Position-sensing transition-edge sensors for large-field high-energy-resolution x-ray imaging spectroscopy

2000 ◽  
Author(s):  
Enectali Figueroa-Feliciano ◽  
Caroline K. Stahle ◽  
Fred M. Finkbeiner ◽  
Mary J. Li ◽  
Mark A. Lindeman ◽  
...  
Keyword(s):  
Energy Resolution ◽  
Imaging Spectroscopy ◽  
High Energy ◽  
Transition Edge Sensors ◽  
Large Field ◽  
High Energy Resolution ◽  
X Ray ◽  
Position Sensing ◽  
Transition Edge ◽  
X Ray Imaging

Broadband high-energy resolution hard x-ray spectroscopy using transition edge sensors at SPring-8

2021 ◽  
Vol 92 (1) ◽  
pp. 013103
Author(s):  
Shinya Yamada ◽  
Yuto Ichinohe ◽  
Hideyuki Tatsuno ◽  
Ryota Hayakawa ◽  
Hirotaka Suda ◽  
...  
Keyword(s):  
Energy Resolution ◽  
High Energy ◽  
Transition Edge Sensors ◽  
High Energy Resolution ◽  
X Ray ◽  
Transition Edge

scholarly journals High Energy Resolution Hyperspectral X-Ray Imaging for Low-Dose Contrast-Enhanced Digital Mammography

2017 ◽  
Vol 36 (9) ◽  
pp. 1784-1795 ◽  
Author(s):  
Silvia Pani ◽  
Sarene C. Saifuddin ◽  
Filipa I.M. Ferreira ◽  
Nicholas Henthorn ◽  
Paul Seller ◽  
...  
Keyword(s):  
Energy Resolution ◽  
Digital Mammography ◽  
Low Dose ◽  
High Energy ◽  
High Energy Resolution ◽  
X Ray ◽  
X Ray Imaging ◽  
Contrast Enhanced

CORRELATION OF CRITICAL TEMPERATURES AND ELECTRICAL PROPERTIES IN TITANIUM FILMS

2003 ◽  
Vol 17 (04n06) ◽  
pp. 948-952 ◽  
Author(s):  
C. GANDINI ◽  
V. LACQUANITI ◽  
E. MONTICONE ◽  
C. PORTESI ◽  
M. RAJTERI ◽  
...  
Keyword(s):  
High Energy ◽  
Transition Edge Sensors ◽  
High Energy Resolution ◽  
Critical Temperatures ◽  
X Ray ◽  
Silicon Nitride Films ◽  
Transition Edge ◽  
Electrical Resistivities ◽  
Different Thickness ◽  
Deposition Substrate

Recently transition-edge sensors (TES) have obtained an increasing interest as light detectors due to their high energy resolution and broadband response. Titanium (Ti), with transition temperature up to 0.5 K, is among the suitable materials for TES application. In this work we investigate Ti films obtained from two materials of different purity deposited by e-gun on silicon nitride. Films with different thickness and deposition substrate temperature have been measured. Critical temperatures, electrical resistivities and structural properties obtained from x-ray are related to each other.

New Science Case for the Micro-X High Energy Resolution Microcalorimeter X-ray Imaging Rocket

2009 ◽  
Author(s):  
E. Figueroa-Feliciano ◽  
J. S. Adams ◽  
R. Baker ◽  
S. R. Bandler ◽  
T. A. DeLaney ◽  
...  
Keyword(s):  
Energy Resolution ◽  
High Energy ◽  
High Energy Resolution ◽  
X Ray ◽  
New Science ◽  
X Ray Imaging

D2R1: A 2-D X-Ray Detector for CdTe-Based Fine Pitch and High-Energy Resolution Imaging Spectroscopy

2018 ◽  
Vol 65 (7) ◽  
pp. 1408-1415 ◽  
Author(s):  
D. Baudin ◽  
S. Dubos ◽  
O. Gevin ◽  
O. Limousin ◽  
D. Maier ◽  
...  
Keyword(s):  
Energy Resolution ◽  
Imaging Spectroscopy ◽  
High Energy ◽  
High Energy Resolution ◽  
X Ray ◽  
Fine Pitch ◽  
Resolution Imaging

Transition Edge Sensor (TES) X-Ray Detecting System with Sensitivity Correction to Stabilize the Spectrum Peak Center

2014 ◽  
Vol 617 ◽  
pp. 233-236
Author(s):  
Keiichi Tanaka ◽  
Masataka Ohgaki ◽  
Hidekazu Suzuki ◽  
Masakatsu Hasuda ◽  
Masato Yano ◽  
...  
Keyword(s):  
Energy Resolution ◽  
Transition Edge Sensor ◽  
High Energy ◽  
Transition Curve ◽  
High Energy Resolution ◽  
Time Interval ◽  
Heater Power ◽  
X Ray ◽  
Transition Edge ◽  
Superconducting Current

Transition Edge Sensor (TES) is an energy dispersive X-ray detecting system with high energy resolution. The energy resolution of this system depends on the steepness of superconducting transition curve from normal to superconducting state, heat capacitance and the operating temperature. The TES is based on the dilution refrigerator cooled by about 100 mK. The energy resolution is calculated about 1-2 eV for the detector with maximum detecting energy as 10 eV. The energy resolution also depends on the superconducting current flowing through the TES device because the superconducting current is affected by the temperature stability of the refrigerator. The fluctuation of the superconducting current means the fluctuation of the X-ray spectrum peak center. We have developed the sensitivity correction system to stabilize the peak center of the X-ray spectrum. The peak center of X-ray spectrum correlates with heater power to keep the base temperature of TES device at a constant temperature. The peak center of X-ray spectrum is calibrated by monitoring the heater power at constant time interval using the correlation curve between the peak center of X-ray spectrum and heater power.

scholarly journals High-Energy-Resolution Fluorescence-Detected X-ray Absorption of the Q Intermediate of Soluble Methane Monooxygenase

2017 ◽  
Vol 139 (49) ◽  
pp. 18024-18033 ◽  
Author(s):  
Rebeca G. Castillo ◽  
Rahul Banerjee ◽  
Caleb J. Allpress ◽  
Gregory T. Rohde ◽  
Eckhard Bill ◽  
...  
Keyword(s):  
Energy Resolution ◽  
Methane Monooxygenase ◽  
High Energy ◽  
High Energy Resolution ◽  
X Ray ◽  
Soluble Methane Monooxygenase ◽  
X Ray Absorption

scholarly journals High-energy resolution X-ray absorption and emission spectroscopy reveals insight into unique selectivity of La-based nanoparticles for CO2

2015 ◽  
Vol 112 (52) ◽  
pp. 15803-15808 ◽  
Author(s):  
Ofer Hirsch ◽  
Kristina O. Kvashnina ◽  
Li Luo ◽  
Martin J. Süess ◽  
Pieter Glatzel ◽  
...  
Keyword(s):  
Energy Resolution ◽  
Emission Spectroscopy ◽  
High Energy ◽  
Unit Cell ◽  
High Energy Resolution ◽  
Electron Configuration ◽  
Edge Structure ◽  
X Ray ◽  
X Ray Absorption

The lanthanum-based materials, due to their layered structure and f-electron configuration, are relevant for electrochemical application. Particularly, La2O2CO3 shows a prominent chemoresistive response to CO2. However, surprisingly less is known about its atomic and electronic structure and electrochemically significant sites and therefore, its structure–functions relationships have yet to be established. Here we determine the position of the different constituents within the unit cell of monoclinic La2O2CO3 and use this information to interpret in situ high-energy resolution fluorescence-detected (HERFD) X-ray absorption near-edge structure (XANES) and valence-to-core X-ray emission spectroscopy (vtc XES). Compared with La(OH)3 or previously known hexagonal La2O2CO3 structures, La in the monoclinic unit cell has a much lower number of neighboring oxygen atoms, which is manifested in the whiteline broadening in XANES spectra. Such a superior sensitivity to subtle changes is given by HERFD method, which is essential for in situ studying of the interaction with CO2. Here, we study La2O2CO3-based sensors in real operando conditions at 250 °C in the presence of oxygen and water vapors. We identify that the distribution of unoccupied La d-states and occupied O p- and La d-states changes during CO2 chemoresistive sensing of La2O2CO3. The correlation between these spectroscopic findings with electrical resistance measurements leads to a more comprehensive understanding of the selective adsorption at La site and may enable the design of new materials for CO2 electrochemical applications.

Sign in / Sign up

Export Citation Format

Share Document