Closure to “Discussion of ‘Gyroscopic and Support Effects on the Steady-State Response of a Noncontacting Flexibly Mounted Rotor Mechanical Face Seal’” (1989, ASME J. Tribol., 111, p. 207)

1989 ◽  
Vol 111 (2) ◽  
pp. 207-208
Author(s):  
I. Green
Keyword(s):  
Steady State ◽  
Steady State Response ◽  
Face Seal ◽  
Support Effects ◽  
State Response ◽  
Mechanical Face Seal

Gyroscopic and Support Effects on the Steady-State Response of a Noncontacting Flexibly Mounted Rotor Mechanical Face Seal

1989 ◽  
Vol 111 (2) ◽  
pp. 200-206 ◽  
Author(s):  
I. Green
Keyword(s):  
Dynamic Response ◽  
Closed Form Solution ◽  
Form Solution ◽  
Steady State Response ◽  
Face Seal ◽  
State Response ◽  
High Speeds ◽  
Relative Response ◽  
Mechanical Face Seal ◽  
Stiffness And Damping

The dynamic behavior of a noncontacting rotary mechanical face seal is analyzed. A closed-form solution is presented for the response of a flexibly mounted rotor to forcing misalignments which normally exist due to manufacturing and assembly tolerances. The relative misalignment between the rotor and the stator, which is the most important seal parameter, has been found to be time dependent with a cyclically varying magnitude. The relative response is minimum when support stiffness and damping are minimum. The gyroscopic couple is shown to have a direct effect on the dynamic response. This effect is enhanced at high speeds, and depending on the ratio between the transverse and polar moments of inertia, it can either decrease or increase the dynamic response. Its effect is most beneficial to seal performance when the rotor is a “short disk.” A numerical example demonstrates that a flexibly-mounted rotor seal outperforms a flexibly mounted stator seal with regard to the total relative misalignment, the critical stator misalignment, and the critical speed.

Rotordynamics of a Mechanical Face Seal Riding on a Flexible Shaft

1994 ◽  
Vol 116 (2) ◽  
pp. 345-350 ◽  
Author(s):  
An Sung Lee ◽  
Itzhak Green
Keyword(s):  
Dynamic Analysis ◽  
High Speed ◽  
Center Of Mass ◽  
Steady State Response ◽  
Face Seal ◽  
Rotating Shaft ◽  
State Response ◽  
Flexible Shaft ◽  
Mechanical Face Seal ◽  
Rotor Center

A mechanical face seal is a triboelement intended to minimize leakage between a rotating shaft and a housing, while allowing the shaft to rotate as freely as possible. All dynamic analysis to date have concentrated on the seal itself. In reality, however, especially in high speed turbomachinery, shafts are made flexible and the dynamics of seals must be coupled with the dynamics of shafts. (Perhaps the dynamics of other triboelements, such as gears, bearings, etc., have to be included as well.) In this work the complex extended transfer matrix method is established to solve for the steady state response of a noncontacting flexibly mounted rotor mechanical face seal that rides on a flexible shaft. This method offers a complete dynamic analysis of a seal tribosystem, including effects of shaft inertia and slenderness, fluid film, secondary seal, flexibly mounted rotating element, and axial offset of the rotor center of mass. The results are then compared to those obtained from an analysis that implicitly assumed the shaft rigid. The comparison shows that shaft dynamics can greatly affect the seal performance even at relatively low speeds.

The Auditory Steady-State Response: Full-Term and Premature Neonates

2002 ◽  
Vol 13 (05) ◽  
pp. 260-269 ◽  
Author(s):  
Barbara Cone-Wesson ◽  
John Parker ◽  
Nina Swiderski ◽  
Field Rickards
Keyword(s):  
Steady State ◽  
Premature Infants ◽  
Modulation Frequency ◽  
Otoacoustic Emission ◽  
Full Term ◽  
Steady State Response ◽  
Pass Rates ◽  
Term Infants ◽  
State Response ◽  
Auditory Steady State Response

Two studies were aimed at developing the auditory steady-state response (ASSR) for universal newborn hearing screening. First, neonates who had passed auditory brainstem response, transient evoked otoacoustic emission, and distortion-product otoacoustic emission tests were also tested with ASSRs using modulated tones that varied in frequency and level. Pass rates were highest (> 90%) for amplitude-modulated tones presented at levels ≥ 69 dB SPL. The effect of modulation frequency on ASSR for 500- and 2000-Hz tones was evaluated in full-term and premature infants in the second study. Full-term infants had higher pass rates for 2000-Hz tones amplitude modulated at 74 to 106 Hz compared with pass rates for a 500-Hz tone modulated at 58 to 90 Hz. Premature infants had lower pass rates than full-term infants for both carrier frequencies. Systematic investigation of ASSR threshold and the effect of modulation frequency in neonates is needed to adapt the technique for screening.

scholarly journals Steady State Response of Linear Time Invariant Systems Modeledby Multibond Graphs

2021 ◽  
Vol 11 (4) ◽  
pp. 1717
Author(s):  
Gilberto Gonzalez Avalos ◽  
Noe Barrera Gallegos ◽  
Gerardo Ayala-Jaimes ◽  
Aaron Padilla Garcia
Keyword(s):  
Steady State ◽  
Linear Time ◽  
Direct Determination ◽  
The State ◽  
Steady State Response ◽  
State Variables ◽  
Linear Time Invariant ◽  
State Response ◽  
Time Invariant

The direct determination of the steady state response for linear time invariant (LTI) systems modeled by multibond graphs is presented. Firstly, a multiport junction structure of a multibond graph in an integral causality assignment (MBGI) to get the state space of the system is introduced. By assigning a derivative causality to the multiport storage elements, the multibond graph in a derivative causality (MBGD) is proposed. Based on this MBGD, a theorem to obtain the steady state response is presented. Two case studies to get the steady state of the state variables are applied. Both cases are modeled by multibond graphs, and the symbolic determination of the steady state is obtained. The simulation results using the 20-SIM software are numerically verified.

Sign in / Sign up

Export Citation Format

Share Document