Development Steps for Parabolic Trough Solar Power Technologies With Maximum Impact on Cost Reduction

2006 ◽  
Vol 129 (4) ◽  
pp. 371-377 ◽  
Author(s):  
Robert Pitz-Paal ◽  
Jürgen Dersch ◽  
Barbara Milow ◽  
Félix Téllez ◽  
Alain Ferriere ◽  
...  
Keyword(s):  
Mass Production ◽  
Cost Reduction ◽  
Power Plants ◽  
Solar Power ◽  
Performance Model ◽  
Heat Transfer Fluid ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Technical Improvement ◽  
The Cost

Besides continuous implementation of concentrating solar power plants (CSP) in Europe, which stipulate cost reduction by mass production effects, further R&D activities are necessary to achieve the cost competitiveness to fossil power generation. The European Concentrated Solar Thermal Roadmap (ECOSTAR) study that was conducted by European research institutes in the field of CSP intends to stipulate the direction for R&D activities in the context of cost reduction. This paper gives an overview about the methodology and the results for one of the seven different CSP system concepts that are currently under promotion worldwide and considered within ECOSTAR. The technology presented here is the parabolic trough with direct steam generation (DSG), which may be considered as an evolution of the existing parabolic systems with thermal oil as heat transfer fluid. The methodology is explained using this exemplary system, and the technical improvements are evaluated according to their cost-reduction potential using a common approach, based on an annual performance model. Research priorities are given based on the results. The simultaneous implementation of three measures is required in order to achieve the cost-reduction target: Technical improvement by R&D, upscaling of the unit size, and mass production of the equipment.

Development Steps for Concentrating Solar Power Technologies With Maximum Impact on Cost Reduction: Results of the European ECOSTAR Study

Solar Energy ◽  
2005 ◽  
Author(s):  
Robert Pitz-Paal ◽  
Ju¨rgen Dersch ◽  
Barbara Milow ◽  
Fe´lix Te´llez ◽  
Alain Ferriere ◽  
...  
Keyword(s):  
Cost Reduction ◽  
Power Plants ◽  
Solar Power ◽  
Low Cost ◽  
Performance Model ◽  
Concentrating Solar Power ◽  
Cost Information ◽  
Power Cycles ◽  
Electricity Cost ◽  
The Cost

Beside continuous implementation of concentrating solar power plants (CSP) in Europe, which stipulate cost reduction by mass production effects, further R&D activities are necessary to achieve the cost competitiveness to fossil power generation. Therefore the cost range of 15–20 cents€/kWh for the currently planned CSP systems in Europe has to be decreased by a factor of 2–4. The European Concentrated Solar Thermal Roadmap (ECOSTAR) study that is conducted by leading CSP research institutes in Europe intends to stipulate the direction for R&D activities in the context of cost reduction. It uses a common methodology approach, based on an annual performance model to identify the most essential technical innovations that will reduce the cost of seven different CSP system concepts, which are currently under promotion world wide. The potential of innovative concepts for solar light weight concentrators, low-cost thermal energy storage concepts, solar receivers/absorbers and power cycles are in the main focus of interest. The results of the study include a description of the value of CSP power, the sensitivity of the electricity cost information, a list of innovations that have been investigated and recommendations for the focus of further R&D work.

Comparison of Two Linear Collectors in Solar Thermal Plants: Parabolic Trough vs Fresnel

2011 ◽  
Author(s):  
A. Giostri ◽  
M. Binotti ◽  
P. Silva ◽  
E. Macchi ◽  
G. Manzolini
Keyword(s):  
Power Plants ◽  
Thermal Power ◽  
Solar Thermal ◽  
Heat Transfer Fluid ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Research Activity ◽  
Optical Efficiency ◽  
Synthetic Oil ◽  
Yearly Average

Parabolic trough can be considered the state of the art for solar thermal power plants thanks to the almost 30 years experience gained in SEGS and, recently, Nevada Solar One plants in US and Andasol plants in Spain. One of the major issues that limits the wide diffusion of this technology is the high investment cost of the solar field and, particularly, of the solar collector. For this reason, since several years research activity has been trying to develop new solutions with the aim of cost reduction. This work compares commercial Fresnel technology with conventional parabolic trough plant based on synthetic oil as heat transfer fluid at nominal conditions and evaluates yearly average performances. In both technologies, no thermal storage system is considered. In addition, for Fresnel, a Direct Steam Generation (DSG) case is investigated. Performances are calculated by a commercial code, Thermoflex®, with dedicated component to evaluate solar plant. Results will show that, at nominal conditions, Fresnel technology have an optical efficiency of 67% which is lower than 75% of parabolic trough. Calculated net electric efficiency is about 19.25%, while parabolic trough technology achieves 23.6%. In off-design conditions, the gap between Fresnel and parabolic trough increases because the former is significantly affected by high radiation incident angles. The calculated sun-to-electric annual average efficiency for Fresnel plant is 10.2%, consequence of the average optical efficiency of 38.8%, while parabolic trough achieve an overall efficiency of 16%, with an optical one of 52.7%. An additional case with Fresnel collector and synthetic oil outlines differences among investigated cases. Finally, because part of performance difference between PT and Fresnel is simple due to different definitions, additional indexes are introduced in order to make a consistent comparison.

Current and Future Economics of Parabolic Trough Technology

2007 ◽  
Author(s):  
Henry Price ◽  
Mark Mehos ◽  
Chuck Kutscher ◽  
Nate Blair
Keyword(s):  
Natural Gas ◽  
Power Systems ◽  
Power Plants ◽  
Solar Power ◽  
Power Market ◽  
Parabolic Trough ◽  
Cost Of Electricity ◽  
Near Term ◽  
The Cost ◽  
Utility Scale

Solar energy is the largest energy resource on the planet. Unfortunately, it is largely untapped at present, in part because sunlight is a very diffuse energy source. Concentrating solar power (CSP) systems use low cost reflectors to concentrate the sun’s energy to allow it to be used more effectively. Concentrating solar power systems are also well suited for large solar power plants that can be connected into the existing utility infrastructure. These two facts mean that CSP systems can be used to make a meaningful difference in energy supply in a relatively short period. CSP plants are best suited for the arid climates in the Southwestern United States, Northern Mexico, and many desert regions around the globe. A recent Western Governors’ Association siting study [1] found that the solar potential in the U.S. Southwest is at least 4 times the total U.S. electric demand even after eliminating urban areas, environmentally sensitive areas, and all regions with a ground slope greater than 1%.While it is currently not practical to power the whole county from the desert southwest, only a small portion of this area is needed to make a substantial contribution to future U.S. electric needs. Many of the best sites are near existing high-voltage transmission lines and close to major power load centers in the Southwest (Los Angeles, Las Vegas, and Phoenix). In addition, the power provided by CSP technologies has strong coincidence with peak electric demand, especially in the Southwest where peak demand corresponds in large part to air conditioning loads. Parabolic troughs currently represent the most cost-effective CSP technology for developing large utility-scale solar electric power systems. These systems are also one of the most mature solar technologies, with commercial utility-scale plants that have been operating for over 20 years. In addition, substantial improvements have been made to the technology in recent years including improved efficiency and the addition of thermal energy storage. The main issue for parabolic trough technology is that the cost of electricity is still higher than the cost of electricity from conventional natural gas-fired power plants. Although higher natural gas prices are helping to substantially reduce the difference between the cost of electricity from solar and natural gas plants, in the near-term increased incentives such as the 30% Investment Tax Credit (ITC) are needed to make CSP technology approach competitiveness with natural gas power on a financial basis. In the longer term, additional reductions in the cost of the technology will be necessary. This paper looks at the near-term potential for parabolic trough technology to compete with conventional fossil power resources in the firm, intermediate load power market and at the longer term potential to compete in the baseload power market. The paper will consider the potential impact of a reduced carbon emissions future.

Model and control scheme for recirculation mode direct steam generation parabolic trough solar power plants

2017 ◽  
Vol 202 ◽  
pp. 700-714 ◽  
Author(s):  
Su Guo ◽  
Deyou Liu ◽  
Xingying Chen ◽  
Yinghao Chu ◽  
Chang Xu ◽  
...  
Keyword(s):  
Power Plants ◽  
Solar Power ◽  
Steam Generation ◽  
Parabolic Trough ◽  
Control Scheme ◽  
Direct Steam ◽  
Solar Power Plants ◽  
And Control

scholarly journals Reducing the Cost of Energy From Parabolic Trough Solar Power Plants

Solar Energy ◽  
2003 ◽  
Author(s):  
Henry Price ◽  
David Kearney
Keyword(s):  
Mojave Desert ◽  
Power Plants ◽  
Large Scale ◽  
Solar Power ◽  
Parabolic Trough ◽  
Cost Of Energy ◽  
Solar Power Plants ◽  
The Cost ◽  
The Impact ◽  
Fossil Fuel Power Plants

Parabolic trough solar technology is the most proven and lowest cost large-scale solar power technology available today, primarily because of the nine large commercial-scale solar power plants that are operating in the California Mojave Desert. However, no new plants have been built during the past ten years because the cost of power from these plants is more expensive than power from conventional fossil fuel power plants. This paper reviews the current cost of energy and the potential for reducing the cost of energy from parabolic trough solar power plant technology based on the latest technological advancements and projected improvements from industry and sponsored R&D. The paper also looks at the impact of project financing and incentives on the cost of energy.

scholarly journals SIMULATION STUDY OF PARABOLIC TROUGH SOLAR POWER PLANTS IN BRAZIL

2019 ◽  
Vol 7 (8) ◽  
pp. 17-28
Author(s):  
Antonio Marcos De Oliveira Siqueira ◽  
Gabi Antoine Altabash ◽  
Rayan Fadi Barhouche ◽  
Gabriel Siqueira Silva ◽  
Fábio Gonçalves Villela
Keyword(s):  
Power Plant ◽  
Heat Exchangers ◽  
Solar Collector ◽  
Power Plants ◽  
Solar Power ◽  
Simulation Software ◽  
Heat Transfer Fluid ◽  
Electricity Production ◽  
Parabolic Trough ◽  
Power Block

Various data reveals the potential of concentrated solar technologies for the electricity production. With global growing energy demand and green-house gas emission, concentrating solar power is considered as one of the promising options and has invited wide attention. In this work, a model for a 30 MW parabolic trough solar power plant system was developed for 31 different locations in Brazil, using TRNSYS simulation software, and TESS and STEC libraries. The power system consists of a parabolic trough solar collector loop connected to a power block by a series of heat exchangers. The solar collector loop consists of a field of parabolic trough collectors, stratified thermal storage tank, pump and heat exchangers to drive the power block and uses Therminol VP1 as heat transfer fluid. The results show that the cities of Recife (PE), Fortaleza (CE), Belterra (PA), Salvador (BA) and Petrolina (PE) stand out for their high monthly values of direct normal irradiation and, resulting the highest production of energy by the same configuration of Solar Central Power Plant.

Sign in / Sign up

Export Citation Format

Share Document