The ecophysiological and growth responses of Aleppo pine (Pinushalepensis) to controlled heating applied to the base of the trunk

1996 ◽  
Vol 26 (8) ◽  
pp. 1366-1374 ◽  
Author(s):  
Michel Ducrey ◽  
Fabrice Duhoux ◽  
Roland Huc ◽  
Eric Rigolot

Controlled, localized heating was applied to the trunks of young Aleppo pines (Pinushalepensis Mill.) during the winter. Three levels of burning were applied to the circumference of the trunks (zero, partial, or total), and the effects on tree physiology and growth were monitored during the 7 months following heating. Effects of the heat treatment on tree physiology were assessed by measuring predawn water potential, sap flux density, microvariations in trunk diameter, electrical resistance of the cambium, and gas exchanges from the needles (photosynthesis and stomatal conductance). Morphological response measurements included height and radial growth of the trees and morphological characteristics of the needles. The amount of chlorotic foliage was also measured. Aleppo pine was highly resistant to trunk injury, surviving when 80% of the trunk circumference was destroyed by fire. The behaviour of partially burnt pines was not significantly different from that of controls, for all variables studied. Trees whose trunks were totally burnt died from 1 to 5 months after treatment. Sap flux density of totally burnt trees was already significantly lower than that of other trees in the first week following the treatment. A decrease in net photosynthesis and stomatal conductance in the still surviving totally burnt trees was also recorded during the first measurements made in July. Treatment differences in predawn water potential, microvariations in trunk diameter, and electrical resistance of the cambium only appeared a few days before death of the totally burnt trees.

2016 ◽  
Vol 218-219 ◽  
pp. 92-101 ◽  
Author(s):  
V. Hernandez-Santana ◽  
J.E. Fernández ◽  
C.M. Rodriguez-Dominguez ◽  
R. Romero ◽  
A. Diaz-Espejo

2004 ◽  
Vol 24 (3) ◽  
pp. 241-249 ◽  
Author(s):  
C. R. Ford ◽  
M. A. McGuire ◽  
R. J. Mitchell ◽  
R. O. Teskey

Trees ◽  
2014 ◽  
Vol 28 (6) ◽  
pp. 1867-1868
Author(s):  
Lidewei L. Vergeynst ◽  
Maurits W. Vandegehuchte ◽  
Mary Anne McGuire ◽  
Robert O. Teskey ◽  
Kathy Steppe

1997 ◽  
Vol 24 (5) ◽  
pp. 701 ◽  
Author(s):  
Ping Lu

The Granier sap flow measuring system that normally uses one analogue input channel of a datalogger for each sensor was modified to enable one channel to measure the average value of signals from two or more sensors. The sap flux density calculated from this average value of signals was very close (difference < 6.0%) to the arithmetic mean of the sap flux densities measured separately by means of individual sensors (using two or more input channels). The dynamics of the sap flux density measured by the modified method were similar to those measured by the original method. On a per-channel basis, the modified method reduced the ‘estimation error’ of sap flux density by 4–14-fold compared to the original method. By using the modified Granier system, the error in sap flow measurement that is usually associated with limited sampling can be substantially reduced without the need for extra dataloggers, the greatest item of expense.


2020 ◽  
Vol 40 (5) ◽  
pp. 683-694
Author(s):  
Michael A Forster

Abstract Heat pulse methods are a popular approach for estimating sap flow and transpiration. Yet, many methods are unable to resolve the entire heat velocity measurement range observable in plants. Specifically, the Heat Ratio (HRM) and Tmax heat pulse methods can only resolve slow and fast velocities, respectively. The Dual Method Approach (DMA) combines optimal data from HRM and Tmax to output the entire range of heat velocity. However, the transition between slow and fast methods in the DMA currently does not have a theoretical solution. A re-consideration of the conduction/convection equation demonstrated that the HRM equation is equivalent to the Péclet equation which is the ratio of conduction to convection. This study tested the hypothesis that the transition between slow and fast methods occurs when conduction/convection, or the Péclet number, equals one, and the DMA would be improved via the inclusion of this transition value. Sap flux density was estimated via the HRM, Tmax and DMA methods and compared with gravimetric sap flux density measured via a water pressure system on 113 stems from 15 woody angiosperm species. When the Péclet number ≤ 1, the HRM yielded accurate results and the Tmax was out of range. When the Péclet number &gt; 1, the HRM reached a maximum heat velocity at approximately 15 cm hr −1 and was no longer accurate, whereas the Tmax yielded accurate results. The DMA was able to output accurate data for the entire measurement range observed in this study. The linear regression analysis with gravimetric sap flux showed an r2 of 0.541 for HRM, 0.879 for Tmax and 0.940 for DMA. With the inclusion of the Péclet equation, the DMA resolved the entire heat velocity measurement range observed across 15 taxonomically diverse woody species. Consequently, the HRM and Tmax are redundant sap flow methods and have been superseded by the DMA.


Sign in / Sign up

Export Citation Format

Share Document