scholarly journals Predicting Pumpability and Shootability of Crushed Aggregate Wet-Mix Shotcrete Based on Rheological Properties

2016 ◽  
Vol 2016 ◽  
pp. 1-9 ◽  
Author(s):  
Kyong-Ku Yun ◽  
Pangil Choi ◽  
Jung Heum Yeon
Keyword(s):  
Fly Ash ◽  
Rheological Properties ◽  
Silica Fume ◽  
Steel Fiber ◽  
Wide Spectrum ◽  
Granulated Blast Furnace Slag ◽  
Compliance Testing ◽  
Testing Data ◽  
Crushed Aggregate ◽  
Pump Pressure

This study aims to estimate the pumpability and shootability of wet-mix shotcrete (WMS) made with crushed aggregates and various admixtures such as silica fume, fly ash, ground granulated blast furnace slag (GGBFS), metakaolin, and steel fiber based on rheological properties. The IBB rheometer was employed as an apparatus to measure the rheological properties of freshly mixed shotcrete such as flow resistance and torque viscosity. Results have shown that the use of silica fume and metakaolin led to satisfactory pumpability, whereas mixtures with fly ash and steel fiber failed to meet the pumping criteria at normal pump pressure. The build-up thickness, an indicator to represent shotcrete shootability, was predicted to vary between 68 and 218 mm, demonstrating that the use of admixtures resulted in a wide spectrum of shootability. In particular, the use of metakaolin was found to substantially increase the predicted build-up thickness only with a small replacement. The findings of this study are expected to be used as an easy-to-use guideline for estimating pumpability and shootability of WMS when no compliance testing data is available.

Quantitative evaluation of mineral admixtures on the properties, pore structure, and durability of cement-based composites

2012 ◽  
Vol 19 (2) ◽  
pp. 199-207 ◽  
Author(s):  
Chinlai Lee ◽  
Maochieh Chi ◽  
Ran Huang
Keyword(s):  
Fly Ash ◽  
Pore Structure ◽  
Silica Fume ◽  
Mercury Intrusion Porosimetry ◽  
Cementitious Material ◽  
Mineral Admixtures ◽  
Penetration Test ◽  
Compressive Strength Test ◽  
Testing Data ◽  
Influence Of Water

AbstractThe influence of water/cementitious material ratio, silica fume, and fly ash as partial Portland cement replacement materials on the properties, pore structure, and durability of cement-based composites was evaluated by conducting compressive strength test, mercury intrusion porosimetry test, water absorption, rapid chloride penetration test, and scanning electron microscopy (SEM). Water/cementitious material ratio, and replacement percentage of silica fume and fly ash have significant effects on the pore structure and durability of cement-based composites. Composites with silica fume or fly ash have a denser structure than the control composite on SEM micrographs. Silica fume has about 5–10 times as much effect as fly ash, according to results of multiple linear regression analyses of testing data.

Current situation with the production and use of supplementary cementitious materials (SCMs) in concrete construction in Canada

2005 ◽  
Vol 32 (1) ◽  
pp. 129-143 ◽  
Author(s):  
Nabil Bouzoubaâ ◽  
Benoît Fournier
Keyword(s):  
Fly Ash ◽  
Silica Fume ◽  
Blended Cement ◽  
Cementitious Materials ◽  
Current Situation ◽  
Supplementary Cementitious Materials ◽  
Market Demand ◽  
Granulated Blast Furnace Slag ◽  
The Us ◽  
Economic Barriers

The data gathered on the current situation of supplementary cementing materials (SCMs) in Canada have shown that around 524 000, 347 000, and 37 000 t of fly ash, ground granulated blast furnace slag (GGBFS), and silica fume were used in cement and concrete applications in 2001, respectively, which represents 11%, 90%, and 185% of the quantity produced. The remaining 10% of GGBFS produced was used in the US, and 17 000 t of silica fume were imported from the US and Norway to meet market demand. Fly ash appears to be the only material that is underused and that represents a potential for increased use of SCMs in Canada. For the GGBFS, the quantity produced can be increased if the demand increases. This investigation has shown, however, that there are policy, technical, and economic barriers to the increased use of SCMs in Canada. Some solutions were proposed to overcome these barriers and are summarized in the conclusions of the paper.Key words: fly ash, slag, silica fume, concrete, blended cement.

Properties of Steel Fiber Reinforced Geopolymer

2015 ◽  
Vol 659 ◽  
pp. 143-148 ◽  
Author(s):  
Rachamongkon Wongruk ◽  
Smith Songpiriyakij ◽  
Piti Sukontasukkul ◽  
Prinya Chindaprasirt
Keyword(s):  
Fly Ash ◽  
Flexural Strength ◽  
Silica Fume ◽  
Steel Fibre ◽  
Steel Fiber ◽  
Volume Fraction ◽  
Fibre Volume Fraction ◽  
Fibre Volume ◽  
Steel Fibers ◽  
Flexural Performance

In this study, the mechanical properties of steel fibre reinforced geopolymer (SFRG) are investigated. The geopolymer is consisted of fly ash, silica fume and activator solution, sodium silicate and sodium hydroxide. Five mix proportions of fly ash and silica fume are varied to study the effect of fly ash/silica fume ratios (FA/SF). This experimental series focus mainly on flexural strength and flexural toughness performance of SFRG. Hooked-ends steel fibers are used at 0.5% and 1% by volume fractions. The experiment is carried out based on ASTM C1609 (beam specimens) for flexural performance. The results showed that fibre can significantly enhance the both flexural strength and toughness of geopolymer. The enhancement also increases with the increasing fibre volume fraction.

Experimental Research of Rebound Detection in Steel Fiber Concrete

2014 ◽  
Vol 578-579 ◽  
pp. 1108-1112 ◽  
Author(s):  
Jian Feng Ye ◽  
Hua Yan Chen ◽  
Xian Shun Bi
Keyword(s):  
Regression Analysis ◽  
Fly Ash ◽  
Experimental Research ◽  
Compression Strength ◽  
Steel Fiber ◽  
Detection Method ◽  
Fiber Concrete ◽  
Testing Data ◽  
Steel Fiber Concrete ◽  
Set Up

For the application into country point highway of Xiamen to Kunming, a series of the C40 concrete with fly ash and slag have been studied by rebound detection and compression strength, the detecting wave of rebound value and compression strength is set up by regression analysis of the testing data. It is shown from the example that the compression strength and rebound value have good relativity, this rebound detection method used in steel fiber concrete is simple and practical.

Effects of Temperature on Drying Shrinkage of Concrete

2014 ◽  
Vol 584-586 ◽  
pp. 1176-1181 ◽  
Author(s):  
Ying Zi Yang ◽  
Mao Guang Li ◽  
Hong Wei Deng ◽  
Qi Liu
Keyword(s):  
Fly Ash ◽  
Silica Fume ◽  
Drying Shrinkage ◽  
Shrinkage Strain ◽  
Mineral Admixture ◽  
Cement Ratio ◽  
Water Cement Ratio ◽  
Granulated Blast Furnace Slag ◽  
Influence Of Water ◽  
Effects Of Temperature

The present study investigated experimentally effects of temperature on drying shrinkage of concrete in different water cement ratio and containing mineral admixture. Concrete was exposed to a controlled environment of 20±1oC, 35±1oC, 50±1oC, and 60% ± 5 RH, respectively. The drying shrinkage of concretes with water cement ratio of 0.3, 0.4 and 0.5 were evaluated. The resuluts showed that with the increase of temperature from 20 oC to 50 oC, the influence of water cement ratio on drying shrinkage of concrete was gradually weakened. The shrinkage strain of concretes with replacement of cement by 20% of ground granulated blast-furnace slag (GGBS), 10% of silica fume (SF), and 20% of fly ash (FA) were measured, respectively. Test results showed that GGBS had a little impact on drying shrinkage of concrete; Silica fume could increase the drying shrinkage of concrete significantly in the early and later ages, especially when concrete was subjected to high temperature; Fly ash reduced drying shrinkage in early ages and increased drying shrinkage of concrete in the later ages.

scholarly journals Basic Properties of fly Ash/Slag -Concrete Slurry Waste Geopolymer Activated by Sodium Carbonate and Different Silicon Sources

2021 ◽  
Vol 8 ◽  
Author(s):  
Yingli Gao ◽  
Kairui Duan ◽  
Shuncheng Xiang ◽  
Wei Zeng
Keyword(s):  
Fly Ash ◽  
Silica Fume ◽  
Sodium Carbonate ◽  
Negative Impact ◽  
Reference Group ◽  
Setting Time ◽  
Sodium Metasilicate ◽  
Fly Ash Concrete ◽  
Granulated Blast Furnace Slag ◽  
Silicon Sources

As a kind of granular waste with complex composition and alkali corrosiveness, concrete slurry waste (CSW) has severe recycling limitations in the ordinary Portland cement (OPC). Considering this, a new type of geopolymer, prepared by granulated blast furnace slag/fly ash, concrete slurry waste, and powdered activators (sodium carbonate and different silicon sources including sodium metasilicate pentahydrate and silica fume), was adopted to conduct a comparative study with the OPC counterpart. In this study, the homogenized CSW was mixed in the OPC and geopolymer with a constant ratio of 50 wt%, respectively. Then the properties were studied in terms of the flowability, setting times, mechanical strengths, and microstructures. The results showed that better flowability (200 mm) could be achieved in the obtained geopolymer than in the OPC reference group (95 mm) by increasing the powdered activators. The setting time of the OPC was significantly shortened due to the addition of CSW. The strengths of geopolymer were supported by the produced C-A-S-H and carbonates, with less chemically bonded water than the hydration products in the reference group. The dominant size of pores in the hardened geopolymer was much smaller than that in the OPC group which was 80 nm. Silica fume could be the alternate of the sodium metasilicate pentahydrate and had an insignificant negative impact on the fresh and hardened properties and microstructures of the geopolymer when the incorporation rate was within 5%.

Durability of Sustainable Self-Consolidating Concrete

2018 ◽  
Vol 765 ◽  
pp. 285-289
Author(s):  
Osama Ahmed Mohamed ◽  
Waddah Al Hawat ◽  
Omar Fawwaz Najm
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Silica Fume ◽  
Cementitious Materials ◽  
Chloride Penetration ◽  
Supplementary Cementitious Materials ◽  
Test Results ◽  
Self Consolidating Concrete ◽  
Human Footprint ◽  
Granulated Blast Furnace Slag

Supplementary cementitious materials such as fly ash, silica fume and ground granulated blast furnace slag (GGBS) have been used widely to partially replace cement in producing self-consolidating concrete (SCC). The production of cement is associated with emission of significant amounts of CO2 and increases the human footprint on the environment. Fly ash, silica fume, and GGBS are recycled industrial by-products that also impart favorable fresh and hardened properties on concrete. This study aims to assess the effect of the amounts of fly ash and silica fume on strength and chloride penetration resistance of concrete. Rapid Chloride Penetration Test (RCPT) was used to assess the ability of SCC to resist ingress of chlorides into concrete. SCC mixes with different dosages of fly ash and silica fume were developed and tested at different curing ages. Test results showed that replacing 20% of cement with fly ash produced the highest compressive strength of 67.96 MPa among all fly ash-cement binary mixes. Results also showed that replacing15% of cement with silica fume produced the highest compressive strength of 95.3 MPa among fly ash-cement binary mixes. Using fly ash and silica fume consistently increased the concrete resistance to chloride penetration at the early ages. Silica fume at all dosages results in low or very low levels of chloride penetration at all curing ages of concrete.

Sign in / Sign up

Export Citation Format

Share Document