scholarly journals Application of Recursive Least Square Algorithm on Estimation of Vehicle Sideslip Angle and Road Friction

2010 ◽  
Vol 2010 ◽  
pp. 1-18 ◽  
Author(s):  
Nenggen Ding ◽  
Saied Taheri
Keyword(s):  
Least Square ◽  
Recursive Least Square ◽  
Control Logic ◽  
Sideslip Angle ◽  
Active Steering ◽  
Direct Yaw Moment Control ◽  
Road Friction ◽  
Yaw Moment Control ◽  
Moment Control ◽  
Yaw Moment

A recursive least square (RLS) algorithm for estimation of vehicle sideslip angle and road friction coefficient is proposed. The algorithm uses the information from sensors onboard vehicle and control inputs from the control logic and is intended to provide the essential information for active safety systems such as active steering, direct yaw moment control, or their combination. Based on a simple two-degree-of-freedom (DOF) vehicle model, the algorithm minimizes the squared errors between estimated lateral acceleration and yaw acceleration of the vehicle and their measured values. The algorithm also utilizes available control inputs such as active steering angle and wheel brake torques. The proposed algorithm is evaluated using an 8-DOF full vehicle simulation model including all essential nonlinearities and an integrated active front steering and direct yaw moment control on dry and slippery roads.

Direct Yaw-Moment Control through Optimal Control Allocation Method for Light Vehicle

2012 ◽  
Vol 246-247 ◽  
pp. 847-852 ◽  
Author(s):  
Bing Zhu ◽  
Li Tong Guo ◽  
Jian Zhao ◽  
Fang Gao ◽  
Zhen Pan ◽  
...  
Keyword(s):  
Optimal Control ◽  
Superior Performance ◽  
Control Allocation ◽  
Sideslip Angle ◽  
Pid Algorithm ◽  
Direct Yaw Moment Control ◽  
Allocation Method ◽  
Yaw Moment Control ◽  
Moment Control ◽  
Yaw Moment

This paper presents a Direct Yaw-moment Control (DYC) strategy to prevent light vehicles from entering the unsteady state and improve the handling stability. A novelty of this work is the ability to achieve superior performance through the lower workload of the actuators by using the optimal control allocation method to distribute the active yaw moment. In the main-loop, the DYC controller is designed based on the classical PID algorithm with the yaw rate and sideslip angle feedback. Simulation tests are carried out on the conditions of sine steering and single lane change steering. Results indicate that the working potential of each actuator can be fully utilized and a significant improvement in handling stability can be achieved from the DYC system.

scholarly journals Yaw Rate and Sideslip Angle Control Through Single Input Single Output Direct Yaw Moment Control

2021 ◽  
Vol 29 (1) ◽  
pp. 124-139 ◽  
Author(s):  
Basilio Lenzo ◽  
Mattia Zanchetta ◽  
Aldo Sorniotti ◽  
Patrick Gruber ◽  
Wouter De Nijs
Keyword(s):  
Sideslip Angle ◽  
Single Input Single Output ◽  
Yaw Rate ◽  
Single Output ◽  
Direct Yaw Moment Control ◽  
Yaw Moment Control ◽  
Moment Control ◽  
Single Input ◽  
Yaw Moment

A Comparison of the Relative Benefits of Active Front Steering and Active Rear Steering When Coordinated With Direct Yaw Moment Control

2001 ◽  
Author(s):  
M. A. Selby ◽  
W. J. Manning ◽  
M. D. Brown ◽  
D. A. Crolla
Keyword(s):  
Load Transfer ◽  
Open Loop ◽  
Lateral Acceleration ◽  
Sideslip Angle ◽  
Direct Yaw Moment Control ◽  
Active Front Steering ◽  
Yaw Moment Control ◽  
Moment Control ◽  
The Stability ◽  
Yaw Moment

Abstract This paper studies the benefits of coordinating stability and steerability controllers to reduce vehicle deceleration during limit handling situations. The stability controller, DYC, uses the vehicle brakes to apply a restoring moment when the vehicle sideslip angle and sideslip velocity exceed fixed bounds. This use of the brakes interferes with the longitudinal dynamics of the vehicle in a way that drivers find undesirable. Active front steering (AFS) and active rear steering(ARS) can be used to tune the vehicle handling balance in the low to mid-range lateral-acceleration regime. Earlier work has shown that the use of AFS can reduce the interference observed using DYC alone. The levels of improvement achievable by coordinating AFS and ARS with DYC are quantified using open loop handling simulations tests by predicting the deceleration of the vehicle in an extreme manoeuvre. The results from these simulations are compared to assess the relative benefits of AFS and ARS when coordinated with DYC. The computer simulations are based on a four-degree of freedom vehicle model incorporating longitudinal, lateral, yaw, roll, and load transfer effects.

scholarly journals Sliding Mode Integrated Control for Vehicle Systems Based on AFS and DYC

2020 ◽  
Vol 2020 ◽  
pp. 1-8
Author(s):  
Chao Lu ◽  
Jing Yuan ◽  
Genlong Zha
Keyword(s):  
Sliding Mode ◽  
Integrated Control ◽  
Sideslip Angle ◽  
Yaw Rate ◽  
Direct Yaw Moment Control ◽  
Vehicle Systems ◽  
Yaw Moment Control ◽  
Moment Control ◽  
Two Degree Of Freedom ◽  
Yaw Moment

This paper has investigated an integrated control of active front steering (AFS) and direct yaw-moment control (DYC) for vehicle systems. First of all, the desired yaw rate and sideslip angle are estimated by using a two-degree-of-freedom (2-DOF) model of the vehicle system. On this basis, the actual sideslip angle is estimated by means of an observer. Then, the sliding mode control (SMC) is developed for AFS and DYC, respectively, to guarantee that the actual yaw rate and the sideslip angle track their reference signals. Additionally, the disturbance observer (DOB) technique is introduced to further improve the control performance. Finally, the simulation results validate the superiority of the AFS and DYC integrated control by using CarSim software during the following conditions: double lane change and side wind disturbance.

Innovative Active Vehicle Safety Using Integrated Stabilizer Pendulum and Direct Yaw Moment Control

2014 ◽  
Vol 136 (5) ◽  
Author(s):  
Avesta Goodarzi ◽  
Fereydoon Diba ◽  
Ebrahim Esmailzadeh
Keyword(s):  
Control System ◽  
Model Simulation ◽  
Dynamic Control ◽  
Superior Performance ◽  
Steering Control ◽  
Pendulum System ◽  
Direct Yaw Moment Control ◽  
Yaw Moment Control ◽  
Moment Control ◽  
Yaw Moment

Basically, there are two main techniques to control the vehicle yaw moment. First method is the indirect yaw moment control, which works on the basis of active steering control (ASC). The second one being the direct yaw moment control (DYC), which is based on either the differential braking or the torque vectoring. An innovative idea for the direct yaw moment control is introduced by using an active controller system to supervise the lateral dynamics of vehicle and perform as an active yaw moment control system, denoted as the stabilizer pendulum system (SPS). This idea has further been developed, analyzed, and implemented in a standalone direct yaw moment control system, as well as, in an integrated vehicle dynamic control system with a differential braking yaw moment controller. The effectiveness of SPS has been evaluated by model simulation, which illustrates its superior performance especially on low friction roads.

Sign in / Sign up

Export Citation Format

Share Document