Interferential filter design with continuously variable refractive index

1998 ◽  
Author(s):  
Andreea Trache ◽  
Voicu Lupei ◽  
Mihai P. Dinca
Keyword(s):  
Refractive Index ◽  
Filter Design ◽  
Interferential Filter

Design and optimization of two dimensional photonic crystal based optical filter

2015 ◽  
Vol 24 (03) ◽  
pp. 1550027 ◽  
Author(s):  
G. Rajalakshmi ◽  
A. Sivanantha Raja ◽  
D. Shanmuga Sundar
Keyword(s):  
Refractive Index ◽  
Photonic Crystal ◽  
Transmission Spectrum ◽  
Filter Design ◽  
Photonic Band Gap ◽  
Fdtd Method ◽  
Optical Filter ◽  
Two Dimensional ◽  
Dimensional Photonic Crystal ◽  
Two Dimensional Photonic Crystal

In this paper, the channel drop filter based on two dimensional photonic crystal is proposed. The structure is made of silicon rods with the refractive index n1 = 3.4641 which are perforated in air with refractive index n2 = 1. The simulation results are obtained using 2D finite difference time domain (FDTD) method. The photonic band gap is calculated by plane wave expansion solver method. Resonant mode of the ring resonator and the filter transmission spectrum is calculated using 2D FDTD method. Full width half maximum (FWHM) bandwidth of the filter at the output transmission spectrum from 1.508 μm to 1.512 μm is 4 nm. The quality factor of the filter is 377.5 and the proposed filter design is around 21 × 15 μm which is suitable for photonic integrated circuits.

TEM characterization of proton-exchanged LiNbO3 optical waveguides

1986 ◽  
Vol 44 ◽  
pp. 480-481
Author(s):  
W. E. Lee
Keyword(s):  
Refractive Index ◽  
Benzoic Acid ◽  
Optical Waveguides ◽  
Total Internal Reflection ◽  
Index Of Refraction ◽  
Optical Measurements ◽  
Lithium Ions ◽  
Wide Channel ◽  
Tem Characterization

An optical waveguide consists of a several-micron wide channel with a slightly different index of refraction than the host substrate; light can be trapped in the channel by total internal reflection.Optical waveguides can be formed from single-crystal LiNbO3 using the proton exhange technique. In this technique, polished specimens are masked with polycrystal1ine chromium in such a way as to leave 3-13 μm wide channels. These are held in benzoic acid at 249°C for 5 minutes allowing protons to exchange for lithium ions within the channels causing an increase in the refractive index of the channel and creating the waveguide. Unfortunately, optical measurements often reveal a loss in waveguiding ability up to several weeks after exchange.

Light microscopy of ceramics

1993 ◽  
Vol 51 ◽  
pp. 908-909
Author(s):  
Walter C. McCrone
Keyword(s):  
Refractive Index ◽  
Light Microscopy ◽  
Light Microscope ◽  
Polarized Light ◽  
Refractive Indices ◽  
Complete Coverage ◽  
The Subject ◽  
Lower Refractive Index

An excellent chapter on this subject by V.D. Fréchette appeared in a book edited by L.L. Hench and R.W. Gould in 1971 (1). That chapter with the references cited there provides a very complete coverage of the subject. I will add a more complete coverage of an important polarized light microscope (PLM) technique developed more recently (2). Dispersion staining is based on refractive index and its variation with wavelength (dispersion of index). A particle of, say almandite, a garnet, has refractive indices of nF = 1.789 nm, nD = 1.780 nm and nC = 1.775 nm. A Cargille refractive index liquid having nD = 1.780 nm will have nF = 1.810 and nC = 1.768 nm. Almandite grains will disappear in that liquid when observed with a beam of 589 nm light (D-line), but it will have a lower refractive index than that liquid with 486 nm light (F-line), and a higher index than that liquid with 656 nm light (C-line).

On the refractive index of rutile

1992 ◽  
Vol 139 (2) ◽  
pp. 163 ◽  
Author(s):  
M.R. Shenoy ◽  
R.M. de la Rue
Keyword(s):  
Refractive Index

Towards optimum multilayer filter design

1991 ◽  
Vol 138 (4) ◽  
pp. 241 ◽  
Author(s):  
T.C. Chen
Keyword(s):  
Filter Design

Modification of optical properties of PC-PBT/Cr2O3 and PC-PBT/CdS nanocomposites by gamma irradiation

2020 ◽  
Vol 92 (2) ◽  
pp. 20402
Author(s):  
Kaoutar Benthami ◽  
Mai ME. Barakat ◽  
Samir A. Nouh
Keyword(s):  
Refractive Index ◽  
Optical Properties ◽  
Band Gap ◽  
Color Difference ◽  
Band Gap Energy ◽  
Polybutylene Terephthalate ◽  
Γ Irradiation ◽  
Gap Energy ◽  
Vis Spectroscopy ◽  
Oxygen Atoms

Nanocomposite (NCP) films of polycarbonate-polybutylene terephthalate (PC-PBT) blend as a host material to Cr2O3 and CdS nanoparticles (NPs) were fabricated by both thermolysis and casting techniques. Samples from the PC-PBT/Cr2O3 and PC-PBT/CdS NCPs were irradiated using different doses (20–110 kGy) of γ radiation. The induced modifications in the optical properties of the γ irradiated NCPs have been studied as a function of γ dose using UV Vis spectroscopy and CIE color difference method. Optical dielectric loss and Tauc's model were used to estimate the optical band gaps of the NCP films and to identify the types of electronic transition. The value of optical band gap energy of PC-PBT/Cr2O3 NCP was reduced from 3.23 to 3.06 upon γ irradiation up to 110 kGy, while it decreased from 4.26 to 4.14 eV for PC-PBT/CdS NCP, indicating the growth of disordered phase in both NCPs. This was accompanied by a rise in the refractive index for both the PC-PBT/Cr2O3 and PC-PBT/CdS NCP films, leading to an enhancement in their isotropic nature. The Cr2O3 NPs were found to be more effective in changing the band gap energy and refractive index due to the presence of excess oxygen atoms that help with the oxygen atoms of the carbonyl group in increasing the chance of covalent bonds formation between the NPs and the PC-PBT blend. Moreover, the color intensity, ΔE has been computed; results show that both the two synthesized NCPs have a response to color alteration by γ irradiation, but the PC-PBT/Cr2O3 has a more response since the values of ΔE achieved a significant color difference >5 which is an acceptable match in commercial reproduction on printing presses. According to the resulting enhancement in the optical characteristics of the developed NCPs, they can be a suitable candidate as activate materials in optoelectronic devices, or shielding sheets for solar cells.

Sign in / Sign up

Export Citation Format

Share Document