Stabilizing controller design for multi-bus MVDC distribution systems using a passivity based stability criterion and positive feed-forward control

Author(s):  
Jonathan Siegers ◽  
Silvia Arrua ◽  
Enrico Santi
Author(s):  
Milos Milanovic ◽  
Verica Radisavljevic-Gajic

This paper presents, a novel controller design technique that can be used for the Proton Exchange Membrane Fuel Cell to tackle the impact of the sudden stack current disturbances. The proposed controller design consists of three components: a full-state feedback control loop, an integral of error control loop and a feed-forward control loop. The feed-forward control loop is designed to ease the impact of the piecewise continuous current disturbance on the stack voltage. Linearized system matrices are set up in such a way that a new augmented system is formed. Controller gains are calculated by using a quadratic performance criterion which is minimized along the trajectories of the augmented system. Simulation results are presented and discussed.


2015 ◽  
Vol 643 ◽  
pp. 61-67
Author(s):  
Shu Wu ◽  
Yasunori Kobori ◽  
Haruo Kobayashi

This paper presents usage of analog feed-forward control to improve the transient response of DC-DC buck converters with pulse-width-modulation (PWM). The analog feed-forward controller is simple and does not require complicated calculations. Duty cycle is modulated directly based on the charge balance of the output capacitor. Compared with conventional feedback control, this simple feed-forward controller reduces control delay and provides a satisfactory transient response. We apply this technique to a Single-Inductor-Dual-Output (SIDO) buck converter as well as a Single-Inductor-Single-Output (SISO) buck converter, and show that its cross-regulation is improved. We have validated the proposed method with SIMetrix simulations.


2020 ◽  
Vol 53 (2) ◽  
pp. 1331-1336
Author(s):  
Sven Pfeiffer ◽  
Annika Eichler ◽  
Holger Schlarb

2014 ◽  
Vol 989-994 ◽  
pp. 3386-3389
Author(s):  
Zhu Wen Yan ◽  
Hen An Bu ◽  
Dian Hua Zhang ◽  
Jie Sun

The influence on the shape of the strip from rolling force fluctuations has been analyzed. The combination of intermediate roll bending and work roll bending has been adopted. The principle of rolling force feed-forward control has been analyzed. The feed-forward control model has been established on the basis of neural networks. The model has been successfully applied to a rolling mill and a good effect has been achieved.


2010 ◽  
Vol 32 (10) ◽  
pp. 1678-1685 ◽  
Author(s):  
Jason B. Carmel ◽  
Sangsoo Kim ◽  
Marcel Brus-Ramer ◽  
John H. Martin

Sign in / Sign up

Export Citation Format

Share Document