Numerical Prediction of the Hydrodynamic Loads and Vortex-Induced Vibrations of Offshore Structures

2000 ◽  
Vol 122 (4) ◽  
pp. 289-293 ◽  
Author(s):  
Karl W. Schulz ◽  
Yannis Kallinderis
Keyword(s):  
Reynolds Number ◽  
Stokes Flow ◽  
Structural Response ◽  
Reynolds Numbers ◽  
Offshore Structures ◽  
Navier Stokes ◽  
High Reynolds Numbers ◽  
Vortex Induced Vibrations ◽  
Flow Algorithm ◽  
High Reynolds

An incompressible Navier-Stokes flow algorithm is coupled with an elastic body structural response to numerically investigate the hydrodynamics of several relevant offshore applications. These applications include the effects of surface roughness on a bare cylinder and the study of vortex-induced vibrations (VIV) for a cylinder at high Reynolds numbers. The Reynolds number for the roughness cases was Re=4×106, while the Reynolds number for the VIV cases ranged from 2.25×105⩽Re⩽4.75×105. Additional VIV cases were also performed for two common suppression devices: strakes and fairings. The results from both the roughness and bare cylinder VIV applications were compared to experimental data in order to further validate the numerical scheme and illustrate the effectiveness of applying Navier-Stokes technologies to offshore applications. [S0892-7219(00)00604-X]

Temperature Control of Blow-Down, Supersonic Tunnels

1956 ◽  
Vol 60 (541) ◽  
pp. 67-70
Author(s):  
T. A. Thomson
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Reynolds Number ◽  
Mach Number ◽  
Reynolds Numbers ◽  
Stagnation Temperature ◽  
Blow Down ◽  
High Reynolds Numbers ◽  
Experimental Errors ◽  
High Reynolds

The blow-down type of intermittent, supersonic tunnel is attractive because of its simplicity and because relatively high Reynolds numbers can be obtained for a given size of test section. An adverse characteristic, however, is the fall of stagnation temperature during runs, which can affect experiments in several ways. The Reynolds number varies and the absolute velocity is not constant, even if the Mach number and pressure are; heat-transfer cannot be studied under controlled conditions and the experimental errors arising from the effect of heat-transfer on the boundary layer vary in time. These effects can become significant in quantitative experiments if the tunnel is large and the variation of temperature very rapid; the expense required to eliminate them might then be justified.

Relationship of roll and pitch oscillations in a fin flapping at transitional to high Reynolds numbers

2012 ◽  
Vol 702 ◽  
pp. 298-331 ◽  
Author(s):  
Promode R. Bandyopadhyay ◽  
David N. Beal ◽  
J. Dana Hrubes ◽  
Arun Mangalam
Keyword(s):  
Reynolds Number ◽  
Stagnation Point ◽  
Strouhal Number ◽  
High Efficiency ◽  
Oscillation Amplitude ◽  
Leading Edge ◽  
Reynolds Numbers ◽  
Stokes Wave ◽  
High Reynolds Numbers ◽  
High Reynolds

AbstractHydrodynamic effects of the relationship between the roll and pitch oscillations in low-aspect-ratio fins, with a laminar section and a rounded leading edge, flapping at transitional to moderately high Reynolds numbers, are considered. The fin is hinged at one end and its roll amplitude is large. Also examined is how this relationship is affected by spanwise twist, which alters the pitch oscillation amplitude and its phase relative to the roll motion. Force, efficiency and surface hot-film-anemometry measurements, and flow visualization are carried out in a tow tank. A fin of an abstracted penguin-wing planform and a NACA 0012 cross-section is used, and the chord Reynolds number varies from 3558 to 150 000 based on total speed. The fin is forced near the natural shedding frequency. Strouhal number and pitch amplitude are directly related when thrust is produced, and efficiency is maximized in narrow combinations of Strouhal number and pitch amplitude when oscillation of the leading-edge stagnation point is minimal. Twist makes the angle of attack uniform along the span and enhances thrust by up to 24 %, while maintaining high efficiency. Only 5 % of the power required to roll is spent to pitch, and yet roll and pitch are directly related. During hovering, dye visualization shows that a diffused leading-edge vortex is produced in rigid fins, which enlarges along the span; however, twist makes the vortex more uniform and the fin in turn requires less power to roll. Low-order phase maps of the measurements of force oscillation versus its derivative are modelled as due to van der Pol oscillators; the higher-order maps show trends in the sub-regimes of the transitional Reynolds number. Fin oscillation imparts a chordwise fluid motion, yielding a Stokes wave in the near-wall vorticity layer. When the roll and pitch oscillations are directly related, the wave is optimized: causing vorticity lift-up as the fin is decelerated at the roll extremity; the potential energy at the stagnation point is converted into kinetic energy; a vortex is produced as the lifted vorticity is wrapped around the leading edge; and free-stream reattachment keeps the vortex trapped. When the twist oscillation is phased along the span, this vortex becomes self-preserving at all amplitudes of twist, indicating the most stable (low-bandwidth) tuned nature.

scholarly journals Vortex induced vibrations at high Reynolds numbers on circular cylinders

2015 ◽  
Vol 94 ◽  
pp. 140-154 ◽  
Author(s):  
M. Belloli ◽  
S. Giappino ◽  
S. Morganti ◽  
S. Muggiasca ◽  
A. Zasso
Keyword(s):  
Reynolds Numbers ◽  
Circular Cylinders ◽  
High Reynolds Numbers ◽  
Vortex Induced Vibrations ◽  
High Reynolds

scholarly journals Model-based scaling of the streamwise energy density in high-Reynolds-number turbulent channels

2013 ◽  
Vol 734 ◽  
pp. 275-316 ◽  
Author(s):  
Rashad Moarref ◽  
Ati S. Sharma ◽  
Joel A. Tropp ◽  
Beverley J. McKeon
Keyword(s):  
Reynolds Number ◽  
Stokes Equations ◽  
Reynolds Numbers ◽  
Low Rank ◽  
Navier Stokes ◽  
Mean Velocity ◽  
Navier Stokes Equations ◽  
Self Similar ◽  
The Mean ◽  
High Reynolds

AbstractWe study the Reynolds-number scaling and the geometric self-similarity of a gain-based, low-rank approximation to turbulent channel flows, determined by the resolvent formulation of McKeon & Sharma (J. Fluid Mech., vol. 658, 2010, pp. 336–382), in order to obtain a description of the streamwise turbulence intensity from direct consideration of the Navier–Stokes equations. Under this formulation, the velocity field is decomposed into propagating waves (with single streamwise and spanwise wavelengths and wave speed) whose wall-normal shapes are determined from the principal singular function of the corresponding resolvent operator. Using the accepted scalings of the mean velocity in wall-bounded turbulent flows, we establish that the resolvent operator admits three classes of wave parameters that induce universal behaviour with Reynolds number in the low-rank model, and which are consistent with scalings proposed throughout the wall turbulence literature. In addition, it is shown that a necessary condition for geometrically self-similar resolvent modes is the presence of a logarithmic turbulent mean velocity. Under the practical assumption that the mean velocity consists of a logarithmic region, we identify the scalings that constitute hierarchies of self-similar modes that are parameterized by the critical wall-normal location where the speed of the mode equals the local turbulent mean velocity. For the rank-1 model subject to broadband forcing, the integrated streamwise energy density takes a universal form which is consistent with the dominant near-wall turbulent motions. When the shape of the forcing is optimized to enforce matching with results from direct numerical simulations at low turbulent Reynolds numbers, further similarity appears. Representation of these weight functions using similarity laws enables prediction of the Reynolds number and wall-normal variations of the streamwise energy intensity at high Reynolds numbers (${Re}_{\tau } \approx 1{0}^{3} {\unicode{x2013}} 1{0}^{10} $). Results from this low-rank model of the Navier–Stokes equations compare favourably with experimental results in the literature.

Sign in / Sign up

Export Citation Format

Share Document