Collision-induced microwave absorption in Ne–Xe and Ar–Xe gaseous mixtures

1978 ◽  
Vol 56 (8) ◽  
pp. 1046-1053 ◽  
Author(s):  
I. R. Dagg ◽  
G. E. Reesor ◽  
M. Wong

Collision-induced microwave absorption has been observed at 4.4 cm−1 for the inert gas mixtures Ne–Xe and Ar–Xe. The absorption coefficient has been measured at room temperature for a range of density products up to 15 000 amagat2 and for different density ratios. The intracollisional absorption coefficient has been determined at this low frequency for each mixture from the data at low densities. These results for the absorption coefficient along with existing infrared results have yielded an accurate value for the zeroth moment for each of the spectra and hence improved values for the induced dipole moment parameters for the exponential model. For the range parameter, ρ, we obtain values of 0.312 Å and 0.408 Å, respectively, for the Ne–Xe and Ar–Xe mixtures. The values for the dipole strength parameters, μσ, calculated using the Lennard-Jones (12-6) potential are 0.0293 and 0.0328 D, respectively. Evaluations of μσ have also been carried out using other potentials. In particular, for Ne–Xe a value of μσ = 0.0377 D is calculated using the more realistic Morse – Spine – van der Waals (MSV) potential. At higher densities the results reveal intercollisional interference effects which result in a reduction of the absorption. The amount of reduction depends on the ratios of the gases in the mixture. In the highest density range studied, there is observed a marked increase in the absorption which may be attributed to many-body collisions.

1980 ◽  
Vol 58 (5) ◽  
pp. 633-641 ◽  
Author(s):  
I. R. Dagg ◽  
W. D. Leckie ◽  
L. A. A. Read

Collision-induced microwave absorption has been observed at 2.3 cm−1 for the rare gas mixtures Ne–Kr, Ar–Kr, Ar–Xe, and Kr–Xe. The absorption coefficient has been measured at room temperature for density products up to 8000 amagat2 and for various density ratios. These results have been used in conjunction with those of the infrared region to determine more accurately the zeroth moment for each of the spectra and hence have allowed improved values for the induced dipole moment parameters for the exponential model. Upper limits to the absorption in He–Xe and He–Ar mixtures in the microwave region have also been established.


1978 ◽  
Vol 56 (12) ◽  
pp. 1559-1564 ◽  
Author(s):  
I. R. Dagg ◽  
G. E. Reesor ◽  
M. Wong

Collision-induced microwave absorption has been observed at 2.3 cm−1 for the inert gas mixtures Ne–Xe and Ar–Xe. The absorption coefficient has been measured at room temperature for a range of density products up to 15 000 amagat2 for different density ratios. The present results are compared with the results obtained earlier at 4.4 cm−1. The intracollisional absorption coefficient arising from two body interactions is approximately proportional to the square of the frequency for both mixtures. The intercollisional interference effects have led to a larger suppression of the absorption than was observed previously at 4.4 cm−1. An expression for the intercollisional line shape factor was used to fit the data. At high densities, there is observed a marked increase in the absorption which has also been observed at 4.4 cm−1 and which may be attributed to many body collisions.


Author(s):  
Purwanto Purwanto

The increasing use of composites in all fields is engineered materials that many people do to obtain the new alternative materials, one of the materials such as natural vetiver fiber (SAW) which is strong and lightweight and powder sawn (SGK), which is waste material. In this research, manufacturing the composite of  SAW and SGK then testing acoustic/absorption power by measuring the absorption coefficient of the sound and the observation of microstructure. The method used in the study is an experiment in the laboratory to make composites based on the ratio of the weight fraction between SAW and SGK from 1: 5, 2: 5, 3: 5, 4: 5 and 5: 5. Having formed the composites, then the specimen has made by an acoustic test that compatible to ASTM E-1050-98 standard with B & K 4206 Small Tube Set test instrument. Furthermore, to determine the composition of fibers in the composites, there do the micro observation. From the results of the show the composites produced the sound absorption ability for the low frequency (1000 Hz) with an absorption coefficient (α) of 0.25 occurred in comparative fraction of 2: 5 (SAW20, SGK50). While at high frequency (5000 Hz) has a value of coefficient (α) of 0.41 occurred in the ratio of 1: 5 (SAW10, SGK50). The number of composition number fiber influence the composite tensile strength and micro observations occurred in the composition ratio of 5: 5 its highest strength.


The low-frequency field modulation technique has been employed to study the de Haas-van Alphen effect in single crystals of niobium in fields up to 10 tesla. The frequency determination of the oscillations was performed by computer-based Fourier analysis and gave five sets of frequencies, which were studied in {100} and {110} planes. Effective masses and Dingle temperatures of some orbits were measured in the symmetry directions <100>, <110> and <111>. Interpretation of the results has been based on the results of a recent augmented plane wave band structure calculation of Mattheiss (1970). Three of the observed frequency branches can be explained in terms of, and are in good agreement with, the Fermi surface predicted by this calculation. The remaining frequencies can be accounted for, if a slight distortion of the proposed model is made. Comparison of the measured effective masses with those calculated from the band structure gives a value of 2·14 ± 0·17 for the mass enhancement factor due to many body effects. Using the theory of McMillan (1968) we evaluate the superconducting isotope shift coefficient to be 0·24.


2020 ◽  
Vol 64 (3) ◽  
pp. 30502-1-30502-15
Author(s):  
Kensuke Fukumoto ◽  
Norimichi Tsumura ◽  
Roy Berns

Abstract A method is proposed to estimate the concentration of pigments mixed in a painting, using the encoder‐decoder model of neural networks. The model is trained to output a value that is the same as its input, and its middle output extracts a certain feature as compressed information about the input. In this instance, the input and output are spectral data of a painting. The model is trained with pigment concentration as the middle output. A dataset containing the scattering coefficient and absorption coefficient of each of 19 pigments was used. The Kubelka‐Munk theory was applied to the coefficients to obtain many patterns of synthetic spectral data, which were used for training. The proposed method was tested using spectral images of 33 paintings, which showed that the method estimates, with high accuracy, the concentrations that have a similar spectrum of the target pigments.


2021 ◽  
pp. 107754632110082
Author(s):  
Hanbo Shao ◽  
Jincheng He ◽  
Jiang Zhu ◽  
Guoping Chen ◽  
Huan He

Our work investigates a tunable multilayer composite structure for applications in the area of low-frequency absorption. This acoustic device is comprised of three layers, Helmholtz cavity layer, microperforated panel layer, and the porous material layer. For the simulation and experiment in our research, the absorber can fulfill a twofold requirement: the acoustic absorption coefficient can reach near 0.8 in very low frequency (400 Hz) and the range of frequency is very wide (400–3000 Hz). In all its absorption frequency, the average of the acoustic absorption coefficient is over 0.9. Besides, the absorption coefficient can be tunable by the scalable cavity. The multilayer composite structure in our article solved the disadvantages in single material. For example, small absorption coefficient in low frequency in traditional material such as microperforated panel and porous material and narrow reduction frequency range in acoustic metamaterial such as Helmholtz cavity. The design of the composite structure in our article can have more wide application than single material. It can also give us a novel idea to produce new acoustic devices.


Author(s):  
Limin Zhang ◽  
Pengfei Yin ◽  
Jian Wang ◽  
Xing Feng ◽  
Jianwu Dai

2021 ◽  
pp. 2150319
Author(s):  
Li Bo Wang ◽  
Cheng Zhi Ma ◽  
Jiu Hui Wu ◽  
Chong Rui Liu

The underwater acoustic siphon effect is proposed in this work, which aims to reveal the basic physical mechanism of high-efficiency sound absorption in meta-structures composed of multiple detuned units. Furthermore, the influence of the area ratio on the underwater acoustic siphon effect is then investigated by finite element simulation (FES) and theoretical calculation. On this basis, a meta-structure with the maximum absorption coefficient of almost 100% and average absorption coefficient of 80% at 600–1400 Hz is achieved. The underwater acoustic siphon effect could provide a better understanding of high-efficiency sound absorption and offer a new perspective in controlling underwater noises.


Sign in / Sign up

Export Citation Format

Share Document