Kinetics of the Crystallization of Potassium Sulfate

1993 ◽  
Vol 58 (8) ◽  
pp. 1848-1854 ◽  
Author(s):  
Miroslav Karel ◽  
Jaroslav Nývlt
Keyword(s):  
Experimental Data ◽  
Crystal Growth ◽  
Growth Rates ◽  
Potassium Sulfate ◽  
Kinetics Of

The kinetics of the crystallization of potassium sulfate has been determined using the MSMPR technique. Values of the nucleation and crystal growth rates evaluated from the experimental data are compared with the corresponding literature data.

Research on Crystallization Kinetics of Calcium Sulfate Dihydrate Prepared by Bittern under 20°C and 120r/min Condition

2014 ◽  
Vol 926-930 ◽  
pp. 210-213
Author(s):  
Bi Jun Luo ◽  
Hai Hong Wu ◽  
Yu Qi Wang ◽  
Qi Zhang
Keyword(s):  
Experimental Data ◽  
Crystal Growth ◽  
Crystallization Kinetics ◽  
Residence Time ◽  
Calcium Sulfate ◽  
Nucleation Density ◽  
Growth Line ◽  
Calcium Sulfate Dihydrate ◽  
Kinetics Of

Crystallization kinetics experiment of calcium sulfate dehydrates, which is prepared by bittern under 20°C and 120r/min conditions, is carried out. According to the results of the experimental data, nucleation densityn0of gypsum crystals is proportional to the residence time, and the rate of crystal growth lineGis inversely proportional to the residence time. Meanwhile, the crystallization kinetics formula is derived to be:B0= 5.78×102G0.87.

Improved Measurement of the Kinetics of Crystallization in a Batch Experiment

1993 ◽  
Vol 58 (8) ◽  
pp. 1839-1847 ◽  
Author(s):  
Jaroslav Nývlt ◽  
Miloslav Karel
Keyword(s):  
Experimental Data ◽  
Crystal Size ◽  
Evaluation Method ◽  
Potassium Sulfate ◽  
Batch Experiment ◽  
Improved Method ◽  
Short Intervals ◽  
Wide Range ◽  
Kinetics Of ◽  
Single Batch

An improved method is described whereby knowledge of the supersaturation course during a run and measurement of the final product crystal size distribution yield the growth rate of crystals and the nucleation rate in a wide range of supersaturations from only a single batch experiment. The evaluation method is refined by the interpolation of experimental data for short intervals of time. The method is illustrated using potassium sulfate crystallization as an example.

Understanding the fast crystallization kinetics of In–Sb–Te by using ultrafast calorimetry

CrystEngComm ◽  
2018 ◽  
Vol 20 (2) ◽  
pp. 159-163 ◽  
Author(s):  
Sen Mu ◽  
Yimin Chen ◽  
Hongbo Pan ◽  
Guoxiang Wang ◽  
Junqiang Wang ◽  
...  
Keyword(s):  
Crystal Growth ◽  
Phase Change ◽  
Crystallization Kinetics ◽  
Growth Rates ◽  
Phase Change Materials ◽  
Supercooled Liquids ◽  
Kinetics Of

The crystal growth rates of supercooled liquids In–Sb–Te can be well characterized by ultrafast DSC, and it benefits to the optimization for phase-change materials.

A fuzzy neural network approach for modeling the growth kinetics of FeB and Fe2B layers during the boronizing process

2018 ◽  
Vol 106 (6) ◽  
pp. 603 ◽  
Author(s):  
Bendaoud Mebarek ◽  
Mourad Keddam
Keyword(s):  
Neural Network ◽  
Experimental Data ◽  
Fuzzy Neural Network ◽  
Treatment Time ◽  
Calculation Model ◽  
Average Error ◽  
Network Approach ◽  
Neural Network Approach ◽  
Fuzzy Neural ◽  
Kinetics Of

In this paper, we develop a boronizing process simulation model based on fuzzy neural network (FNN) approach for estimating the thickness of the FeB and Fe2B layers. The model represents a synthesis of two artificial intelligence techniques; the fuzzy logic and the neural network. Characteristics of the fuzzy neural network approach for the modelling of boronizing process are presented in this study. In order to validate the results of our calculation model, we have used the learning base of experimental data of the powder-pack boronizing of Fe-15Cr alloy in the temperature range from 800 to 1050 °C and for a treatment time ranging from 0.5 to 12 h. The obtained results show that it is possible to estimate the influence of different process parameters. Comparing the results obtained by the artificial neural network to experimental data, the average error generated from the fuzzy neural network was 3% for the FeB layer and 3.5% for the Fe2B layer. The results obtained from the fuzzy neural network approach are in agreement with the experimental data. Finally, the utilization of fuzzy neural network approach is well adapted for the boronizing kinetics of Fe-15Cr alloy.

Features of the kinetics of cyclic elastoplastic deformation diagrams at dwells in cycles and superimposition of variable stresses on them

2020 ◽  
Vol 86 (12) ◽  
pp. 46-53
Author(s):  
M. M. Gadenin
Keyword(s):  
Experimental Data ◽  
Elastoplastic Deformation ◽  
Low Cycle Fatigue ◽  
Cycle Fatigue ◽  
Loading Cycle ◽  
Additional Variable ◽  
Dynamic Creep ◽  
Variable Stresses ◽  
Kinetics Of ◽  
Deformation Diagrams

The goal of the study is determination of the regularities of changes in cyclic strains and related deformation diagrams attributed to the existence of time dwells in the loading modes and imposition of additional variable stresses on them. Analysis of the obtained experimental data on the kinetics of cyclic elastoplastic deformation diagrams and their parameters revealed that in contrast to regular cyclic loading (equal in stresses), additional deformations of static and dynamic creep are developed. The results of the studys are especially relevant for assessing the cyclic strength of unique extremely loaded objects of technology, including nuclear power equipment, units of aviation and space systems, etc. The experiments were carried out on the samples of austenitic stainless steel under low-cycle loading and high temperatures of testing. Static and dynamic creep deformations arising under those loading conditions promote an increase in the range of cyclic plastic strain in each loading cycle and also stimulate an increase in the range of elastoplastic strain due to active cyclic deformation. At the same time the existence of dwells on extrema of stresses in cycles without imposition of additional variable stresses on them most strongly affects the growth of plastic strain ranges in cycles. Imposition of additional variable stresses on dwells also results in the development of creep strains, but their growth turns out to be somewhat less than in the presence of dwells without stresses imposed. The diagrams of cyclic deformation obtained in the experiments are approximated by power dependences, their kinetics being described in terms of the number of loading cycles using corresponding temperature-time functions. At the same time, it is shown that increase in the cyclic plastic deformation for cycles with dwells and imposition of additional variable stresses on them decreases low cycle fatigue life compared to regular loading without dwells at the same stress amplitudes, moreover, the higher the values of static and dynamic creep, the greater decrease in low-cycle fatigue life. This conclusion results from experimental data and analysis of conditions of damage accumulation for the considered forms of the loading cycle using the deformation criterion of reaching the limit state leading to fracture.

Effect of ionizing radiation on the kinetics of hydrogenation on the Ni-MgO mixed catalyst

1982 ◽  
Vol 47 (7) ◽  
pp. 1780-1786 ◽  
Author(s):  
Rostislav Kudláček ◽  
Jan Lokoč
Keyword(s):  
Experimental Data ◽  
Activation Energy ◽  
Liquid Phase ◽  
Ionizing Radiation ◽  
Oxide Catalyst ◽  
Absorbed Dose ◽  
Hydrogenation Rate ◽  
Solution Composition ◽  
Mixed Catalyst ◽  
Kinetics Of

The effect of gamma pre-irradiation of the mixed nickel-magnesium oxide catalyst on the kinetics of hydrogenation of maleic acid in the liquid phase has been studied. The changes of the hydrogenation rate are compared with the changes of the adsorbed amount of the acid and with the changes of the solution composition, activation energy, and absorbed dose of the ionizing radiation. From this comparison and from the interpretation of the experimental data it can be deduced that two types of centers can be distinguished on the surface of the catalyst under study, namely the sorption centres for the acid and hydrogen and the reaction centres.

Comparison of copper sulphate pentahydrate growth rates determined by different methods

1990 ◽  
Vol 55 (7) ◽  
pp. 1691-1707 ◽  
Author(s):  
Miloslav Karel ◽  
Jiří Hostomský ◽  
Jaroslav Nývlt ◽  
Axel König
Keyword(s):  
Growth Rate ◽  
Crystal Growth ◽  
Fluidized Bed ◽  
Growth Rates ◽  
Copper Sulphate ◽  
Crystal Growth Rate ◽  
Effect Of Temperature ◽  
Rotating Disc ◽  
Shape Factors ◽  
Data Treatment

Crystal growth rates of copper sulphate pentahydrate (CuSO4.5 H2O) determined by different authors and methods are compared. The methods included in this comparison are: (i) Measurement on a fixed crystal suspended in a streaming solution, (ii) measurement on a rotating disc, (iii) measurement in a fluidized bed, (iv) measurement in an agitated suspension. The comparison involves critical estimation of the supersaturation used in measurements, of shape factors used for data treatment and a correction for the effect of temperature. Conclusions are drawn for the choice of values to be specified when data of crystal growth rate measurements are published.

Diffusion model for deposition of epitaxial GaAs layers prepared by the MOCVD method

1991 ◽  
Vol 56 (10) ◽  
pp. 2020-2029
Author(s):  
Jindřich Leitner ◽  
Petr Voňka ◽  
Josef Stejskal ◽  
Přemysl Klíma ◽  
Rudolf Hladina
Keyword(s):  
Experimental Data ◽  
Growth Rate ◽  
Kinetic Model ◽  
Gas Phase ◽  
Substrate Surface ◽  
Deposition Process ◽  
Hydrogen Atmosphere ◽  
Epitaxial Gaas ◽  
Kinetics Of ◽  
Good Agreement

The authors proposed and treated quantitatively a kinetic model for deposition of epitaxial GaAs layers prepared by reaction of trimethylgallium with arsine in hydrogen atmosphere. The transport of gallium to the surface of the substrate is considered as the controlling process. The influence of the rate of chemical reactions in the gas phase and on the substrate surface on the kinetics of the deposition process is neglected. The calculated dependence of the growth rate of the layers on the conditions of the deposition is in a good agreement with experimental data in the temperature range from 600 to 800°C.

Kinetic analysis of mechanism of intestinal Na+-dependent sugar transport

1985 ◽  
Vol 248 (5) ◽  
pp. C498-C509 ◽  
Author(s):  
D. Restrepo ◽  
G. A. Kimmich
Keyword(s):  
Experimental Data ◽  
Steady State ◽  
Sugar Transport ◽  
Enzyme Kinetic ◽  
Steady State Distribution ◽  
State Distribution ◽  
Least Squares Fit ◽  
Coupling Stoichiometry ◽  
Rate Limiting ◽  
Kinetics Of

Zero-trans kinetics of Na+-sugar cotransport were investigated. Sugar influx was measured at various sodium and sugar concentrations in K+-loaded cells treated with rotenone and valinomycin. Sugar influx follows Michaelis-Menten kinetics as a function of sugar concentration but not as a function of Na+ concentration. Nine models with 1:1 or 2:1 sodium:sugar stoichiometry were considered. The flux equations for these models were solved assuming steady-state distribution of carrier forms and that translocation across the membrane is rate limiting. Classical enzyme kinetic methods and a least-squares fit of flux equations to the experimental data were used to assess the fit of the different models. Four models can be discarded on this basis. Of the remaining models, we discard two on the basis of the trans sodium dependence and the coupling stoichiometry [G. A. Kimmich and J. Randles, Am. J. Physiol. 247 (Cell Physiol. 16): C74-C82, 1984]. The remaining models are terter ordered mechanisms with sodium debinding first at the trans side. If transfer across the membrane is rate limiting, the binding order can be determined to be sodium:sugar:sodium.

Sign in / Sign up

Export Citation Format

Share Document