Kinetics of ammonia oxidation on cobalt catalyst II application of tubular reactor with catalytically active wall

1982 ◽  
Vol 47 (8) ◽  
pp. 2097-2109 ◽  
Author(s):  
Bohumil Bernauer ◽  
Antonín Šimeček ◽  
Jan Vosolsobě
Keyword(s):  
Experimental Data ◽  
Nitrogen Dioxide ◽  
Cobalt Catalyst ◽  
Ammonia Oxidation ◽  
Tubular Reactor ◽  
Nitrogen Monoxide ◽  
Empirical Equations ◽  
Catalytically Active ◽  
Kinetics Of ◽  
Elementary Nitrogen

The kinetics of ammonia oxidation on cobalt catalyst is described on basis of experimental data measured in the tubular reactor with catalytically active wall. In the temperature range up to 623 K, where the products of ammonia oxidation are nitrogen monoxide and elementary nitrogen, it is possible to describe the rate of formation of these components by empirical equations (5) and (6), at the temperature above 900 K, where the products are nitrogen dioxide and elementary nitrogen, by equations (7) and (8).

Kinetics of oxidation of ammonia on cobalt catalyst I model of the reactor with catalytically active wall

1982 ◽  
Vol 47 (8) ◽  
pp. 2087-2096 ◽  
Author(s):  
Bohumil Bernauer ◽  
Antonín Šimeček ◽  
Jan Vosolsobě
Keyword(s):  
Parabolic Equations ◽  
Cobalt Catalyst ◽  
Nonlinear Parabolic Equations ◽  
Catalytic Reactions ◽  
Temperature Profiles ◽  
Dimensional Model ◽  
Kinetics Of Oxidation ◽  
Nonlinear Parabolic ◽  
Catalytically Active ◽  
Kinetics Of

A two dimensional model of a tabular reactor with the catalytically active wall has been proposed in which several exothermic catalytic reactions take place. The derived dimensionless equations enable evaluation of concentration and temperature profiles on the surface of the active component. The resulting nonlinear parabolic equations have been solved by the method of orthogonal collocations.

Mathematical Modeling of Drying Kinetics of Salted Otolithes Ruber at the Different Temperature

2013 ◽  
Vol 781-784 ◽  
pp. 1347-1352 ◽  
Author(s):  
Yan Yan Wu ◽  
Zhong Yang Ren ◽  
Lai Hao Li ◽  
Xian Qing Yang ◽  
Wan Ling Lin ◽  
...  
Keyword(s):  
Mathematical Modeling ◽  
Experimental Data ◽  
Suitable Model ◽  
Empirical Equations ◽  
Thin Layer Drying ◽  
Electric Oven ◽  
Otolithes Ruber ◽  
Predicted Values ◽  
Semi Empirical ◽  
Kinetics Of

Salted Otolithes ruber with 80 (±5) g weight on dry basis were dried in the blast electric oven using different temperature (20, 30, 40 and 50°C) until the humidity fell down to 0.6 from 1.23 on dry basis. Drying processes were completed between 20-48h. In this study, experiment values were compared with predicted values obtained from twenty thin layer drying theoretical/ semi-empirical/ empirical equations. Models whose coefficient of correlation (R2) values are highest were chosen to be the best models. According to this, Midillis Model was defined as the most suitable model in which predicted value is closest to experimental data for 20°C level, Weibulls model was for 30°C level, Weibull distributions model was for 40°C level and Alibas model was for 50°C level.

A fuzzy neural network approach for modeling the growth kinetics of FeB and Fe2B layers during the boronizing process

2018 ◽  
Vol 106 (6) ◽  
pp. 603 ◽  
Author(s):  
Bendaoud Mebarek ◽  
Mourad Keddam
Keyword(s):  
Neural Network ◽  
Experimental Data ◽  
Fuzzy Neural Network ◽  
Treatment Time ◽  
Calculation Model ◽  
Average Error ◽  
Network Approach ◽  
Neural Network Approach ◽  
Fuzzy Neural ◽  
Kinetics Of

In this paper, we develop a boronizing process simulation model based on fuzzy neural network (FNN) approach for estimating the thickness of the FeB and Fe2B layers. The model represents a synthesis of two artificial intelligence techniques; the fuzzy logic and the neural network. Characteristics of the fuzzy neural network approach for the modelling of boronizing process are presented in this study. In order to validate the results of our calculation model, we have used the learning base of experimental data of the powder-pack boronizing of Fe-15Cr alloy in the temperature range from 800 to 1050 °C and for a treatment time ranging from 0.5 to 12 h. The obtained results show that it is possible to estimate the influence of different process parameters. Comparing the results obtained by the artificial neural network to experimental data, the average error generated from the fuzzy neural network was 3% for the FeB layer and 3.5% for the Fe2B layer. The results obtained from the fuzzy neural network approach are in agreement with the experimental data. Finally, the utilization of fuzzy neural network approach is well adapted for the boronizing kinetics of Fe-15Cr alloy.

Features of the kinetics of cyclic elastoplastic deformation diagrams at dwells in cycles and superimposition of variable stresses on them

2020 ◽  
Vol 86 (12) ◽  
pp. 46-53
Author(s):  
M. M. Gadenin
Keyword(s):  
Experimental Data ◽  
Elastoplastic Deformation ◽  
Low Cycle Fatigue ◽  
Cycle Fatigue ◽  
Loading Cycle ◽  
Additional Variable ◽  
Dynamic Creep ◽  
Variable Stresses ◽  
Kinetics Of ◽  
Deformation Diagrams

The goal of the study is determination of the regularities of changes in cyclic strains and related deformation diagrams attributed to the existence of time dwells in the loading modes and imposition of additional variable stresses on them. Analysis of the obtained experimental data on the kinetics of cyclic elastoplastic deformation diagrams and their parameters revealed that in contrast to regular cyclic loading (equal in stresses), additional deformations of static and dynamic creep are developed. The results of the studys are especially relevant for assessing the cyclic strength of unique extremely loaded objects of technology, including nuclear power equipment, units of aviation and space systems, etc. The experiments were carried out on the samples of austenitic stainless steel under low-cycle loading and high temperatures of testing. Static and dynamic creep deformations arising under those loading conditions promote an increase in the range of cyclic plastic strain in each loading cycle and also stimulate an increase in the range of elastoplastic strain due to active cyclic deformation. At the same time the existence of dwells on extrema of stresses in cycles without imposition of additional variable stresses on them most strongly affects the growth of plastic strain ranges in cycles. Imposition of additional variable stresses on dwells also results in the development of creep strains, but their growth turns out to be somewhat less than in the presence of dwells without stresses imposed. The diagrams of cyclic deformation obtained in the experiments are approximated by power dependences, their kinetics being described in terms of the number of loading cycles using corresponding temperature-time functions. At the same time, it is shown that increase in the cyclic plastic deformation for cycles with dwells and imposition of additional variable stresses on them decreases low cycle fatigue life compared to regular loading without dwells at the same stress amplitudes, moreover, the higher the values of static and dynamic creep, the greater decrease in low-cycle fatigue life. This conclusion results from experimental data and analysis of conditions of damage accumulation for the considered forms of the loading cycle using the deformation criterion of reaching the limit state leading to fracture.

Effect of ionizing radiation on the kinetics of hydrogenation on the Ni-MgO mixed catalyst

1982 ◽  
Vol 47 (7) ◽  
pp. 1780-1786 ◽  
Author(s):  
Rostislav Kudláček ◽  
Jan Lokoč
Keyword(s):  
Experimental Data ◽  
Activation Energy ◽  
Liquid Phase ◽  
Ionizing Radiation ◽  
Oxide Catalyst ◽  
Absorbed Dose ◽  
Hydrogenation Rate ◽  
Solution Composition ◽  
Mixed Catalyst ◽  
Kinetics Of

The effect of gamma pre-irradiation of the mixed nickel-magnesium oxide catalyst on the kinetics of hydrogenation of maleic acid in the liquid phase has been studied. The changes of the hydrogenation rate are compared with the changes of the adsorbed amount of the acid and with the changes of the solution composition, activation energy, and absorbed dose of the ionizing radiation. From this comparison and from the interpretation of the experimental data it can be deduced that two types of centers can be distinguished on the surface of the catalyst under study, namely the sorption centres for the acid and hydrogen and the reaction centres.

Kinetics of the Crystallization of Potassium Sulfate

1993 ◽  
Vol 58 (8) ◽  
pp. 1848-1854 ◽  
Author(s):  
Miroslav Karel ◽  
Jaroslav Nývlt
Keyword(s):  
Experimental Data ◽  
Crystal Growth ◽  
Growth Rates ◽  
Potassium Sulfate ◽  
Kinetics Of

The kinetics of the crystallization of potassium sulfate has been determined using the MSMPR technique. Values of the nucleation and crystal growth rates evaluated from the experimental data are compared with the corresponding literature data.

Diffusion model for deposition of epitaxial GaAs layers prepared by the MOCVD method

1991 ◽  
Vol 56 (10) ◽  
pp. 2020-2029
Author(s):  
Jindřich Leitner ◽  
Petr Voňka ◽  
Josef Stejskal ◽  
Přemysl Klíma ◽  
Rudolf Hladina
Keyword(s):  
Experimental Data ◽  
Growth Rate ◽  
Kinetic Model ◽  
Gas Phase ◽  
Substrate Surface ◽  
Deposition Process ◽  
Hydrogen Atmosphere ◽  
Epitaxial Gaas ◽  
Kinetics Of ◽  
Good Agreement

The authors proposed and treated quantitatively a kinetic model for deposition of epitaxial GaAs layers prepared by reaction of trimethylgallium with arsine in hydrogen atmosphere. The transport of gallium to the surface of the substrate is considered as the controlling process. The influence of the rate of chemical reactions in the gas phase and on the substrate surface on the kinetics of the deposition process is neglected. The calculated dependence of the growth rate of the layers on the conditions of the deposition is in a good agreement with experimental data in the temperature range from 600 to 800°C.

Kinetic analysis of mechanism of intestinal Na+-dependent sugar transport

1985 ◽  
Vol 248 (5) ◽  
pp. C498-C509 ◽  
Author(s):  
D. Restrepo ◽  
G. A. Kimmich
Keyword(s):  
Experimental Data ◽  
Steady State ◽  
Sugar Transport ◽  
Enzyme Kinetic ◽  
Steady State Distribution ◽  
State Distribution ◽  
Least Squares Fit ◽  
Coupling Stoichiometry ◽  
Rate Limiting ◽  
Kinetics Of

Zero-trans kinetics of Na+-sugar cotransport were investigated. Sugar influx was measured at various sodium and sugar concentrations in K+-loaded cells treated with rotenone and valinomycin. Sugar influx follows Michaelis-Menten kinetics as a function of sugar concentration but not as a function of Na+ concentration. Nine models with 1:1 or 2:1 sodium:sugar stoichiometry were considered. The flux equations for these models were solved assuming steady-state distribution of carrier forms and that translocation across the membrane is rate limiting. Classical enzyme kinetic methods and a least-squares fit of flux equations to the experimental data were used to assess the fit of the different models. Four models can be discarded on this basis. Of the remaining models, we discard two on the basis of the trans sodium dependence and the coupling stoichiometry [G. A. Kimmich and J. Randles, Am. J. Physiol. 247 (Cell Physiol. 16): C74-C82, 1984]. The remaining models are terter ordered mechanisms with sodium debinding first at the trans side. If transfer across the membrane is rate limiting, the binding order can be determined to be sodium:sugar:sodium.

Sign in / Sign up

Export Citation Format

Share Document