NORTHERN SAN ANDREAS FAULT SLIP RATES ON THE SANTA CRUZ MOUNTAIN SECTION: 10BE DATING OF AN OFFSET ALLUVIAL FAN COMPLEX, SANBORN COUNTY PARK, SARATOGA, CA

2018 ◽  
Author(s):  
Kimberly Blisniuk ◽  
◽  
Katherine A. Guns ◽  
Roland Burgmann
Geosphere ◽  
2020 ◽  
Author(s):  
Katherine A. Guns ◽  
Richard A Bennett ◽  
Joshua C. Spinler ◽  
Sally F. McGill

Assessing fault-slip rates in diffuse plate boundary systems such as the San Andreas fault in southern California is critical both to characterize seis­mic hazards and to understand how different fault strands work together to accommodate plate boundary motion. In places such as San Gorgonio Pass, the geometric complexity of numerous fault strands interacting in a small area adds an extra obstacle to understanding the rupture potential and behavior of each individual fault. To better understand partitioning of fault-slip rates in this region, we build a new set of elastic fault-block models that test 16 different model fault geometries for the area. These models build on previ­ous studies by incorporating updated campaign GPS measurements from the San Bernardino Mountains and Eastern Transverse Ranges into a newly calculated GPS velocity field that has been removed of long- and short-term postseismic displacements from 12 past large-magnitude earthquakes to estimate model fault-slip rates. Using this postseismic-reduced GPS velocity field produces a best- fitting model geometry that resolves the long-standing geologic-geodetic slip-rate discrepancy in the Eastern California shear zone when off-fault deformation is taken into account, yielding a summed slip rate of 7.2 ± 2.8 mm/yr. Our models indicate that two active strands of the San Andreas system in San Gorgonio Pass are needed to produce sufficiently low geodetic dextral slip rates to match geologic observations. Lastly, results suggest that postseismic deformation may have more of a role to play in affecting the loading of faults in southern California than previously thought.


2020 ◽  
Author(s):  
K.A. Guns ◽  
et al.

<div>Includes tables of statistical details regarding estimation of GPS velocities (including the map position and names of all campaign and continuous station sites) and the full model assessments of fit. Also includes figures that present details of all strike-slip and dip-slip fault-slip rates calculated within models.<br></div>


2020 ◽  
Author(s):  
K.A. Guns ◽  
et al.

<div>Includes tables of statistical details regarding estimation of GPS velocities (including the map position and names of all campaign and continuous station sites) and the full model assessments of fit. Also includes figures that present details of all strike-slip and dip-slip fault-slip rates calculated within models.<br></div>


Geosphere ◽  
2021 ◽  
Author(s):  
Sally F. McGill ◽  
Lewis A. Owen ◽  
Ray J. Weldon ◽  
Katherine J. Kendrick ◽  
Reed J. Burgette

Four new latest Pleistocene slip rates from two sites along the northwestern half of the San Bernardino strand of the San Andreas fault suggest the slip rate decreases southeastward as slip transfers from the Mojave section of the San Andreas fault onto the northern San Jacinto fault zone. At Badger Canyon, offsets coupled with radiocarbon and optically stimulated luminescence (OSL) ages provide three independent slip rates (with 95% confidence intervals): (1) the apex of the oldest dated alluvial fan (ca. 30–28 ka) is right-laterally offset ~300–400 m yielding a slip rate of 13.5 +2.2/−2.5 mm/yr; (2) a terrace riser incised into the northwestern side of this alluvial fan is offset ~280–290 m and was abandoned ca. 23 ka, yielding a slip rate of 11.9 +0.9/−1.2 mm/yr; and (3) a younger alluvial fan (13–15 ka) has been offset 120–200 m from the same source canyon, yielding a slip rate of 11.8 +4.2/−3.5 mm/yr. These rates are all consistent and result in a preferred, time-averaged rate for the past ~28 k.y. of 12.8 +5.3/−4.7 mm/yr (95% confidence interval), with an 84% confidence interval of 10–16 mm/yr. At Matthews Ranch, in Pitman Canyon, ~13 km northwest of Badger Canyon, a landslide offset ~650 m with a 10Be age of ca. 47 ka yields a slip rate of 14.5 +9.9/−6.2 mm/yr (95% confidence interval). All of these slip rates for the San Bernardino strand are significantly slower than a previously published rate of 24.5 ± 3.5 mm/yr at the southern end of the Mojave section of the San Andreas fault (Weldon and Sieh, 1985), suggesting that ~12 mm/yr of slip transfers from the Mojave section of the San Andreas fault to the northern San Jacinto fault zone (and other faults) between Lone Pine Canyon and Badger Canyon, with most (if not all) of this slip transfer happening near Cajon Creek. This has been a consistent behavior of the fault for at least the past ~47 k.y.


2019 ◽  
Author(s):  
Greg Balco ◽  
Kimberly Blisniuk ◽  
Alan Hidy

Abstract. We apply cosmogenic-nuclide burial dating using the 36Cl-in-K-feldspar/10Be-in-quartz pair in fluvially transported granitoid clasts to determine the age of alluvial sediment displaced by the Mission Creek strand of the San Andreas Fault in southern California. Because the half-lives of 36Cl and 10Be are more different than those of the commonly used 26Al/10Be pair, 36Cl/10Be burial dating should be applicable to sediments in the range ca. 0.2–0.5 Ma that are too young to be accurately dated with the 26Al/10Be pair, and should theoretically be more precise for middle and late Pleistocene sediments in general. However, using the 36Cl/10Be pair is more complex because the 36Cl/10Be production ratio varies with the chemical composition of each sample. We use 36Cl/10Be measurements in samples of granodiorite exposed at the surface at present to validate calculations of the 36Cl/10Be production ratio in this lithology, and then apply this information to determine the burial age of alluvial clasts of the same lithology. This particular field area presents the additional obstacle to burial dating (which is not specific to the 36Cl/10Be pair, but would apply to any) that most buried alluvial clasts are derived from extremely rapidly eroding parts of the San Bernardino Mountains and have correspondingly extremely low nuclide concentrations, the majority of which most likely derives from nucleogenic (for 36Cl) and post-burial production. Although this precludes accurate burial dating of many clasts, data from surface and subsurface samples with higher nuclide concentrations, originating from lower-erosion-rate source areas, show that upper Cabezon Formation alluvium is 260 ka. This is consistent with stratigraphic age constraints as well as independent estimates of long-term fault slip rates, and highlights the potential usefulness of the 36Cl/10Be pair for dating upper and middle Pleistocene clastic sediments.


1981 ◽  
Vol 71 (5) ◽  
pp. 1607-1624
Author(s):  
M. Lisowski ◽  
W. H. Prescott

abstract Periodic measurements of fault-crossing networks with a side length of 1 to 3 km are being made to monitor deformation across fault zones in California. The distance measurements are made with a Hewlett-Packard 3800 or 3808 electronic distance meter and have a maximum standard deviation of 5 mm. Deformation measured within networks that span the San Juan Bautista-Cholame segment of the San Andreas fault in central California yields slip rates similar to those measured across a 100- to 300-m-wide zone by repeated alinement array surveys. Fault slip rates increase from near 0 to 32 mm/yr between San Juan Bautista and Bitterwater Valley in step-like increments. From Bitterwater to Slack Canyon slip rates vary between 26 and 32 mm/yr. Slip rates decrease southwestward of Slack Canyon to 3 mm/yr at Cholame. In contrast, Geodolite measurements of deformation across a 20-km-wide zone are consistent from San Juan Bautista to Slack Canyon and imply a 32 ± 2 mm/yr slip rate. Deformation across the Calaveras fault accounts for the difference between Geodolite and near-fault slip rates between San Juan Bautista and Bear Valley, although the zone of deformation is wider than 2.5 km just south of Hollister. At Bear Valley, measurements of a short-range network crossing the Paicines fault imply a slip rate of 10 ± 3 mm/yr during the period 1976 to 1979. From Slack Canyon to Cholame, Geodolite measurements show a constant decrease in the rate of shallow slip.


Geochronology ◽  
2019 ◽  
Vol 1 (1) ◽  
pp. 1-16
Author(s):  
Greg Balco ◽  
Kimberly Blisniuk ◽  
Alan Hidy

Abstract. We apply cosmogenic-nuclide burial dating using the 36Cl-in-K-feldspar∕10Be-in-quartz pair in fluvially transported granitoid clasts to determine the age of alluvial sediment displaced by the Mission Creek strand of the San Andreas Fault in southern California. Because the half-lives of 36Cl and 10Be are more different than those of the commonly used 26Al∕10Be pair, 36Cl∕10Be burial dating should be applicable to sediments in the range ca. 0.2–0.5 Ma, which is too young to be accurately dated with the 26Al∕10Be pair, and should be more precise for Middle and Late Pleistocene sediments in general. However, using the 36Cl∕10Be pair is more complex because the 36Cl∕10Be production ratio varies with the chemical composition of each sample. We use 36Cl∕10Be measurements in samples of granodiorite exposed at the surface at present to validate calculations of the 36Cl∕10Be production ratio in this lithology, and then we apply this information to determine the burial age of alluvial clasts of the same lithology. This particular field area presents the additional obstacle to burial dating (which is not specific to the 36Cl∕10Be pair, but would apply to any) that most buried alluvial clasts are derived from extremely rapidly eroding parts of the San Bernardino Mountains and have correspondingly extremely low nuclide concentrations, the majority of which most likely derive from nucleogenic (for 36Cl) and post-burial production. Although this precludes accurate burial dating of many clasts, data from surface and subsurface samples with higher nuclide concentrations, originating from lower-erosion-rate source areas, show that the age of upper Cabezon Formation alluvium is 260 ka. This is consistent with stratigraphic age constraints as well as independent estimates of long-term fault slip rates, and it highlights the potential usefulness of the 36Cl∕10Be pair for dating Upper and Middle Pleistocene clastic sediments.


Sign in / Sign up

Export Citation Format

Share Document