A High-Gain 1.75-GHz Dual-Inductor Transimpedance Amplifier With Gate Noise Suppression for Fast Radiation Detection

2016 ◽  
Vol 63 (4) ◽  
pp. 356-360 ◽  
Author(s):  
Inyong Kwon ◽  
Taehoon Kang ◽  
Byron T. Wells ◽  
Lawrence D'Aries ◽  
Mark D. Hammig
Keyword(s):  
Noise Suppression ◽  
Radiation Detection ◽  
High Gain ◽  
Transimpedance Amplifier

scholarly journals A Sub-mW 18-MHz MEMS Oscillator Based on a 98-dBΩ Adjustable Bandwidth Transimpedance Amplifier and a Lamé-Mode Resonator

Sensors ◽  
2019 ◽  
Vol 19 (12) ◽  
pp. 2680
Author(s):  
Anoir Bouchami ◽  
Mohannad Y. Elsayed ◽  
Frederic Nabki
Keyword(s):  
Phase Noise ◽  
Cmos Technology ◽  
High Gain ◽  
Transimpedance Amplifier ◽  
Short Term ◽  
Microelectromechanical System ◽  
Fully Differential ◽  
Mems Oscillator ◽  
Measured Input ◽  
Mode Resonator

This paper presents a microelectromechanical system (MEMS)-based oscillator based on a Lamé-mode capacitive micromachined resonator and a fully differential high-gain transimpedance amplifier (TIA). The proposed TIA is designed using TSMC 65 nm CMOS technology and consumes only 0.9 mA from a 1-V supply. The measured mid-band transimpedance gain is 98 dB Ω and the TIA features an adjustable bandwidth with a maximum bandwidth of 142 MHz for a parasitic capacitance C P of 4 pF. The measured input-referred current noise of the TIA at mid-band is below 15 pA/ Hz . The TIA is connected to a Lamé-mode resonator, and the oscillator performance in terms of phase noise and frequency stability is presented. The measured phase noise under vacuum is −120 dBc/Hz at a 1-kHz offset, while the phase noise floor reaches −127 dBc/Hz. The measured short-term stability of the MEMS-based oscillator is ±0.25 ppm.

scholarly journals Design of a Simple UV Double Beam Spectrophotometer Detector Based on a High Gain Trans Impedance Operational Amplifiers for RNA Measurement

2016 ◽  
Vol 4 (2) ◽  
pp. 24
Author(s):  
Alakhib Ibrahim Abdelbary ◽  
Abdelrahim Elobied Ahmed
Keyword(s):  
Nucleic Acid ◽  
High Gain ◽  
Operational Amplifiers ◽  
Nucleic Acid Detection ◽  
Transimpedance Amplifier ◽  
Amplifier Circuit ◽  
Double Beam ◽  
Prototype Design

In this work a simple double beam spectrophotometer detector for the nucleic acid detection has been designed. The developed system contains photodiodes as a sensor, logarithamatic transimpedance amplifier circuit and filter circuit.The developed prototype design accuracy is validated by running a RNA sample and the result shows that our simplified developed setup detects the present of RNA in the sample.

High-gain transimpedance amplifier in InP-based HBT technology for the receiver in 40-Gb/s optical-fiber TDM links

2000 ◽  
Vol 35 (9) ◽  
pp. 1260-1265 ◽  
Author(s):  
J. Mullrich ◽  
H. Thurner ◽  
E. Mullner ◽  
J.F. Jensen ◽  
W.E. Stanchina ◽  
...  
Keyword(s):  
Optical Fiber ◽  
High Gain ◽  
Transimpedance Amplifier

scholarly journals The Isotopx NGX and the ATONA Faraday Amplifiers

2020 ◽  
Author(s):  
Stephen E. Cox ◽  
Sidney R. Hemming ◽  
Damian Tootell
Keyword(s):  
Mass Spectrometer ◽  
Dynamic Range ◽  
Noble Gas ◽  
High Dynamic Range ◽  
High Gain ◽  
Low Noise ◽  
Transimpedance Amplifier ◽  
Noise Floor ◽  
Baseline Noise ◽  
Noise Measurements

Abstract. We installed the new Isotopx ATONA Faraday cup detector amplifiers on an Isotopx NGX mass spectrometer at Lamont-Doherty Earth Observatory in early 2018. The ATONA is a capacitive transimpedance amplifier, which differs from the traditional resistive transimpedance amplifier used on most Faraday detectors for mass spectrometry. Instead of a high gain resistor, a capacitor is used to accumulate and measure charge. The advantages of this architecture are a very low noise floor, rapid response time, stable baselines, and very high dynamic range. We show baseline noise measurements and measurements of argon from air and cocktail gas standards to demonstrate the capabilities of these amplifiers. The ATONA exhibits a noise floor better than a traditional 1013 Ω amplifier in normal noble gas mass spectrometer usage, superior gain and baseline stability, and an unrivaled dynamic range that makes it practical to measure beams ranging in size from below 10−16 A to above 10−9 A using a single amplifier.

Enhanced bandwidth, high gain, low noise transimpedance amplifier for asynchronous optical sampling systems

2019 ◽  
Vol 90 (6) ◽  
pp. 063103 ◽  
Author(s):  
Xue Yang ◽  
Bo Su ◽  
Yaxiong Wu ◽  
Hongfei Zhang ◽  
David R. Jones
Keyword(s):  
High Gain ◽  
Low Noise ◽  
Transimpedance Amplifier ◽  
Optical Sampling ◽  
Sampling Systems
Sign in / Sign up

Export Citation Format

Share Document