Water content - void ratio swell-shrink paths of compacted expansive soils

2002 ◽  
Vol 39 (4) ◽  
pp. 938-959 ◽  
Author(s):  
S Tripathy ◽  
KS Subba Rao ◽  
D G Fredlund

This paper addresses the behaviour of compacted expansive soils under swell–shrink cycles. Laboratory cyclic swell–shrink tests were conducted on compacted specimens of two expansive soils at surcharge pressures of 6.25, 50.00, and 100.00 kPa. The void ratio and water content of the specimens at several intermediate stages during swelling until the end of swelling and during shrinkage until the end of shrinkage were determined to trace the water content versus void ratio paths with an increasing number of swell–shrink cycles. The test results showed that the swell–shrink path was reversible once the soil reached an equilibrium stage where the vertical deformations during swelling and shrinkage were the same. This usually occurred after about four swell–shrink cycles. The swelling and shrinkage path of each specimen subjected to full swelling – full shrinkage cycles showed an S-shaped curve (two curvilinear portions and a linear portion). However, the swelling and shrinkage path occurred as a part of the S-shaped curve, when the specimen was subjected to full swelling – partial shrinkage cycles. More than 80% of the total volumetric change and more than 50% of the total vertical deformation occurred in the central linear portion of the S-shaped curve. The volumetric change was essentially parallel to the saturation line within a degree of saturation range of 50–80% for the equilibrium cycle. The primary value of the swell–shrink path is to provide information regarding the void ratio change that would occur for a given change in water content for any possible swell–shrink pattern. It is suggested that these swell–shrink paths can be established with a limited number of tests in the laboratory.Key words: expansive soils, oedometer tests, swell–shrink behaviour, shrinkage tests.

2000 ◽  
Vol 37 (6) ◽  
pp. 1325-1331
Author(s):  
J LH Grozic ◽  
M E Lefebvre ◽  
P K Robertson ◽  
N R Morgenstern

Time domain reflectometry (TDR) can be used to determine the volumetric water content of soils. This note describes the utilization of a TDR miniprobe in triaxial testing. The TDR performance was examined with a series of tests that not only proved its reliability but also resulted in two empirical correlations. Using these correlations, the degree of saturation and volumetric water content during triaxial testing could be determined. The TDR was then put to use in a laboratory program designed to investigate the response of loose gassy sand under static and cyclic loading. Because of the TDR measurements it was possible to determine the degree of saturation and void ratio of the gassy specimens. The TDR miniprobe proved to be accurate, simple to use, and inexpensive to build.Key words: time domain reflectometry, TDR, triaxial testing, gassy, unsaturated.


2013 ◽  
Vol 50 (2) ◽  
pp. 200-208 ◽  
Author(s):  
Simon Salager ◽  
Mathieu Nuth ◽  
Alessio Ferrari ◽  
Lyesse Laloui

The paper presents an experimental and modelling approach for the soil-water retention behaviour of two deformable soils. The objective is to investigate the physical mechanisms that govern the soil-water retention properties and to propose a constitutive framework for the soil-water retention curve accounting for the initial state of compaction and deformability of soils. A granular soil and a clayey soil were subjected to drying over a wide range of suctions so that the residual state of saturation could be attained. Different initial densities were tested for each material. The soil-water retention curves (SWRCs) obtained are synthesized and compared in terms of water content, void ratio, and degree of saturation, and are expressed as a function of the total suction. The studies enable assessment of the effect of the past and present soil deformation on the shape of the curves. The void ratio exerts a clear influence on the air-entry value, revealing that the breakthrough of air into the pores of the soil is more arduous in denser states. In the plane of water content versus suction, the experimental results highlight the fact that from a certain value of suction, the retention curves corresponding to different densities of the same soil are convergent. The observed features of behaviour are conceptualized into a modelling framework expressing the evolution of the degree of saturation as a function of suction. The proposed retention model makes use of the theory of elastoplasticity and can thus be generalized into a hysteretic model applicable to drying–wetting cycles. The calibration of the model requires the experimental retention data for two initial void ratios. The prediction of tests for further ranges of void ratios proves to be accurate, which supports the adequacy of formulated concepts.


2012 ◽  
Vol 28 (3) ◽  
pp. 431-437 ◽  
Author(s):  
S.-R. Yang ◽  
H.-D. Lin ◽  
W.-H. Huang

AbstractIn this study, the initial soil suction of as-compacted clayey soils was evaluated for various compaction conditions, covering a wide range of compaction energy and molding water content. The soil specimens were prepared by impact compaction under three levels of compaction energy. The filter paper method was used to measure the initial soil suction of as-compacted specimens. Test results indicate that the relationship between the soil suction and the molding water content is bilinear under three different compaction energies. However, the effect of compaction energy on soil suction is different for the soils with different amounts of clay fraction and is elucidated by the macro soil properties. The change of soil suction due to different compaction energies can be predicted by the void ratio and the degree of saturation.


2017 ◽  
Vol 19 (2) ◽  
pp. 121-127
Author(s):  
Lisa Fitriyana ◽  
Abdul Rochim

Swelling and shrinkage abilities of soils are dangerous for buildings. According to Hardiyatmo (2014) There are two types of swelling in expansive soils that are the movement of lateral (horizontal) and axial (vertical). Oftentimes the deformation of soils cannot be supported by building stiffness. This damage can be seen in retaining walls, tunnel walls, and etc. With the aims to identify an expansive soil and to know its lateral and axial strains, an experimental study was performed. Swelling tests were conducted in a specimen having diameter (d) of 4,5 cm and height (h0) of 2 cm with the variations in : 1) water content wopt = 31% and 18%; 2) vertical pressure (pv) 1 kPa, 3.5 kPa and 6.9 kPa; and 3) membrane thickness (t) 0.7 mm and 0.5 mm. The strain in the axial direction was measured with a dial gauge that was set vertically parallel whereas the lateral strain is by measuring changes in diameter of the specimen with a digital caliper measurement tools. Based on the analysis on the identification results, the observed soil is classified as expansive soil with the expansion potential is high average. The test results show the same potential for the occurrence of lateral and lateral strain if the lateral retention (e.g. retaining wall) is weak. The largest lateral and axial soil development occurred at water content w0 = 18% are 15.7% and 15.8% respectively.


2020 ◽  
Vol 195 ◽  
pp. 04004
Author(s):  
Arisleidy Mesa Alcantara ◽  
Nadia Mokni ◽  
Enrique Romero ◽  
Sebastià Olivella

Bentonite mixtures of MX-80 (80% of high-density pellets and 20% of bentonite powder on a mass basis) have been recently proposed as a candidate material for sealing deep geological disposals of high-level radioactive waste. A loading/unloading oedometer test at constant water content has been performed on this mixture, which has been modelled using the finite element Code_Bright. The constitutive model used to represent the mechanical response is the Barcelona Expansive Model (BExM), since a multi-modal pore size distribution characterises the pore network of the mixture. During compression at constant water content, an increase in the degree of saturation and a consequent reduction of suction is induced. Consequently, two competing effects occur at different pore-size scales: (a) compression due to mean net stress increase; and (b) expansion on induced suction reduction that mainly affects the micro-porosity level inside aggregates. A sensitivity analysis has been performed to explore these effects, in which the elastic compressibility parameter at the micro-porosity scale for changes in mean effective stress plays an important role.


2014 ◽  
Vol 580-583 ◽  
pp. 705-710
Author(s):  
Ping Liu ◽  
Hu Yuan Zhang ◽  
Yi Chen ◽  
Xian Xian Shao ◽  
Xin Yuan Fu

The soil water characteristic curve (SWCC) has been tested during the drying process. In order to define the relationship between suction, degree of saturation and void ratio, fitting models of SWCC was established. Studies have shown that the shape of SWCC of three kinds of samples (taken from Jiaohe, Gaochang and Jiuzhoutai) was similar to the inverted “S”, the relationship between water content and matric suction was inversely proportional. Under the condition of the same moisture, the matric suction of the Jiaohe and Gaochang samples were greater than the Jiuzhoutai samples, and the changes of pore water pressures showed the same trend. The degree of saturation began to decrease when the water content reduced to the air entry value. When the degree of saturation was greater than 90%, the volume of soil samples contracted significantly, and when saturation is below 80%, volume shrinkage stopped.


2015 ◽  
Vol 52 (2) ◽  
pp. 244-250 ◽  
Author(s):  
X.-Y. Shang ◽  
G.-Q. Zhou ◽  
L.-F. Kuang ◽  
W. Cai

The oedometer tests of remoulded deep clay in East China subjected to consolidation stresses ranging from 0.2 to 15.0 MPa were carried out. Both the measured compression curves and the curves of logarithmic permeability versus void ratio consist of two linear segments, among which the bilinear shape of the compression curves is less noticeable. The consolidation stress and void ratio at the intersection of two lines are around 2 MPa and 0.565 ± 0.015, respectively, and the corresponding saturated water content is very close to the reported saturated adsorbed water content. Lastly, but most importantly, the calculated microscopic pore size corresponding to the intersection point agrees well with the transitional range of the distance between two clay surfaces within which water molecules transform from bulk-liquid-like water into confined water. This is confirmed by experimental results available in the literature.


2014 ◽  
Vol 51 (12) ◽  
pp. 1449-1455 ◽  
Author(s):  
Glen J. Burton ◽  
Daichao Sheng ◽  
David Airey

In this paper, the volume change behaviour of Maryland clay compacted on the wet side of standard Proctor optimum water content (with lower compaction energy) is studied in reference to the saturated reconstituted state. Oedometer tests over a range of suctions and vertical stresses have been carried out, and the results have shown that the compression index reaches a peak (approximately twice that of the reconstituted material) and then gradually reduces to the reconstituted value as the stress level is increased. The results are analyzed in a framework where the degree of saturation is treated as a state parameter and controls the slope of the unsaturated normal compression line. Tests conducted under constant suction and constant water content have been used to demonstrate the effectiveness of using the degree of saturation as a state variable.


2010 ◽  
Vol 47 (5) ◽  
pp. 583-594 ◽  
Author(s):  
Setianto Samingan Agus ◽  
Tom Schanz ◽  
Delwyn G. Fredlund

Compacted soils have been widely used as landfill barriers because of favorable characteristics such as low coefficient of permeability and high swelling. Compacted bentonite–sand mixtures are normally unsaturated and therefore suction can be used as a behavioral indicator in addition to generally used factors such as water content and dry density (or void ratio). This study focused on investigating suction characteristics of bentonite–sand mixtures. Suction was measured using various techniques for compacted bentonite–sand mixtures. The laboratory results were analyzed to provide an understanding of the suction concept in expansive soils. It was found that suction depends primarily on the water content and the bentonite content of the mixture, and suction in expansive soils changes with the time of hydration.


Sign in / Sign up

Export Citation Format

Share Document