Assessment of the Robust Satellite Technique (RST) for volcanic ash plume identification and tracking

Author(s):  
F. Marchese ◽  
R. Corrado ◽  
N. Genzano ◽  
G. Mazzeo ◽  
R. Paciello ◽  
...  
Keyword(s):  
2011 ◽  
Vol 11 (5) ◽  
pp. 2245-2279 ◽  
Author(s):  
U. Schumann ◽  
B. Weinzierl ◽  
O. Reitebuch ◽  
H. Schlager ◽  
A. Minikin ◽  
...  

Abstract. Airborne lidar and in-situ measurements of aerosols and trace gases were performed in volcanic ash plumes over Europe between Southern Germany and Iceland with the Falcon aircraft during the eruption period of the Eyjafjalla volcano between 19 April and 18 May 2010. Flight planning and measurement analyses were supported by a refined Meteosat ash product and trajectory model analysis. The volcanic ash plume was observed with lidar directly over the volcano and up to a distance of 2700 km downwind, and up to 120 h plume ages. Aged ash layers were between a few 100 m to 3 km deep, occurred between 1 and 7 km altitude, and were typically 100 to 300 km wide. Particles collected by impactors had diameters up to 20 μm diameter, with size and age dependent composition. Ash mass concentrations were derived from optical particle spectrometers for a particle density of 2.6 g cm−3 and various values of the refractive index (RI, real part: 1.59; 3 values for the imaginary part: 0, 0.004 and 0.008). The mass concentrations, effective diameters and related optical properties were compared with ground-based lidar observations. Theoretical considerations of particle sedimentation constrain the particle diameters to those obtained for the lower RI values. The ash mass concentration results have an uncertainty of a factor of two. The maximum ash mass concentration encountered during the 17 flights with 34 ash plume penetrations was below 1 mg m−3. The Falcon flew in ash clouds up to about 0.8 mg m−3 for a few minutes and in an ash cloud with approximately 0.2 mg m−3 mean-concentration for about one hour without engine damage. The ash plumes were rather dry and correlated with considerable CO and SO2 increases and O3 decreases. To first order, ash concentration and SO2 mixing ratio in the plumes decreased by a factor of two within less than a day. In fresh plumes, the SO2 and CO concentration increases were correlated with the ash mass concentration. The ash plumes were often visible slantwise as faint dark layers, even for concentrations below 0.1 mg m−3. The large abundance of volatile Aitken mode particles suggests previous nucleation of sulfuric acid droplets. The effective diameters range between 0.2 and 3 μm with considerable surface and volume contributions from the Aitken and coarse mode aerosol, respectively. The distal ash mass flux on 2 May was of the order of 500 (240–1600) kg s−1. The volcano induced about 10 (2.5–50) Tg of distal ash mass and about 3 (0.6–23) Tg of SO2 during the whole eruption period. The results of the Falcon flights were used to support the responsible agencies in their decisions concerning air traffic in the presence of volcanic ash.


2014 ◽  
Vol 7 (4) ◽  
pp. 3863-3913
Author(s):  
T. H. Virtanen ◽  
P. Kolmonen ◽  
E. Rodríguez ◽  
L. Sogacheva ◽  
A.-M. Sundström ◽  
...  

Abstract. An algorithm is presented for estimation of volcanic ash plume top height using the stereo view of the Advanced Along Track Scanning Radiometer (AATSR) aboard ENVISAT. The algorithm is based on matching the top of atmosphere (TOA) reflectances and brightness temperatures of the nadir and 55° forward views, and using the resulting parallax to obtain the height estimate. Various retrieval parameters are discussed in detail, several quality parameters are introduced, and post-processing methods for screening out unreliable data have been developed. The method is compared against other satellite observations and in-situ data. The proposed algorithm is designed to be fully automatic, and can be implemented into operational retrieval algorithms. Combined with automated ash detection using the brightness temperature difference between the 11 μm and 12 μm channels, the algorithm allows simultaneous retrieval of horizontal and vertical dispersion of volcanic ash efficiently. A case study on the eruption of the Icelandic volcano Eyjafjallajökull in 2010 is presented. The height estimate method results are validated against available satellite and ground based data.


2014 ◽  
Vol 7 (8) ◽  
pp. 2437-2456 ◽  
Author(s):  
T. H. Virtanen ◽  
P. Kolmonen ◽  
E. Rodríguez ◽  
L. Sogacheva ◽  
A.-M. Sundström ◽  
...  

Abstract. An algorithm is presented for the estimation of volcanic ash plume top height using the stereo view of the Advanced Along Track Scanning Radiometer (AATSR) aboard Envisat. The algorithm is based on matching top of the atmosphere (TOA) reflectances and brightness temperatures of the nadir and 55° forward views, and using the resulting parallax to obtain the height estimate. Various retrieval parameters are discussed in detail, several quality parameters are introduced, and post-processing methods for screening out unreliable data have been developed. The method is compared to other satellite observations and in situ data. The proposed algorithm is designed to be fully automatic and can be implemented in operational retrieval algorithms. Combined with automated ash detection using the brightness temperature difference between the 11 and 12 μm channels, the algorithm allows efficient simultaneous retrieval of the horizontal and vertical dispersion of volcanic ash. A case study on the eruption of the Icelandic volcano Eyjafjallajökull in 2010 is presented.


2019 ◽  
Vol 36 (3) ◽  
pp. 353-367
Author(s):  
Nicholas Rainville ◽  
Scott Palo ◽  
Kristine M. Larson ◽  
Mario Mattia

AbstractThe presence of volcanic ash in the signal path between a GPS satellite and a ground-based receiver strongly correlates with a decrease in GPS signal strength. This effect has been seen in data collected from GPS sites located near active volcanoes; however, the sparse placement of existing GPS sites limits the applicability of this technique as an ash plume detection method to relatively few well-instrumented volcanoes. This deficiency has motivated the development of a low-cost distributed sensor system based on navigation-grade GPS receivers, which can take advantage of attenuated GPS signals to increase the quality and availability of real-time ash plume observations during an eruption. This GPS-based system has been designed specifically to meet remote sensing needs while operating autonomously in difficult conditions and minimizing on-site infrastructure requirements. Prototypes of this system have undergone long-term testing and the data collected from this testing have been used to develop the additional processing steps necessary to account for the different behavior of navigation grade GPS equipment compared to the geodetic equipment used at existing GPS sites.


Eos ◽  
2010 ◽  
Vol 91 (33) ◽  
pp. 296
Author(s):  
Leslie Ofori ◽  
Ernie Tretkoff
Keyword(s):  

Author(s):  
Franco Marenco ◽  
Ben Johnson ◽  
Kate Turnbull ◽  
Stuart Newman ◽  
Jim Haywood ◽  
...  

Author(s):  
Andri Wibowo

Recently on the December 4, 2021 at 03:00 PM, 3676 m high Mount Semeru located in the East parts of Java Island has erupted. To our best knowledge, an immediate and rapid systematic analysis of the volcanic ash plume courses, PM2.5 emissions, and environmental impacts based on Mount Semeru eruption has not been implemented so far. Then, this research aims to provide and fill the research gap on the rapid assessment of recent Mount Semeru eruption. From the result, it is clearly visible that for 12 hours the volcanic ash plume course was eastward. The volcanic ash plume can travel a distance of 0–10 km to the North and South directions, and more than 10 km to the East direction. The size of the volcanic ash plume was large at 02:00 AM on December 5, 2021. The smallest size of a volcanic ash plume was recorded at 09:00 PM on December 4, 2021. Most parts of the ash plume (55.98%) or equals 39.01 km2 contain fallen volcanic material amounts ranged from 1 kg/m2 to 10 kg/m2. The fallen volcanic material amount peaked between 08:00 PM and 11:00 PM. Based on the estimation, the PM2.5 content in the atmosphere increased after the eruption. The mean of PM2.5 before the eruption was 48.5 ± 19.3(95%CI: 29.2 to 67.8 ug/m3). While after eruption the mean of PM2.5 was 79.4 ± 32.2(95%CI: 47.2 to112 ug/m3). It indicated that the Mount Semeru eruption has increased the PM2.5 equals 63.65%.


2011 ◽  
Vol 11 (6) ◽  
pp. 16417-16437 ◽  
Author(s):  
M. Pitz ◽  
J. Gu ◽  
J. Soentgen ◽  
A. Peters ◽  
J. Cyrys

Abstract. During the time period of the Eyjafjallajökull volcano eruption in 2010 increased mass concentration of PM10 (particulate matter, diameter <10 μm) were observed at ground level in Augsburg, Germany. In particular on 19 and 20 April 2010 the daily PM10 limit value of 50 μg m−3 was exceeded. Because ambient particles are in general a complex mixture originating from different sources, a source apportionment method (positive matrix factorization; PMF) was applied to particle size distribution data in the size range from 3 nm to 10 μm to identify and estimate the volcanic ash contribution to the overall PM10 load in the ambient air in Augsburg. A PMF factor with relevant particle mass concentration in the size range between 1 and 4 μm (maximum at 2 μm) was associated with long range transported dust. This factor increased from background concentration to high levels simultaneously with the arrival of the volcanic ash plume in the planetary boundary layer. Hence, we assume that this factor could be used as an indicator for the impact of the Eyjafjallajökull ash plume on ground level in Augsburg. From 17 to 22 April 2010 long range transported dust factor contributed on average 30.2 % (11.6 μg m−3) to PM10. On 19 April 2010 at 20:00 UTC+1 the maximum percentage of the long range transported dust factor accounted for around 65 % (35 μg m−3) to PM10 and three hours later the maximum absolute value with around 48 μg m−3 (61 %) was observed. Additional PMF analyses for a Saharan dust event occurred in May and June 2008 suggest, that the long range transported dust factor could also be used as an indicator for Saharan dust events.


Sign in / Sign up

Export Citation Format

Share Document