Local Anisotropy in Strained Turbulence at High Reynolds Numbers

1991 ◽  
Vol 113 (4) ◽  
pp. 707-709 ◽  
Author(s):  
P. A. Durbin ◽  
C. G. Speziale
Keyword(s):  
Reynolds Number ◽  
Shear Flow ◽  
Reynolds Numbers ◽  
Local Anisotropy ◽  
Local Isotropy ◽  
Uniform Shear ◽  
Uniform Shear Flow ◽  
High Reynolds Numbers ◽  
High Reynolds ◽  
Mean Strain

It is shown that the hypothesis of local isotropy is implausible in the presence of significant mean rates of strain. In fact, it appears that in uniform shear flow near equilibrium, local isotropy can never constitute a systematic approximation, even in the limit of infinite Reynolds number. An estimate of the level of mean strain rate for which local isotropy is formally a good approximation is provided.

The formation mechanism and shedding frequency of vortices from a sphere in uniform shear flow

1995 ◽  
Vol 287 ◽  
pp. 151-171 ◽  
Author(s):  
Hiroshi Sakamoto ◽  
Hiroyuki Haniu
Keyword(s):  
Reynolds Number ◽  
Shear Flow ◽  
Formation Mechanism ◽  
Vortex Shedding ◽  
Uniform Flow ◽  
Sphere Diameter ◽  
Uniform Shear ◽  
Uniform Shear Flow ◽  
Vortex Loops ◽  
Shear Parameter

Experiments to investigate the formation mechanism and frequency of vortex shedding from a sphere in uniform shear flow were conducted in a water channel using flow visualization and velocity measurement. The Reynolds number, defined in terms of the sphere diameter and approach velocity at its centre, ranged from 200 to 3000. The shear parameter K, defined as the transverse velocity gradient of the shear flow non-dimensionalized by the above two parameters, was varied from 0 to 0.25. The critical Reynolds number beyond which vortex shedding from the sphere occurred was found to be lower than that for uniform flow and decreased approximately linearly with increasing shear parameter. Also, the Strouhal number of the hairpin-shaped vortex loops became larger than that for uniform flow and increased as the shear parameter increased.The formation mechanism and the structure of vortex shedding were examined on the basis of series of photographs and subsequent image processing using computer graphics. The range of Reynolds number in the present investigation, extending up to 3000, could be classified into three regions on the basis of this study, and it was observed that the wake configuration did not differ substantially from that for uniform flow. Also, unlike the detachment point of vortex loops in uniform flow, which was irregularly located along the circumference of the sphere, the detachment point in shear flow was always on the high-velocity side.

Temperature Control of Blow-Down, Supersonic Tunnels

1956 ◽  
Vol 60 (541) ◽  
pp. 67-70
Author(s):  
T. A. Thomson
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Reynolds Number ◽  
Mach Number ◽  
Reynolds Numbers ◽  
Stagnation Temperature ◽  
Blow Down ◽  
High Reynolds Numbers ◽  
Experimental Errors ◽  
High Reynolds

The blow-down type of intermittent, supersonic tunnel is attractive because of its simplicity and because relatively high Reynolds numbers can be obtained for a given size of test section. An adverse characteristic, however, is the fall of stagnation temperature during runs, which can affect experiments in several ways. The Reynolds number varies and the absolute velocity is not constant, even if the Mach number and pressure are; heat-transfer cannot be studied under controlled conditions and the experimental errors arising from the effect of heat-transfer on the boundary layer vary in time. These effects can become significant in quantitative experiments if the tunnel is large and the variation of temperature very rapid; the expense required to eliminate them might then be justified.

Spectral energy transfer in high Reynolds number turbulence

1977 ◽  
Vol 79 (2) ◽  
pp. 337-359 ◽  
Author(s):  
K. N. Helland ◽  
C. W. Van Atta ◽  
G. R. Stegen
Keyword(s):  
Reynolds Number ◽  
Energy Transfer ◽  
Energy Spectrum ◽  
High Reynolds Number ◽  
Reynolds Numbers ◽  
Second Order ◽  
Spectral Energy ◽  
Local Isotropy ◽  
High Reynolds ◽  
Good Agreement

The spectral energy transfer of turbulent velocity fields has been examined over a wide range of Reynolds numbers by experimental and empirical methods. Measurements in a high Reynolds number grid flow were used to calculate the energy transfer by the direct Fourier-transform method of Yeh & Van Atta. Measurements in a free jet were used to calculate energy transfer for a still higher Reynolds number. An empirical energy spectrum was used in conjunction with a local self-preservation approximation to estimate the energy transfer at Reynolds numbers beyond presently achievable experimental conditions.Second-order spectra of the grid measurements are in excellent agreement with local isotropy down to low wavenumbers. For the first time, one-dimensional third-order spectra were used to test for local isotropy, and modest agreement with the theoretical conditions was observed over the range of wavenumbers which appear isotropic according to second-order criteria. Three-dimensional forms of the measured spectra were calculated, and the directly measured energy transfer was compared with the indirectly measured transfer using a local self-preservation model for energy decay. The good agreement between the direct and indirect measurements of energy transfer provides additional support for both the assumption of local isotropy and the assumption of self-preservation in high Reynolds number grid turbulence.An empirical spectrum was constructed from analytical spectral forms of von Kármán and Pao and used to extrapolate energy transfer measurements at lower Reynolds number to Rλ = 105 with the assumption of local self preservation. The transfer spectrum at this Reynolds number has no wavenumber region of zero net spectral transfer despite three decades of $k^{-\frac{5}{3}}$. behaviour in the empirical energy spectrum. A criterion for the inertial subrange suggested by Lumley applied to the empirical transfer spectrum is in good agreement with the $k^{-\frac{5}{3}}$ range of the empirical energy spectrum.

Relationship of roll and pitch oscillations in a fin flapping at transitional to high Reynolds numbers

2012 ◽  
Vol 702 ◽  
pp. 298-331 ◽  
Author(s):  
Promode R. Bandyopadhyay ◽  
David N. Beal ◽  
J. Dana Hrubes ◽  
Arun Mangalam
Keyword(s):  
Reynolds Number ◽  
Stagnation Point ◽  
Strouhal Number ◽  
High Efficiency ◽  
Oscillation Amplitude ◽  
Leading Edge ◽  
Reynolds Numbers ◽  
Stokes Wave ◽  
High Reynolds Numbers ◽  
High Reynolds

AbstractHydrodynamic effects of the relationship between the roll and pitch oscillations in low-aspect-ratio fins, with a laminar section and a rounded leading edge, flapping at transitional to moderately high Reynolds numbers, are considered. The fin is hinged at one end and its roll amplitude is large. Also examined is how this relationship is affected by spanwise twist, which alters the pitch oscillation amplitude and its phase relative to the roll motion. Force, efficiency and surface hot-film-anemometry measurements, and flow visualization are carried out in a tow tank. A fin of an abstracted penguin-wing planform and a NACA 0012 cross-section is used, and the chord Reynolds number varies from 3558 to 150 000 based on total speed. The fin is forced near the natural shedding frequency. Strouhal number and pitch amplitude are directly related when thrust is produced, and efficiency is maximized in narrow combinations of Strouhal number and pitch amplitude when oscillation of the leading-edge stagnation point is minimal. Twist makes the angle of attack uniform along the span and enhances thrust by up to 24 %, while maintaining high efficiency. Only 5 % of the power required to roll is spent to pitch, and yet roll and pitch are directly related. During hovering, dye visualization shows that a diffused leading-edge vortex is produced in rigid fins, which enlarges along the span; however, twist makes the vortex more uniform and the fin in turn requires less power to roll. Low-order phase maps of the measurements of force oscillation versus its derivative are modelled as due to van der Pol oscillators; the higher-order maps show trends in the sub-regimes of the transitional Reynolds number. Fin oscillation imparts a chordwise fluid motion, yielding a Stokes wave in the near-wall vorticity layer. When the roll and pitch oscillations are directly related, the wave is optimized: causing vorticity lift-up as the fin is decelerated at the roll extremity; the potential energy at the stagnation point is converted into kinetic energy; a vortex is produced as the lifted vorticity is wrapped around the leading edge; and free-stream reattachment keeps the vortex trapped. When the twist oscillation is phased along the span, this vortex becomes self-preserving at all amplitudes of twist, indicating the most stable (low-bandwidth) tuned nature.

An Intermittent High-Reynolds-Number Wind Tunnel

1977 ◽  
Vol 28 (4) ◽  
pp. 259-264 ◽  
Author(s):  
J L Stollery ◽  
A V Murthy
Keyword(s):  
Reynolds Number ◽  
Wind Tunnel ◽  
High Reynolds Number ◽  
Reynolds Numbers ◽  
Simple Method ◽  
High Reynolds Numbers ◽  
Reservoir Conditions ◽  
High Reynolds ◽  
Cryogenic Wind Tunnel ◽  
Performance Estimates

SummaryThe paper suggests a simple method of generating intermittent reservoir conditions for an intermittent, cryogenic wind tunnel. Approximate performance estimates are given and it is recommended that further studies be made because this type of tunnel could be valuable in increasing the opportunities for research at high Reynolds numbers.

Investigations of the Flow in Curved Ducts at Large Reynolds Numbers

1948 ◽  
Vol 15 (4) ◽  
pp. 344-348
Author(s):  
J. R. Weske
Keyword(s):  
Reynolds Number ◽  
Pressure Drop ◽  
Boundary Layers ◽  
Reynolds Numbers ◽  
Equation Of Motion ◽  
Radius Ratio ◽  
High Reynolds Numbers ◽  
Net Pressure ◽  
High Reynolds ◽  
Curved Ducts

Abstract It is found that the flow in curved ducts at high Reynolds numbers may be analyzed by methods adapted from the theory of boundary layers. Integration of the equation of motion of the “shedding layer” led to relations for the net pressure drop of curved ducts as a function of radius ratio and of Reynolds number.

Heat Transfer Coefficient Distribution of W and Broken W Turbulators At High Reynolds Numbers

2021 ◽  
pp. 1-29
Author(s):  
Sam Ghazi-Hesami ◽  
Dylan Wise ◽  
Keith Taylor ◽  
Étienne Robert ◽  
Peter Ireland
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Thermal Performance ◽  
Reynolds Numbers ◽  
High Reynolds Numbers ◽  
Smooth Channel ◽  
Wide Range ◽  
High Reynolds

Abstract An experimental and numerical study of the convective heat transfer enhancement provided by two rib families (W and Broken W) is presented, covering Reynolds numbers (Re) between 300,000 to 900,000 in a straight channel with a rectangular cross section (AR=1.29). These high Reynolds numbers were selected for the current study since most data in the available literature typically pertain to investigations at lower Reynolds numbers. The objective of this study is to assess the local heat transfer coefficient (HTC) enhancement (compared with a smooth channel) and the overall thermal performance, taking into account the effect of increased roughness on the friction factor, of a group of W shaped turbulators over a wide range of Reynolds numbers. Furthermore, the effects of increasing the rib spacing on the thermal performance of the Broken W configuration are presented and discussed. The numerical results are compared against heat transfer measurements obtained using the Transient Liquid Crystal (TLC) method. The research shows that for the Broken W turbulators, increasing the Reynolds number is associated with an overall decrease of the thermal performance while the thermal performance of the W configuration is relatively insensitive to Reynolds number. Nevertheless, the Broken W configuration delivers higher thermal performance and heat transfer compared with the W configuration for the range of Re investigated. The Broken W configuration with a pitch spacing of 10 times the rib height was shown to provide the optimal thermal performance in the configurations investigated here.

Turbulent boundary layer statistics at very high Reynolds number

2015 ◽  
Vol 779 ◽  
pp. 371-389 ◽  
Author(s):  
M. Vallikivi ◽  
M. Hultmark ◽  
A. J. Smits
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
High Reynolds Number ◽  
Reynolds Numbers ◽  
Working Fluid ◽  
Mean Velocity ◽  
High Reynolds Numbers ◽  
Layer Flow ◽  
High Reynolds ◽  
Very High

Measurements are presented in zero-pressure-gradient, flat-plate, turbulent boundary layers for Reynolds numbers ranging from $\mathit{Re}_{{\it\tau}}=2600$ to $\mathit{Re}_{{\it\tau}}=72\,500$ ($\mathit{Re}_{{\it\theta}}=8400{-}235\,000$). The wind tunnel facility uses pressurized air as the working fluid, and in combination with MEMS-based sensors to resolve the small scales of motion allows for a unique investigation of boundary layer flow at very high Reynolds numbers. The data include mean velocities, streamwise turbulence variances, and moments up to 10th order. The results are compared to previously reported high Reynolds number pipe flow data. For $\mathit{Re}_{{\it\tau}}\geqslant 20\,000$, both flows display a logarithmic region in the profiles of the mean velocity and all even moments, suggesting the emergence of a universal behaviour in the statistics at these high Reynolds numbers.

Sign in / Sign up

Export Citation Format

Share Document