewater Treatment ◽  
Fuel Cell ◽  
River Water ◽  
Microbial Fuel Cell ◽  
Alternative Energy ◽  
Coulombic Efficiency ◽  
Oxygen Demand ◽  
Cod Removal ◽  
Bioelectricity Generation ◽  
Alternative Energy Resources

Finding sustainable alternative energy resources and treating wastewater are the two most important issues that need to be solved. Microbial fuel cell (MFC) technology has demonstrated a tremendous potential in bioelectricity generation with wastewater treatment. Since wastewater can be used as a source of electrolyte for the MFC, the salient point of this study was to investigate the effect of pH on bioelectricity production using various biomass feed (wastewater and river water) as the anolyte in a dual-chambered MFC. Maximum extents of power density (1459.02 mW·m−2), current density (1288.9 mA·m−2), and voltage (1132 mV) were obtained at pH 8 by using Bhairab river water as a feedstock in the MFC. A substantial extent of chemical oxygen demand (COD) removal (94%) as well as coulombic efficiency (41.7%) was also achieved in the same chamber at pH 8. The overall performance of the MFC, in terms of bioelectricity generation, COD removal, and coulombic efficiency, indicates a plausible utilization of the MFC for wastewater treatment as well as bioelectricity production.

scholarly journals Enhancing microbial fuel cell (MFC) performance in treatment of solid potato waste by mixed feeding of boiled potato and waste activated sludge

2018 ◽  
Vol 78 (5) ◽  
pp. 1054-1063
Author(s):  
Haixia Du ◽  
Jiangyang Guo ◽  
Yizhen Xu ◽  
Yanxia Wu ◽  
Fusheng Li ◽  
...  
Keyword(s):  
Fuel Cell ◽  
Activated Sludge ◽  
Microbial Fuel Cell ◽  
Coulombic Efficiency ◽  
Oxygen Demand ◽  
Cod Removal ◽  
Hydrolysis Rate ◽  
Waste Activated Sludge ◽  
Mixed Feeding ◽  
Potato Waste

Abstract The effects of mixed feeding of boiled potato and waste activated sludge (WAS) on the performance of a microbial fuel cell (MFC) in treating solid potato waste were investigated. The coulombic efficiency (CE) of four MFCs fed with potato cubes containing 0, 48.7, 67.3 and 85.6% of boiled potato was 53.5, 70.5, 92.7 and 71.1%, respectively, indicating enhanced electricity generation and the existence of an optimum mixing ratio. The hydrolysis rate estimated using a first-order sequential hydrolysis model increased from 0.061 to 0.191 day−1, leading to shortening of the startup time for current density reaching its maximum from 25 to 5 days. The final chemical oxygen demand (COD) removal reached 85%. The CE of seven MFCs, fed with raw potato alone, sterilized/unsterilized WAS alone, and four mixed samples of raw potato with sterilized WAS at ratios of 2:1 and 4:1 and unsterilized WAS at 2:1 and 4:1, was found to be 6.1, 43.6, 0.3, 31.0, 16.5, 0.9 and 31.1%, respectively. The hydrolysis rate increased from 0.056 to 0.089 day−1, and the final COD removal changed from 39.5 to 89.6% following the order: potato alone > mixture of potato & WAS > sterilized WAS alone > unsterilized WAS alone.

scholarly journals Energy capture and nutrients removal enhancement through a stacked constructed wetland incorporated with microbial fuel cell

2017 ◽  
Vol 76 (1) ◽  
pp. 28-34 ◽  
Author(s):  
Lei Xu ◽  
Yaqian Zhao ◽  
Tongyue Wang ◽  
Ranbin Liu ◽  
Fei Gao
Keyword(s):  
Fuel Cell ◽  
Microbial Fuel Cell ◽  
Removal Efficiency ◽  
Oxygen Demand ◽  
Open Circuit ◽  
Cod Removal ◽  
Electrical Performance ◽  
Electricity Production ◽  
Performance Reduction ◽  
Tiered System

To improve the sustainability of constructed wetlands (CWs), a novel tiered wetland system integrated with a microbial fuel cell (MFC) was developed in this study. Compared to the single stage CW, chemical oxygen demand (COD) removal efficiency was improved from 83.2% to 88.7%. More significantly, this tiered system significantly enhanced total nitrogen removal efficiency (an increase from 53.1% to 75.4%). In terms of MFC integration, a gradually decreased performance in electricity production was observed during its 3 months of operation (the voltage dropped from nearly 600 mV to less than 300 mV), which resulted in a reduction of power density from around 2 W/m3 to less than 0.5 W/m3. The deterioration in performance of the air-cathode is the main reason behind this, since the electrode potential of the cathode under open circuit reduced from 348.5 mV to 49.5 mV while the anode potential kept constant at around −400 mV. However, in spite of its electrical performance reduction, it was proved that MFC integration enhanced COD removal and the nitrification process. Further work is needed to improve the stability and feasibility of this new system.

scholarly journals Wastewater Treatment and Electricity Production in a Microbial Fuel Cell with Cu–B Alloy as the Cathode Catalyst

Catalysts ◽  
2019 ◽  
Vol 9 (7) ◽  
pp. 572 ◽  
Author(s):  
Paweł P. Włodarczyk ◽  
Barbara Włodarczyk
Keyword(s):  
Wastewater Treatment ◽  
Fuel Cell ◽  
Microbial Fuel Cell ◽  
Microbial Fuel Cells ◽  
Oxygen Demand ◽  
Electricity Production ◽  
Cathode Catalyst ◽  
Similar Reduction ◽  
Fuel Cell Operation

The possibility of wastewater treatment and electricity production using a microbial fuel cell with Cu–B alloy as the cathode catalyst is presented in this paper. Our research covered the catalyst preparation; measurements of the electroless potential of electrodes with the Cu–B catalyst, measurements of the influence of anodic charge on the catalytic activity of the Cu–B alloy, electricity production in a microbial fuel cell (with a Cu–B cathode), and a comparison of changes in the concentration of chemical oxygen demand (COD), NH4+, and NO3– in three reactors: one excluding aeration, one with aeration, and during microbial fuel cell operation (with a Cu–B cathode). During the experiments, electricity production equal to 0.21–0.35 mA·cm−2 was obtained. The use of a microbial fuel cell (MFC) with Cu–B offers a similar reduction time for COD to that resulting from the application of aeration. The measured reduction of NH4+ was unchanged when compared with cases employing MFCs, and it was found that effectiveness of about 90% can be achieved for NO3– reduction. From the results of this study, we conclude that Cu–B can be employed to play the role of a cathode catalyst in applications of microbial fuel cells employed for wastewater treatment and the production of electricity.

scholarly journals Bioelectricity generation from air-cathode microbial fuel cell connected to constructed wetland

2018 ◽  
Vol 78 (9) ◽  
pp. 1990-1996 ◽  
Author(s):  
Dengming Yan ◽  
Xinshan Song ◽  
Baisha Weng ◽  
Zhilei Yu ◽  
Wuxia Bi ◽  
...  
Keyword(s):  
Fuel Cell ◽  
Microbial Fuel Cell ◽  
Constructed Wetland ◽  
Oxygen Demand ◽  
Pollutant Removal ◽  
Fed Batch ◽  
Air Cathode ◽  
Batch Mode ◽  
Bioelectricity Generation ◽  
N Removal

Abstract The aim of this study was to investigate the different performance of bioelectricity generation and wastewater treatment between constructed wetland (CW) respectively coupled with air-cathode microbial fuel cell (ACMFC) and microbial fuel cell (MFC) under a fed-batch mode. During a 75-day-operation, the voltage of CW-ACMFC and CW-MFC ranged from 0.36 to 0.52 V and from −0.04 to 0.07 V, indicating that the bioenergy output of CW-ACMFC was significantly higher than that of CW-MFC system. In addition, the maximum of power density of CW-ACMFC and CW-MFC was 4.21 and 0.005 mW m−2. Notably, the chemical oxygen demand (COD) and NH3-N removal efficiency of CW-ACMFC was slightly higher than that in CW-MFC, which resulted from a higher voltage accelerating the transport of electron donors and the growth of microorganisms and plants. This study possesses a probability of using ACMFC coupled with CW to enhance the pollutant removal performance in CW system.

Sign in / Sign up

Export Citation Format

Share Document