An Experimental Study of Turbulent Natural Convection Boundary Layers

1969 ◽  
Vol 91 (4) ◽  
pp. 517-531 ◽  
Author(s):  
G. C. Vliet ◽  
C. K. Liu
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Boundary Layers ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Physical Structure ◽  
Longitudinal Vortex ◽  
Turbulent Regime ◽  
Turbulent Natural Convection ◽  
Convection Boundary

An experimental investigation on turbulent natural convection boundary layers has been conducted with water on a vertical plate of constant heat flux. Local heat transfer data are presented for laminar, transition, and turbulent natural convection, with the emphasis on the turbulent regime. The data extend to a modified Rayleigh number of 1016 for a threefold range in Prandtl number. The results indicate that natural transition occurs in the range 1012 < Ra* < 1014; i.e., fully developed turbulent flow occurs by Ra* = 104. This latter value can be as low as 2 × 1013 with the use of a trip rod. The physical structure of the turbulent boundary-layer flow was studied using the combined time-streak marker hydrogen bubble method. Temperature data and temperature corrected velocity data obtained by hot-film sensors are presented for Ra* values between 8.7 × 1013 and 7.1 × 1014. For the range of variables investigated, the major conclusions are (a) the local heat transfer coefficient exhibits a slight decrease with length, (b) confirmation that the vortex street layer in the transition region decays into a longitudinal-vortex-type structure, and (c) the outer portion of the thermal and velocity fields can be approximated by power profiles that fit almost all the data available to date.

Natural Convection Along a Vertical Wavy Surface

1983 ◽  
Vol 105 (3) ◽  
pp. 465-468 ◽  
Author(s):  
L. S. Yao
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Transformation Method ◽  
Wavy Surface ◽  
Convection Boundary Layer ◽  
Heat Transfer Mechanism ◽  
Convection Boundary ◽  
Sinusoidal Surface

A transformation method is applied to study the natural convection along irregular vertical surfaces. A sinusoidal surface is used as a specific example to demonstrate the advantages of the transformation method, and to elucidate the heat transfer mechanism near such surfaces. The numerical results show that the frequency of the local heat transfer rate is twice that of the wavy surface. The amplitude of the oscillating local Nusselt number gradually decreases downstream where the natural convection boundary layer grows thick.

scholarly journals Turbulent Natural Convection from a Vertical Plane Surface

1968 ◽  
Vol 90 (1) ◽  
pp. 1-6 ◽  
Author(s):  
R. Cheesewright
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Natural Convection ◽  
Vertical Plane ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Convection Boundary Layer ◽  
Transfer Coefficients ◽  
Turbulent Natural Convection ◽  
Heat Transfer Coefficients

The paper reports the results of an experimental investigation which was intended to clarify the present uncertain position with regard to the distributions of mean temperature and mean velocity in a turbulent natural-convection boundary layer. Data reported for the turbulent boundary layer for Grashof numbers between 1010 and 1011 include local heat transfer coefficients as well as temperatures and velocities. Local heat transfer coefficients and temperature distributions are also reported for the laminar and transitional boundary-layer regions. Results are compared with other experimental data and with theoretical predictions.

Entropy generation optimization for MHD natural convection of a nanofluid in porous media-filled enclosure with active parts and viscous dissipation

2017 ◽  
Vol 27 (2) ◽  
pp. 379-399 ◽  
Author(s):  
M.A. Mansour ◽  
Sameh Elsayed Ahmed ◽  
Ali J. Chamkha
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Viscous Dissipation ◽  
Entropy Generation ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Convection Flow ◽  
Negative Effects ◽  
Content Type ◽  
Volume Method

Purpose This paper aims to investigate the entropy generation due to magnetohydrodynamic natural convection flow and heat transfer in a porous enclosure filled with Cu-water nanofluid in the presence of viscous dissipation effect. The left and right walls of the cavity are thermally insulated. There are heated and cold parts, and these are placed on the bottom and top wall, respectively, whereas the remaining parts are thermally insulated. Design/methodology/approach The finite volume method is used to solve the dimensionless partial differential equations governing the problem. A comparison with previously published woks is presented and is found to be in an excellent agreement. Findings The minimization of entropy generation and local heat transfer according to different values of the governing parameters are presented in details. It is found that the presence of magnetic field has negative effects on the local entropy generation because of heat transfer and the local total entropy generation. Also, the increase in the heated part length leads to a decrease in the local Nusselt number. Originality/value This problem is original, as it has not been considered previously.

Effects of Embedded Vortices on Film-Cooled Turbulent Boundary Layers

1989 ◽  
Vol 111 (1) ◽  
pp. 71-77 ◽  
Author(s):  
P. M. Ligrani ◽  
A. Ortiz ◽  
S. L. Joseph ◽  
D. L. Evans
Keyword(s):  
Heat Transfer ◽  
Boundary Layers ◽  
Film Cooling ◽  
Free Stream ◽  
Flow Behavior ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Turbulent Boundary Layers ◽  
Stream Velocity ◽  
Longitudinal Vortices

Heat transfer effects of longitudinal vortices embedded within film-cooled turbulent boundary layers on a flat plate were examined for free-stream velocities of 10 m/s and 15 m/s. A single row of film-cooling holes was employed with blowing ratios ranging from 0.47 to 0.98. Moderate-strength vortices were used with circulating-to-free stream velocity ratios of −0.95 to −1.10 cm. Spatially resolved heat transfer measurements from a constant heat flux surface show that film coolant is greatly disturbed and that local Stanton numbers are altered significantly by embedded longitudinal vortices. Near the downwash side of the vortex, heat transfer is augmented, vortex effects dominate flow behavior, and the protection from film cooling is minimized. Near the upwash side of the vortex, coolant is pushed to the side of the vortex, locally increasing the protection provided by film cooling. In addition, local heat transfer distributions change significantly as the spanwise location of the vortex is changed relative to film-cooling hole locations.

scholarly journals Natural Convection From Isothermal Horizontal Cylinders

2009 ◽  
Author(s):  
Ian M. O. Gorman ◽  
Darina B. Murray ◽  
Gerard Byrne ◽  
Tim Persoons
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Separation Distance ◽  
Thermal Plume ◽  
Number Range ◽  
Vertically Aligned ◽  
Isothermal Cylinders ◽  
Horizontal Cylinders

The research described here is concerned with natural convection from isothermal cylinders, with a particular focus on the interaction between a pair of vertically aligned cylinders. Prime attention was focused on how the local heat transfer characteristics of the upper cylinder are affected due to buoyancy induced fluid flow from the lower cylinder. Tests were performed using internally heated copper cylinders with an outside diameter 30mm and a vertical separation distance between the cylinders ranging from two to three cylinder diameters. Plume interaction between the heated cylinders was investigated within a Rayleigh number range of 2×106 to 6×106. Spectral analysis of the associated heat transfer interaction is presented showing that interaction between the cylinders causes oscillation of the thermal plume. The effect of this oscillation is considered as a possible enhancement mechanism of the heat transfer performance of the upper cylinder.

Three-Dimensional Natural Convection From Vertical Heated Plates With Adjoining Cool Surfaces

1992 ◽  
Vol 114 (1) ◽  
pp. 115-120 ◽  
Author(s):  
B. W. Webb ◽  
T. L. Bergman
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Control Volume ◽  
Three Dimensional ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Uniform Heat Flux ◽  
Infrared Thermal Imaging ◽  
Transfer Rates ◽  
Thermal Boundary Conditions

Natural convection in an enclosure with a uniform heat flux on two vertical surfaces and constant temperature at the adjoining walls has been investigated both experimentally and theoretically. The thermal boundary conditions and enclosure geometry render the buoyancy-induced flow and heat transfer inherently three dimensional. The experimental measurements include temperature distributions of the isoflux walls obtained using an infrared thermal imaging technique, while the three-dimensional equations governing conservation of mass, momentum, and energy were solved using a control volume-based finite difference scheme. Measurements and predictions are in good agreement and the model predictions reveal strongly three-dimensional flow in the enclosure, as well as high local heat transfer rates at the edges of the isoflux wall. Predicted average heat transfer rates were correlated over a range of the relevant dimensionless parameters.

Effect of Periodicity of Non-Uniform Sinusoidal Side Heating on Natural Convection in an Anisotropic Porous-Enclosure

2011 ◽  
Vol 110-116 ◽  
pp. 1613-1618 ◽  
Author(s):  
S. Kapoor ◽  
P. Bera
Keyword(s):  
Heat Transfer ◽  
Nusselt Number ◽  
Natural Convection ◽  
Stream Function ◽  
Numerical Study ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Maximum Heat ◽  
Maximum Heat Transfer ◽  
Porous Enclosure

A comprehensive numerical study on the natural convection in a hydrodynamically anisotropic as well as isotropic porous enclosure is presented, flow is induced by non uniform sinusoidal heating of the right wall of the enclosure. The principal directions of the permeability tensor has been taken oblique to the gravity vector. The spectral Element method has been adopted to solve numerically the governing differential equations by using the vorticity-stream-function approach. The results are presented in terms of stream function, temperature profile and Nusselt number. The result show that the maximum heat transfer takes place at y = 1.5 when N is odd.. Also, increasing media permeability, by changing K* = 1 to K* = 0.2, increases heat transfer rate at below and above right corner of the enclosure. Furthermore, for the all values of N, profiles of local Nusselt number (Nuy) in isotropic as well as anisotropic media are similar, but for even values of N differ slightly at N = 2.. In particular the present analysis shows that, different periodicity (N) of temperature boundary condition has the significant effect on the flow pattern and consequently on the local heat transfer phenomena.

Sign in / Sign up

Export Citation Format

Share Document