A Flow Model for Two-Phase Slug Flow in Horizontal Tubes

1961 ◽  
Vol 83 (4) ◽  
pp. 613-618 ◽  
Author(s):  
E. S. Kordyban
Keyword(s):  
Pressure Drop ◽  
Flow Pattern ◽  
Slug Flow ◽  
Flow Model ◽  
Simplified Model ◽  
Two Phase ◽  
Frictional Pressure Drop ◽  
Horizontal Tubes

The paper presents a construction of a simplified model approximating the actual observed flow pattern. The resulting expressions for frictional pressure drop are found to agree fairly well with the author’s data for steam and water and the data for air and water of other investigators. The similarity with a portion of the Chenoweth-Martin correlation appears to present a logical explanation for the applicability of that correlation to slug flow.

Evaluation of Two-Phase Frictional Pressure Drop Correlations Against Experimental Data

2019 ◽  
Vol 12 (3) ◽  
Author(s):  
Wei Li ◽  
Kunrong Shen ◽  
Boren Zheng ◽  
Xiang Ma ◽  
S. A. Sherif ◽  
...  
Keyword(s):  
Experimental Data ◽  
Pressure Drop ◽  
Mass Flow ◽  
Flow Model ◽  
Saturation Temperature ◽  
Separated Flow ◽  
Outer Diameter ◽  
Two Phase ◽  
Homogeneous Flow ◽  
Frictional Pressure Drop

Abstract Results are presented here from an experimental investigation on tube side two-phase characteristics that took place in four tested tubes—the 1EHT-1, 1EHT-2, 4LB, and smooth tubes. The equivalent outer diameter of the tube was 9.52 mm and the inner diameter was 8.32 mm. Condensation tests were conducted using refrigerant R410A at a saturation temperature of 318 K, over a mass flow range of 150–450 kg m−2 s−1, with inlet and outlet vapor qualities of 0.8 and 0.2, respectively. Evaporation tests were performed at a saturation temperature of 279 K, over a mass flow range of 150–380 kg m−2 s−1, with inlet and outlet vapor qualities of 0.2 and 0.8, respectively. Pressure drop data of the four tested tubes were collected to evaluate five identified prediction correlations based on the separated flow model and the homogeneous flow model. The separated flow approaches presented predictions with average MAEs of 24.9% and 16.4% for condensation and evaporation data, respectively, while the average MAEs of the homogeneous flow model were 31.6% and 43.4%, respectively. Almost all the identified correlations underestimated the frictional pressure drop of the 4LB tube with MAEs exceeding 30%. An earlier transition of different flow patterns was expected to occur in the EHT tubes while developing a new diabatic flow pattern map is needed for the 4LB tube. A new correlation was presented based on the two-phase multiplier Φ and the Martinelli parameter Xtt, which exhibited excellent predictive results for the experimental data.

Evaluation of Existing Frictional Pressure Drop Correlations During Condensation of R410A in Four Horizontal Tubes

2019 ◽  
Author(s):  
Kunrong Shen ◽  
Zhichuan Sun ◽  
Wei Li ◽  
Xiang Ma ◽  
Yan He ◽  
...  
Keyword(s):  
Experimental Data ◽  
Pressure Drop ◽  
Flow Model ◽  
Saturation Temperature ◽  
Separated Flow ◽  
Smooth Tube ◽  
Outer Diameter ◽  
Homogeneous Flow ◽  
Frictional Pressure Drop ◽  
Horizontal Tubes

Abstract Results are presented here from an experimental investigation on tube side condensation characteristics that took place in four tested tubes — 1EHT-1, 1EHT-2, 4LB and a smooth tube. The equivalent outer diameter of the tubes was 9.52 mm and the inner diameter was 8.32 mm. Condensation tests were conducted using refrigerant R410A at a saturation temperature of 318K, over a mass flow range of 150–450 kgm−2s−1, with inlet and outlet vapor quality of 0.8 and 0.2, respectively. Pressure drop data of the four tested tubes were collected to evaluate five identified prediction correlations based on the separated flow model and the homogeneous flow model. For 1EHT-2 and the smooth tube, all the listed correlations manage to present predictions with the Mean Absolute Relative Deviation (MARD) less than 30%, while they underestimate the frictional pressure drop of the 4LB tube with MARD exceeding 40% averagely. Regarding the experimental data, it is found that the Muller-Steinhagen and Heck correlation presents the most accurate and stable prediction for the 4 tested tubes. The listed homogeneous flow correlations can provide acceptable predictions with MARD ranging from 25% to 40% under a few conditions, but their average predictive accuracies are inferior to that of the separated flow correlations. Consequently, the separated flow approach performs better than the homogeneous flow model in the prediction of frictional pressure drop for our experimental data.

Experimental Investigation on Flow Patterns and Frictional Pressure Drop of Downward Air-Water Two-Phase Flow in Vertical Pipes

2013 ◽  
Author(s):  
Yuqing Xue ◽  
Huixiong Li ◽  
Tianyou Sheng ◽  
Changjiang Liao
Keyword(s):  
Pressure Drop ◽  
Flow Pattern ◽  
Oil Recovery ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Vertical Pipe ◽  
Two Phase Flows ◽  
Two Phase ◽  
Frictional Pressure Drop

A large amount of air need be transported into the reservoir in the deep stratum to supply oxygen to some microbes in Microbial Enhanced Oil Recovery (MEOR). Air-water two-phase flows downward along vertical pipeline during the air transportation. Base on the experiment data described in this paper, the characteristics of air-water two phase flow patterns were investigated. The flow pattern map of air-water two phase flows in the pipe with inner diameter of 65 mm was drawn, criterions of flow pattern transition were discussed, and the dynamic signals of the pressure and the differential pressure of the two phase flow were recorded to characterize the three basic flow regimes indirectly. The frictional pressure drop of downward flow in vertical pipe must not be disregarded contrast with upward two phase flow in the vertical pipe because the buoyancy must be overcame when the gas flows downward along pipe, and there would be a maximum value of frictional when the flow pattern translated from slug flow to churn flow.

Frictional Pressure Drop of Gas-Newtonian and Gas-Non Newtonian Slug Flow in Vertical Pipe

2011 ◽  
Vol 9 (1) ◽  
Author(s):  
Subrata Kumar Majumder ◽  
Sandip Ghosh ◽  
Gautam Kundu ◽  
Arun Kumar Mitra
Keyword(s):  
Pressure Drop ◽  
Slug Flow ◽  
Amyl Alcohol ◽  
Newtonian Liquid ◽  
Vertical Pipe ◽  
Two Phase ◽  
Vertical Column ◽  
Frictional Pressure Drop ◽  
Liquid Systems ◽  
Phase Pressure

Experimental study on two-phase pressure drop in a vertical pipe with air-Newtonian and non-Newtonian liquid in slug flow regime has been carried out within a range of gas and liquid flowrate of 0.5×10-4 to 1.92×10-4 m-3/s and 1.6×10-4 to 6.7×10-4 m3/s respectively. In the present study air and four types of liquids such as water, amyl alcohol, glycerin (two different concentrations), and CMC (Sodium Carboxymethyl Cellulose) are used. The present data were analyzed by two-phase friction method. To predict the two-phase pressure drop, correlations have been developed with Newtonian and non-Newtonian liquid. A general correlation was also developed to predict the two-phase pressure drop in a vertical column of diameter 0.01905 m and 3.4 m height combining both the Newtonian and non-Newtonian liquid systems.

Flow Characteristics and Frictional Pressure Drops of Gas-Liquid Two-Phase Flow in Mini-Micro Pipes and at Vena Contract and Expansion

2007 ◽  
Author(s):  
Hiroyasu Ohtake ◽  
Hideyasu Ohtaki ◽  
Yasuo Koizumi
Keyword(s):  
Pressure Drop ◽  
Flow Pattern ◽  
Two Phase Flow ◽  
Liquid Velocity ◽  
Flow Patterns ◽  
Experimental Results ◽  
Phase Flow ◽  
Two Phase ◽  
Pressure Drops ◽  
Frictional Pressure Drop

The frictional pressure drops and two-phase flow patterns of gas-liquid two-phase flow in mini-micro pipes and at vena contract and expansion were investigated experimentally. Test liquid was water; test gas was argon. The diameter of the test mini-pipe was 0.5, 0.25 and 0.12 mm, respectively. The pressure drop data and the flow pattern were collected over 2.1 < Ug < 92.5 m/s for the superficial gas velocity and 0.03 < Ul < 10 m/s for the superficial liquid velocity. The experimental results show that the flow patterns were slug, churn, ring and annular flows; pure bubbly flow pattern was not observed in a range of the present experimental conditions. The two-phase friction multiplier data for D > 0.5 mm showed to be in good agreement with the conventional correlations. On the other hand, the two-phase friction multiplier data for D < 0.25 mm differed from the calculated values by the conventional correlations. Then, thickness of liquid film around a gas plug and size of gas core were estimated and the effect of frictional pressure drop on channel size was discussed through Knudsen Number of gas and instability on liquid-gas interface. The coefficients of sudden enlargement and sudden contraction in mini-pipes for the gas-water two-phase flow were modified from the present experimental results.

Void Fraction, Pressure Drop, and Flow Pattern Behavior for Two-Phase Non-Newtonian Slug Flow

2021 ◽  
Author(s):  
Faraj Ben Rajeb ◽  
Syed Imtiaz ◽  
Yan Zhang ◽  
Amer Aborig ◽  
Mohamed M. Awad ◽  
...  
Keyword(s):  
Pressure Drop ◽  
Flow Pattern ◽  
Flow Regime ◽  
Void Fraction ◽  
Slug Flow ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Intermittent Flow ◽  
Phase Flow ◽  
Two Phase

Abstract Slug flow is one of the most common flow patterns in non-Newtonian two-phase flow in pipes. It is a very common occurrence in gas-liquid two-phase flow in the pipe. Usually, it is an unfavorable flow pattern due to its unsteady nature, intermittency as well as high pressure drop. The differences between slug flow and elongated bubble flow are not clear because usually these two types of flow combined under one flow category. In general, these two-phase flow regimes are commonly defined as intermittent flow. In the present study, pressure gradient, and wave behavior in slug flow have been investigated depending on experimental work. In addition, void fraction has been estimated regarding available superficial liquid and gas velocities. The experimental records of superficial velocities of gas and liquid for slug flow and other flow patterns is used to create flow regime map for the gas non-Newtonian flow system. The effect of investigated flow regime velocities for non-Newtonian/gas flow on pressure drop and void fraction is reported. Pressure drop has been discovered to be reduced in slug flow more than other flow patterns due to high shear thinning behavior.

A Study on Flow Patterns and Pressure Drop in Adiabatic Two-Phase Flow Across a Bank of Micro Pin Fins

2007 ◽  
Author(s):  
Santosh Krishnamurthy ◽  
Yoav Peles
Keyword(s):  
Pressure Drop ◽  
Mass Flux ◽  
Slug Flow ◽  
Flow Patterns ◽  
Two Phase ◽  
Frictional Pressure Drop ◽  
Pin Fin ◽  
Scale Models ◽  
Pin Fins ◽  
Micro Pin Fins

Flow patterns, void fraction and pressure drop in adiabatic nitrogen-water two phase flows across a bank of micro pin fin were experimentally investigated for Reynolds number ranging from 5 to 50. Staggered cylindrical shaped micro pin fins with diameter and height of 100 μm were micro-fabricated into 1 cm long, 1.8 mm microchannel. Flow patterns were determined by flow visualization and classified as bubbly-slug flow, gas-slug flow, bridged flow and annular flow. The applicability of conventional scale models to predict two-phase frictional pressure drop was also assessed. The two-phase frictional multiplier was found to be a strong function of mass flux and flow patterns unlike the previous results observed in the microchannel studies. It was observed that models from conventional scale systems did not adequately predict the two-phase frictional multiplier at micro-scale and thus, a modified model accounting for mass flux and flow patterns have been developed in this work.

Sign in / Sign up

Export Citation Format

Share Document