Degradation mechanisms of GaAs PHEMTs in high humidity conditions

Author(s):  
T. Hisaka ◽  
Y. Aihara ◽  
Y. Nogami ◽  
H. Sasaki ◽  
Y. Uehara ◽  
...  
2005 ◽  
Vol 45 (12) ◽  
pp. 1894-1900 ◽  
Author(s):  
Takayuki Hisaka ◽  
Yasuki Aihara ◽  
Yoichi Nogami ◽  
Hajime Sasaki ◽  
Yasushi Uehara ◽  
...  

Author(s):  
Takayuki Hisaka ◽  
Hajime Sasaki ◽  
Yoichi Nogamni ◽  
Kenji Hosogi ◽  
Naohito Yoshida ◽  
...  

Author(s):  
Bhanu Sood ◽  
Lucas Severn ◽  
Michael Osterman ◽  
Michael Pecht ◽  
Anton Bougaev ◽  
...  

Abstract A review of the prevalent degradation mechanisms in Lithium ion batteries is presented. Degradation and eventual failure in lithium-ion batteries can occur for a variety of dfferent reasons. Degradation in storage occurs primarily due to the self-discharge mechanisms, and is accelerated during storage at elevated temperatures. The degradation and failure during use conditions is generally accelerated due to the transient power requirements, the high frequency of charge/discharge cycles and differences between the state-of-charge and the depth of discharge influence the degradation and failure process. A step-by-step methodology for conducting a failure analysis of Lithion batteries is presented. The failure analysis methodology is illustrated using a decision-tree approach, which enables the user to evaluate and select the most appropriate techniques based on the observed battery characteristics. The techniques start with non-destructive and non-intrusive steps and shift to those that are more destructive and analytical in nature as information about the battery state is gained through a set of measurements and experimental techniques.


Author(s):  
Bhanu Sood ◽  
Diganta Das ◽  
Michael H. Azarian ◽  
Michael Pecht

Abstract Negative resistance drift in thick film chip resistors in high temperature and high humidity application conditions was investigated. This paper reports on the investigation of possible causes including formation of current leakage paths on the printed circuit board, delamination between the resistor protective coating and laser trim, and the possibility of silver migration or copper dendrite formation. Analysis was performed on a set of circuit boards exhibiting failures due to this phenomenon. Electrical tests after mechanical and chemical modifications showed that the drift was most likely caused by moisture ingress that created a conductive path across the laser trim.


2018 ◽  
Vol 69 (8) ◽  
pp. 2197-2208
Author(s):  
Carmen Otilia Rusanescu ◽  
Erol Murad ◽  
Cosmin Jinescu ◽  
Marin Rusanescu

In the present paper are presented the experimental results of biomass gasification, the biochair was produced from vineyards by controlled pyrolysis at 750 �C, in order to increase the fertility of soils, it was found the increase of the fertility produced by the development of the vegetables in the soil to which was added biochar. Soil was added to soil 4 g/dm3 biochar, 8 g/dm3 biochar, the soil had no high humidity, was taken at a time when it had not rained for at least one week, the soil pH was 8, in the soil with 8 g/dm3 biochar the plants increased compared to the soil with 4 g/dm3 and the soil without biochar. The biochar resulting from pyrolysis and gasification processes is a valuable amendment to agricultural soils and an efficient and economical way to seize carbon. Using biochar it is possible to increase the diversity of agricultural land in an environmentally sound way in areas with depleted soils, limited organic resources and insufficient water for development. Helps to soil carbon sequestration with negative CO2 balance, increases the productive potential of agricultural ecosystems.


2019 ◽  
Vol 10 (1) ◽  
Author(s):  
Song Chen ◽  
Weiran Cao ◽  
Taili Liu ◽  
Sai-Wing Tsang ◽  
Yixing Yang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document