The relationship between chemical composition and electrical conductivity of some North American micas

1977 ◽  
Vol 55 (3) ◽  
pp. 270-275 ◽  
Author(s):  
J. P. Crine ◽  
A. Friedmann ◽  
M. R. Wertheimer ◽  
A. Yelon
Keyword(s):  
Electrical Conductivity ◽  
Chemical Composition ◽  
Electric Field ◽  
North American ◽  
Room Temperature ◽  
Percolation Model ◽  
The Relationship ◽  
Field Strengths

The electrical conductivity of various North American micas has been measured at room temperature for electric field strengths ranging from 102 to 5 × 104 V cm−1. It is shown that the conductivities observed are consistent with a percolation model in which Fe3+ provides the hopping centers.

Electric field emission and anomalies of electrical conductivity above room temperature in heterogeneous NiO-SnO2 nano-ceramic composites

2020 ◽  
Vol 127 (3) ◽  
pp. 034102 ◽  
Author(s):  
S. Karmakar ◽  
Vanshree Parey ◽  
Chetan D. Mistari ◽  
Ranjit Thapa ◽  
M. A. More ◽  
...  
Keyword(s):  
Electrical Conductivity ◽  
Electric Field ◽  
Field Emission ◽  
Room Temperature ◽  
Ceramic Composites

Variations in the photoconductivity and in the electrical counting properties of diamonds

1956 ◽  
Vol 234 (1198) ◽  
pp. 419-432 ◽  
Keyword(s):  
Electrical Conductivity ◽  
Electric Field ◽  
Hall Effect ◽  
Temperature Effects ◽  
Room Temperature ◽  
Red Light ◽  
Quantitative Relationship ◽  
Charge Carriers ◽  
Light Irradiation ◽  
Hall Effect Measurements

The electrical conductivity produced by β -ray bombardment and by light irradiation in several diamonds was investigated in the temperature range 150 to 500° K. Considerable uniformity was observed in the behaviour of the specimens; all of them polarized strongly in the dark at room temperature, and polarization could be effectively eliminated by pulsing the electric field while maintaining the β -flux. Both the counting response and the photoconductivity increased as the temperature was lowered. This was interpreted as being largely due to an increase in the mobility of the charge carriers at lower temperatures, the quantitative relationship being consistent with Hall effect measurements. Accumulation of polarization was reduced by irradiation with red light or by elevation of temperature; at 420° K little sign of polarization remained. From various temperature effects, the thermal depths of the trapping levels in these diamonds were estimated at 0⋅6, 0⋅8 and 1 eV.

Electric Field Induced Light Emission and Conductance-Loss Transients in Liquid Anthracene

1974 ◽  
Vol 52 (20) ◽  
pp. 3559-3561 ◽  
Author(s):  
Kyoji Shinsaka ◽  
Gordon R. Freeman
Keyword(s):  
Electrical Conductivity ◽  
Electric Field ◽  
Semiconductor Laser ◽  
Laser Emission ◽  
Light Emission ◽  
Average Frequency ◽  
Frequency Of Occurrence ◽  
High Electrical Conductivity ◽  
Field Strengths

Liquid anthracene has an unusually high electrical conductivity for a hydrocarbon, being 2 × 10−1 mho cm−1 at 507 K. At electric field strengths above 3 kV/cm the conductance suffers transient decreases that last <3 μs and are irregularly spaced in time. The average frequency of occurrence and magnitude of the transients increase rapidly with increasing field above the threshold. The conductance loss transients are accompanied by emission of light. These phenomena may be related to that of semiconductor laser emission.

Thermomechanical Treatment of a 4340 Ni-Cr-Mo Alloy Steel

1981 ◽  
Vol 39 ◽  
pp. 314-315 ◽  
Author(s):  
M.T. Jahn ◽  
J.C. Yang ◽  
C.M. Wan
Keyword(s):  
Mechanical Property ◽  
Chemical Composition ◽  
Alloy Steel ◽  
Thermomechanical Treatment ◽  
Room Temperature ◽  
Good Combination ◽  
Thermal Treatments ◽  
Low Carbon ◽  
4340 Steel ◽  
Good Improvement

4340 Ni-Cr-Mo alloy steel is widely used due to its good combination of strength and toughness. The mechanical property of 4340 steel can be improved by various thermal treatments. The influence of thermomechanical treatment (TMT) has been studied in a low carbon Ni-Cr-Mo steel having chemical composition closed to 4340 steel. TMT of 4340 steel is rarely examined up to now. In this study we obtain good improvement on the mechanical property of 4340 steel by TMT. The mechanism is explained in terms of TEM microstructures4340 (0.39C-1.81Ni-0.93Cr-0.26Mo) steel was austenitized at 950°C for 30 minutes. The TMTed specimen (T) was obtained by forging the specimen continuously as the temperature of the specimen was decreasing from 950°C to 600°C followed by oil quenching to room temperature. The thickness reduction ratio by forging is 40%. The conventional specimen (C) was obtained by quenching the specimen directly into room temperature oil after austenitized at 950°C for 30 minutes. All quenched specimens (T and C) were then tempered at 450, 500, 550, 600 or 650°C for four hours respectively.

Application Of Electron Probe Analyses Of Minerals In Discussing The Relationship Between Ductile Deformation And Metamorphism

1990 ◽  
Vol 48 (2) ◽  
pp. 250-251
Author(s):  
Fan Guochuan ◽  
Sun Zhongshi
Keyword(s):  
Chemical Composition ◽  
Shear Deformation ◽  
Electron Probe ◽  
General Rule ◽  
Granulite Facies ◽  
Ductile Deformation ◽  
Higher Temperature ◽  
Ductile Shear ◽  
The Relationship ◽  
Ductile Shear Deformation

Under influence of ductile shear deformation, granulite facies mineral paragenesis underwent metamorphism and changes in chemical composition. The present paper discusses some changes in chemical composition of garnet in hypers thene_absent felsic gnesiss and of hypersthene in rock in early and late granulite facies undergone increasing ductile shear deformation .In garnet fetsic geniss, band structures were formed because of partial melting and resulted in zoning from massive⟶transitional⟶melanocrate zones in increasing deformed sequence. The electron-probe analyses for garnet in these zones are listed in table 1 . The Table shows that Mno, Cao contents in garnet decrease swiftly from slightly to intensely deformed zones.In slightly and moderately deformed zones, Mgo contents keep unchanged and Feo is slightly lower. In intensely deformed zone, Mgo contents increase, indicating a higher temperature. This is in accord with the general rule that Mgo contents in garnet increase with rising temperature.

Analysis of Retention Time Degradation Caused by Electrostatic Potential Variation between Adjacent Bit-Line and Adjacent Contact Node in DRAM

2016 ◽  
Author(s):  
Jungil Mok ◽  
Byungki Kang ◽  
Daesun Kim ◽  
Hongsun Hwang ◽  
Sangjae Rhee ◽  
...  
Keyword(s):  
Electric Field ◽  
Electrostatic Potential ◽  
Critical Dimension ◽  
Data Retention ◽  
Signal Line ◽  
Adjacent Node ◽  
Storage Node ◽  
Retention Characteristics ◽  
Node Voltage ◽  
The Relationship

Abstract Systematic retention failure related on the adjacent electrostatic potential is studied with sub 20nm DRAM. Unlike traditional retention failures which are caused by gate induced drain leakage or junction leakage, this failure is influenced by the combination of adjacent signal line and adjacent contact node voltage. As the critical dimension between adjacent active and the adjacent signal line and contact node is scaled down, the effect of electric field caused by adjacent node on storage node is increased gradually. In this paper, we will show that the relationship between the combination electric field of adjacent nodes and the data retention characteristics and we will demonstrate the mechanism based on the electrical analysis and 3D TCAD simulation simultaneously.

Growth and Mineral Nutrition in Salt Stressed Guava ( Psidium guajava L.) cv . Allahabad Safeda

2016 ◽  
Vol 3 (1) ◽  
Author(s):  
ANSHUMAN SINGH ◽  
ASHWANI KUMAR ◽  
R.K. YADAV ◽  
ASHIM DUTTA ◽  
D.K. SHARMA
Keyword(s):  
Electrical Conductivity ◽  
Chemical Composition ◽  
Plant Height ◽  
Salinity Tolerance ◽  
Soil Ph ◽  
High Salinity ◽  
Psidium Guajava ◽  
Sodium Adsorption Ratio ◽  
Saline Soils ◽  
Experimental Soil

Guav a cv . Allahabad Safeda w as grown in saline soils and irrigated with the best av ailable w ater -1 -1 + -1 (EC 2.8 dS m ). Based on chemical composition (pH- 7.1, EC - 2.8 dS m , Na - 20.04 meq l and IW IW sodium adsorption ratio- 4.86), irrigation w ater w as categorized as marginally saline. The soil pH 2 -1 w as mostly below 8.5 but mean electrical conductivity (EC ) v alues ranged from 0.5-2 dS m 2 indicating moderate to high salinity in the experimental soil. After one-y ear of experimentation, fiv e plants randomly selected from each treatment and the data w ere recorded. Plant height -1 -1 significantly increased (LSD 5%) with increase in salinity from 0.5 dS m to 1.4 dS m . A similar -1 trend w as noted with respect to stem girth. The av erage plant height at 0.5, 0.9 and 1.4 dS m salinity lev els w as 98.3 cm, 108.3 cm and 123 cm, respectiv ely whereas the corresponding stem girth v alues -1 w ere 2.24 cm, 2.28 cm and 2.46 cm. At 2 dS m salinity ,how ev er , both av erage plant height (94.6 cm) and stem girth (2.24 cm) significantly decreased and w ere found to be comparable to control (0.5 dS -1 + -1 m ) v alues. Plants show ed negligible Na accumulation in leav es up to 1.4 dS m salinity , but -1 + exposure to elev ated salinity (2 dS m ) significantly increased leaf Na (0.16% DW). These data -1 indicated a salinity tolerance (EC )threshold of about 1.5 dS m inguav a cultiv ar Allahabad Safeda.

scholarly journals A Risk-Based Approach to Assess the Operational Resilience of Transmission Grids

2020 ◽  
Vol 10 (14) ◽  
pp. 4761
Author(s):  
Milorad Papic ◽  
Svetlana Ekisheva ◽  
Eduardo Cotilla-Sanchez
Keyword(s):  
Power System ◽  
North American ◽  
Response Times ◽  
Transmission System ◽  
Energy Delivery ◽  
The North ◽  
System Components ◽  
Bulk Power ◽  
Definition Of ◽  
The Relationship

Modern risk analysis studies of the power system increasingly rely on big datasets, either synthesized, simulated, or real utility data. Particularly in the transmission system, outage events have a strong influence on the reliability, resilience, and security of the overall energy delivery infrastructure. In this paper we analyze historical outage data for transmission system components and discuss the implications of nearby overlapping outages with respect to resilience of the power system. We carry out a risk-based assessment using North American Electric Reliability Corporation (NERC) Transmission Availability Data System (TADS) for the North American bulk power system (BPS). We found that the quantification of nearby unscheduled outage clusters would improve the response times for operators to readjust the system and provide better resilience still under the standard definition of N-1 security. Finally, we propose future steps to investigate the relationship between clusters of outages and their electrical proximity, in order to improve operator actions in the operation horizon.

Processing by Pulsed Laser Deposition and Structural, Morphological and Chemical Characterization of Bi-Pb-Sr-Ca-Cu-O and Bi-Pb-Sb-Sr-Ca-Cu-O Thin Films

2010 ◽  
Vol 75 ◽  
pp. 202-207
Author(s):  
Victor Ríos ◽  
Elvia Díaz-Valdés ◽  
Jorge Ricardo Aguilar ◽  
T.G. Kryshtab ◽  
Ciro Falcony
Keyword(s):  
Thin Films ◽  
Pulsed Laser Deposition ◽  
Room Temperature ◽  
Pulsed Laser ◽  
Chemical Characterization ◽  
Laser Deposition ◽  
Nominal Composition ◽  
Deposition Parameters ◽  
The Relationship

Bi-Pb-Sr-Ca-Cu-O (BPSCCO) and Bi-Pb-Sb-Sr-Ca-Cu-O (BPSSCCO) thin films were grown on MgO single crystal substrates by pulsed laser deposition. The deposition was carried out at room temperature during 90 minutes. A Nd:YAG excimer laser ( = 355 nm) with a 2 J/pulse energy density operated at 30 Hz was used. The distance between the target and substrate was kept constant at 4,5 cm. Nominal composition of the targets was Bi1,6Pb0,4Sr2Ca2Cu3O and Bi1,6Pb0,4Sb0,1Sr2Ca2Cu3OSuperconducting targets were prepared following a state solid reaction. As-grown films were annealed at different conditions. As-grown and annealed films were characterized by XRD, FTIR, and SEM. The films were prepared applying an experimental design. The relationship among deposition parameters and their effect on the formation of superconducting Bi-system crystalline phases was studied.

Sign in / Sign up

Export Citation Format

Share Document