scholarly journals Influence of Nanolime and Curing Period on Unconfined Compressive Strength of Soil

2017 ◽  
Vol 2017 ◽  
pp. 1-9 ◽  
Author(s):  
Panbarasi Govindasamy ◽  
Mohd Raihan Taha ◽  
Jamal Alsharef ◽  
Kowstubaa Ramalingam
Keyword(s):  
Compressive Strength ◽  
Moisture Content ◽  
Unconfined Compressive Strength ◽  
Curing Time ◽  
Strength Gain ◽  
Treated Soil ◽  
Soil Particles ◽  
Curing Period

This paper presents the improvement of the unconfined compressive strength (UCS) of soil by mixing different percentages of nanolime and 5% lime with soil. The UCS of treated soil increased significantly over curing time with increasing percentage of nanolime. The optimum results were reached at only 0.5% nanolime admixtures which were much higher than 5% lime admixture. This may be due to higher ability of nanolime to flocculate and agglomerate the soil particles compared with the lime. In addition, the lime could fill only the micropores while nanolime could fill the micro- and nanopores as well. The strength gain is inversely proportional to the remolded moisture content and curing period. However, when the content of nanolime used is larger than 0.5%, nanolime particles are not uniformly dispersed. Therefore, a weak area in the form of voids is created, consequently the homogeneous hydrated microstructure cannot be formed, and finally the strength will decrease.

A Study of Soil Stabilization by Hydrated Lime at Kampung Kedaik Asal, Rompin, Pahang, Malaysia

2014 ◽  
Vol 695 ◽  
pp. 738-741
Author(s):  
Azhani Zukri ◽  
Nadiatul Adilah Ahmad Abdul Ghani
Keyword(s):  
Compressive Strength ◽  
Moisture Content ◽  
Unconfined Compressive Strength ◽  
Soil Stabilization ◽  
Optimum Moisture Content ◽  
Natural State ◽  
Dry Density ◽  
Maximum Dry Density ◽  
Lime Content ◽  
Curing Period

This study involves the clay sample which is taken from Kampung Kedaik Asal, Rompin site and evaluation of its properties in natural state and after stabilization. The main objectives of this paper is to estimate the optimum lime content (OLC) needed to stabilize the soil by using Eades-Grim pH Test, to determine the optimum moisture content (OMC) and maximum dry density (MDD) of the treated soil by Standard Proctor Test and also the strength value of the soil specimens with different percentages of lime content corresponding with different curing period by Unconfined Compressive Strength (UCS) Test. From this study, the optimum amount to stabilize the clay soil and minimum amount of lime required to stabilize the soil pH level to 12 is 5%. The results showed that addition of lime decreased the maximum dry density (MDD) and increased the optimum moisture content (OMC). Unconfined compressive test on 48 sets of samples has been carried out for 7, 14 and 28 days of curing with different lime contents such as 5%, 7% and 9%. The highest unconfined compressive strength (UCS) achieved is 321 kN/m2 for clay stabilized with 9% lime content cured at 28 days. From the test results, it was found that the longer the immersion of curing period with higher lime content, the greater the compressive strength of the specimen.

Experimental study on strength of cement stabilized clay

2005 ◽  
Vol 3 (2) ◽  
pp. 116-126 ◽  
Author(s):  
Woo‐Sik Kim ◽  
Nguyen Minh Tam ◽  
Du‐Hwoe Jung
Keyword(s):  
Compressive Strength ◽  
Soil Type ◽  
Unconfined Compressive Strength ◽  
Weight Ratio ◽  
Dry Weight ◽  
Strength Characteristics ◽  
Curing Time ◽  
Compression Tests ◽  
Soil Cement ◽  
Mixing Method

This paper describes the effect of factors on the strength characteristics of cement treated clay from laboratory tests performed on cement mixed clay specimens. It is considered that several factors such as soil type, sample preparing method, quantity of binder, curing time, etc. can have an effect on strength characteristics of cement stabilized clay. A series of unconfined compression tests have been performed on samples prepared with different conditions. The results indicated that soil type, mixing method, curing time, dry weight ratio of cement to clay (Aw), and water‐clay to cement (wc/c) ratio were main factors which can have an influence on unconfined compressive strength, modulus of elasticity, and failure strain of cement stabilized clay. Unconfined compressive strength of soil‐cement samples prepared from dry mixing method was higher than those prepared from wet mixing method.

scholarly journals EFFECT OF LOADING CONDITION DURING CURING PERIOD ON UNCONFINED COMPRESSIVE STRENGTH OF CEMENT STABILIZED SOIL

2005 ◽  
pp. 211-216 ◽  
Author(s):  
Motoyuki SUZUKI ◽  
Takeshi TAGUCHI ◽  
Tetsuo FUJIMOTO ◽  
Yoko KAWAHARA ◽  
Tetsuro YAMAMOTO ◽  
...  
Keyword(s):  
Compressive Strength ◽  
Unconfined Compressive Strength ◽  
Loading Condition ◽  
Curing Period ◽  
Stabilized Soil

Correlation of Unconfined Compressive Strength and California Bearing Ratio in Laterite Soil Stabilization Using Varied Zeolite Content Activated by Waterglass

2020 ◽  
Vol 998 ◽  
pp. 323-328
Author(s):  
Achmad Bakri Muhiddin ◽  
Marthen M. Tangkeallo
Keyword(s):  
Compressive Strength ◽  
Unconfined Compressive Strength ◽  
Soil Stabilization ◽  
Dry Weight ◽  
Engineering Properties ◽  
High Plasticity ◽  
Curing Time ◽  
Laterite Soil ◽  
Zeolite Content ◽  
Meta Silicate

In remote areas, most roads still use pavements that are very sensitive to climate change, especially those using clay pavements with high plasticity. In addition to the issue of cost, the difficulty of obtaining a proper source of material is another problem that has led to soaring prices for materials. In this regard, a study was conducted using local materials, namely zeolite as a stabilizing material added with waterglass as activating agent. The research began with samples of laterite soil and natural zeolite for XRD test (microstructure testing), and then testing for laterite soil’s index properties and engineering properties, namely Unconfined Compressive Strength and CBR value. The purpose of the test is to determine the correlation between the Unconfined Compressive Strength (UCS) and the soil bearing capacity (CBR) caused by adding zeolite as stabilizer material and waterglass as activator with increasing curing time. Laterite soils contain a brownish red iron oxide. The stabilizing material zeolite contains a crystalline mineral of alumina silicate SiO2. While waterglass composed of sodium meta silicate. Stabilization carried out by mixing 4%, 8%, 12%, 16%, and 20% of zeolite with addition of 2% waterglass, percentage was measured based on soil dry weight. Specimens were tested at curing time of 0, 7, 14, and 28 days. The test result shows increasing UCS and CBR values with increasing percentage of zeolite. At mix of 20% zeolite and 2% waterglass, the unconfined compressive strength reaches 23.54 kg/cm2 with CBR value 58% at 28 days of curing time.

Correlation between Unconfined Compressive Strength and Penetration Index Obtained from DCP Tests for Cemented Lateritic Soils

2019 ◽  
Vol 814 ◽  
pp. 399-403
Author(s):  
Anuchit Uchaipichat
Keyword(s):  
Compressive Strength ◽  
Unconfined Compressive Strength ◽  
Cement Content ◽  
Lateritic Soil ◽  
Test Results ◽  
Cone Penetration ◽  
Penetration Index ◽  
Curing Period ◽  
Cemented Soils ◽  
The Relationship

This paper presents the relationship between the dynamic cone penetration (DCP) test results and the unconfined compressive strength of lateritic cemented soils. A series of DCP tests and unconfined compressive strength was performed on lateritic cemented soil. The soils sample used in this study was lateritic soil. The test results for the DCP tests are presented in terms of penetration index. It can be observed that the penetration index decreased with increasing curing period and cement content. Moreover, the unconfined compressive strength of cemented soils increased with curing period and cement content. The relationship between unconfined compressive strength and penetration index is presented. A unique relationship for unconfined compressive strength can be obtained.

Study of Correlation on Unconfined Compressive Strength between Different Soil

2013 ◽  
Vol 838-841 ◽  
pp. 926-929
Author(s):  
Xia Zhao
Keyword(s):  
Compressive Strength ◽  
Soil Moisture ◽  
Moisture Content ◽  
Unconfined Compressive Strength ◽  
Laboratory Tests ◽  
Soil Moisture Content ◽  
Correlation Coefficients ◽  
Friction Angle ◽  
Silty Clay ◽  
Soil Cohesion

Take the silty clay and clay as the research object, the correlation between bulk density, moisture content, cohesion, friction angle and unconfined compressive strength was analyzed using laboratory tests, and the results showed that soil cohesion, friction angle and unconfined compressive strength with good correlation, the correlation coefficients were all above 0.9, while severe and soil moisture content and unconfined compressive strength of correlation is weak, followed by the correlation formulas of the index and unconfined compressive strength were established, these formulas can used to predict the unconfined compressive strength of soil.

Laboratory Experimental Research on Mix Ratio Test of Cement Soil

2013 ◽  
Vol 438-439 ◽  
pp. 197-201
Author(s):  
Xian Hua Yao ◽  
Peng Li ◽  
Jun Feng Guan
Keyword(s):  
Mechanical Properties ◽  
Compressive Strength ◽  
Unconfined Compressive Strength ◽  
Cement Content ◽  
Ratio Test ◽  
Curing Time ◽  
Curing Conditions ◽  
Cement Ratio ◽  
Water Cement Ratio ◽  
Cement Soil

Based on the generalization and analysis of laboratory experimental results on mix ratio, the effects of various factors such as cement content, water-cement ratio, curing time, curing conditions and types of cement on the mechanical properties of unconfined compressive strength of cement soil are presented. Results show that the unconfined compressive strength of cement soil increases with the growing curing time, and it is greatly affected by the cement content, water-cement ratio, cement types and curing time, while the effect of curing conditions is weak with a cement content of more than 10%. Moreover, the stress-strain of the cement soil responds with the cement content and curing time, increasing curing time and cement content makes the cement soil to be harder and brittle, and leads to a larger Young's modulus.

Research about the Effect of Polypropylene Fiber on Mechanical Properties of Curing Sludge

2011 ◽  
Vol 250-253 ◽  
pp. 788-794
Author(s):  
Shu Lin Zhan ◽  
Shu Sen Gao ◽  
Jun Ying Lai
Keyword(s):  
Mechanical Properties ◽  
Compressive Strength ◽  
Shear Strength ◽  
Water Content ◽  
Unconfined Compressive Strength ◽  
Polypropylene Fiber ◽  
Physical And Mechanical Properties ◽  
Curing Time ◽  
Strength Tests ◽  
Different Content

In order to study the influence of modified polypropylene (PP) fiber on the physical and mechanical properties of curing sludge, the same amount of cement and different content of polypropylene fiber were mixed into the sludge. Unconfined compressive strength tests, water content tests and shear strength tests were carried out on different specimens with different curing time. The results show that the sludge curing effect is markedly improved by the addition of the polypropylene fiber. As to the curing sludge with the same curing time, when the content of the polypropylene fiber increases, the unconfined compressive strength and the cohesive strength greatly increase, and the internal frictional angle decreases.

Sign in / Sign up

Export Citation Format

Share Document