Preliminary Studies of the Use of an Automated Flow‐Cell Electrodeposition System for the Formation of CdTe Thin Films by Electrochemical Atomic Layer Epitaxy

1995 ◽  
Vol 142 (9) ◽  
pp. 3007-3016 ◽  
Author(s):  
B. M. Huang ◽  
L. P. Colletti ◽  
B. W. Gregory ◽  
J. L. Anderson ◽  
J. L. Stickney
Author(s):  
Baoming M. Huang

Semiconductor thin films have important applications in areas such as photovoltaics and luminescent displays. Electrodeposition of these films is a potential low cost, room temperature production technique. Electrochemical atomic layer epitaxy (ECALE) involves alternatively depositing individual element monolayer amount per ECALE cycle, taking advantage of the under-potential deposition (UPD) phenomena.A series of CdTe thin films have been deposited using ECALE methodology in an electrochemical flow cell system. The 0.5 mM Te4+, Te blank, 5mM Cd2+, and Cd blank solutions are made with purasonic grade TeO2 and CdSO4, research grade electrolyte, and 18 M ohm water. The gold foil substrates are cleaned electrochemically before each experiment. An ECALE cycle starts with depositing monolayer amount Te, rinsing with Te blank, then depositing monolayer amount of Cd, and ending with rinsing with Cd blank solution. The whole flow cell system is controlled by a computer with house-written codes, and the deposition process can be fully programmed.


2003 ◽  
Vol 559 ◽  
pp. 55-61 ◽  
Author(s):  
Raman Vaidyanathan ◽  
John L. Stickney ◽  
Stephen M. Cox ◽  
Steven P. Compton ◽  
Uwe Happek

2002 ◽  
Vol 744 ◽  
Author(s):  
Raman Vaidyanathan ◽  
Mkhulu K. Mathe ◽  
Patrick Sprinkle ◽  
Steve M Cox ◽  
Uwe Happek ◽  
...  

ABSTRACTElectrochemical atomic-layer epitaxy (EC-ALE) is an approach to electrodepositing thin-films of compound semiconductors. It takes advantage of underpotential deposition (UPD), deposition of a surface limited amount (a monolayer or less) of an element at a potential less negative than bulk deposition, to form a thin-film of a compound--one atomic layer at a time. Ideally, the 2-D growth mode should promote epitaxial deposition.We report the formation of compound Cu2Se, at room temperature by electrochemical atomic layer epitaxy (EC-ALE). Cyclic voltammograms were used to determine the deposition potentials of each element. An automated deposition program was used to form 750 cycles of Cu2Se thin films. Electron probe microanalysis was done to determine the stoichiometry of the thin films. X-ray diffraction of the 200 cycle deposit indicated the presence of polycrystalline Cu2Se. The atomic ratio of Cu/Se in the thin films was found to be 2. Band gap of the thin films were determined by reflection absorption measurements. The band gap of the 200 cycle Cu2Se films was found to be 1.6 eV. X-ray diffraction of 350 and 750 cycle Cu2Se films, indicated the deposits consisted of Cu3Se2 and Cu2Se.


Langmuir ◽  
2000 ◽  
Vol 16 (13) ◽  
pp. 5820-5824 ◽  
Author(s):  
Tsukasa Torimoto ◽  
Atsushi Obayashi ◽  
Susumu Kuwabata ◽  
Hidehiro Yasuda ◽  
Hirotaro Mori ◽  
...  

1998 ◽  
Vol 145 (5) ◽  
pp. 1442-1449 ◽  
Author(s):  
Lisa P. Colletti ◽  
Billy H. Flowers ◽  
John L. Stickney

Sign in / Sign up

Export Citation Format

Share Document