Photoconductive analysis of defect density of hydrogenated amorphous silicon during room-temperature plasma posthydrogenation, light soaking, and thermal annealing

1996 ◽  
Vol 53 (4) ◽  
pp. 1886-1890 ◽  
Author(s):  
J. P. Conde ◽  
M. Gonçalves ◽  
P. Brogueira ◽  
V. Schotten ◽  
V. Chu
Keyword(s):  
Amorphous Silicon ◽  
Thermal Annealing ◽  
Room Temperature ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Temperature Plasma ◽  
Hydrogenated Amorphous

Room-temperature electroluminescence of Er-doped hydrogenated amorphous silicon

1998 ◽  
Vol 227-230 ◽  
pp. 1164-1167 ◽  
Author(s):  
Oleg Gusev ◽  
Mikhail Bresler ◽  
Alexey Kuznetsov ◽  
Vera Kudoyarova ◽  
Petr Pak ◽  
...  
Keyword(s):  
Amorphous Silicon ◽  
Room Temperature ◽  
Hydrogenated Amorphous Silicon ◽  
Er Doped ◽  
Hydrogenated Amorphous

The Spectral Dependence of the Non-Radiative Efficiency in Hydrogenated Amorphous Silicon

1992 ◽  
Vol 258 ◽  
Author(s):  
J. Fan ◽  
J. Kakalios
Keyword(s):  
Amorphous Silicon ◽  
Room Temperature ◽  
Hydrogenated Amorphous Silicon ◽  
Free Carrier ◽  
Radiative Efficiency ◽  
Sharp Minimum ◽  
Carrier Thermalization ◽  
Hydrogenated Amorphous ◽  
Kinetics Of ◽  
Heat Released

ABSTRACTThe room temperature non-radiative efficiency, defined as the ratio of the heat released per absorbed photon for doped and undoped hydrogenated amorphous silicon (a-Si:H) has been measured using photo-pyroelectric spectroscopy (PPES) for photon energies ranging from 2.5 to 1.6 eV. There is a fairly sharp minimum in the non-radiative efficiency when the a-Si:H is illuminated with near bandgap photons. We describe a model wherein this minimum arises from the variation in the amount of heat generated by free carrier thermalization as the incident photon energy is varied, and report measurements of the excitation kinetics of the non-radiative efficiency which support this proposal.

scholarly journals Numerical Design of Ultrathin Hydrogenated Amorphous Silicon-Based Solar Cell

2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
F. X. Abomo Abega ◽  
A. Teyou Ngoupo ◽  
J. M. B. Ndjaka
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Amorphous Silicon ◽  
Buffer Layer ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Theoretical Work ◽  
Silicon Based ◽  
The Impact ◽  
Hydrogenated Amorphous

Numerical modelling is used to confirm experimental and theoretical work. The aim of this work is to present how to simulate ultrathin hydrogenated amorphous silicon- (a-Si:H-) based solar cells with a ITO BRL in their architectures. The results obtained in this study come from SCAPS-1D software. In the first step, the comparison between the J-V characteristics of simulation and experiment of the ultrathin a-Si:H-based solar cell is in agreement. Secondly, to explore the impact of certain properties of the solar cell, investigations focus on the study of the influence of the intrinsic layer and the buffer layer/absorber interface on the electrical parameters ( J SC , V OC , FF, and η ). The increase of the intrinsic layer thickness improves performance, while the bulk defect density of the intrinsic layer and the surface defect density of the buffer layer/ i -(a-Si:H) interface, respectively, in the ranges [109 cm-3, 1015 cm-3] and [1010 cm-2, 5 × 10 13  cm-2], do not affect the performance of the ultrathin a-Si:H-based solar cell. Analysis also shows that with approximately 1 μm thickness of the intrinsic layer, the optimum conversion efficiency is 12.71% ( J SC = 18.95   mA · c m − 2 , V OC = 0.973   V , and FF = 68.95 % ). This work presents a contribution to improving the performance of a-Si-based solar cells.

Radiation hard amorphous silicon particle sensors

2005 ◽  
Vol 862 ◽  
Author(s):  
N. Wyrsch ◽  
C. Miazza ◽  
S. Dunand ◽  
C. Ballif ◽  
A. Shah ◽  
...  
Keyword(s):  
Amorphous Silicon ◽  
Proton Beam ◽  
Thermal Annealing ◽  
Silicon Particle ◽  
Hydrogenated Amorphous Silicon ◽  
High Energy ◽  
Significant Drop ◽  
Radiation Hard ◽  
Hydrogenated Amorphous ◽  
Subsequent Thermal Annealing

AbstractRadiation tests of 32 μm thick hydrogenated amorphous silicon n-i-p diodes have been performed using a high energy 24 GeV proton beam up to fluences in excess of 1016 protons/cm2. The results are compared to irradiation of similar 1 μm and 32 μm thick n-i-p diodes using a proton beam of 280 keV at a fluence of 3x1013 protons/cm2. Even though both types of irradiation cause a significant drop in photoconductivity of thin or thick diodes, all samples survived the experiment and recover almost fully after a subsequent thermal annealing.

Reduction of the Defect Density in a-Si:H Deposited at ≤250°C

1993 ◽  
Vol 297 ◽  
Author(s):  
Hitoshi Nishio ◽  
Gautam Ganguly ◽  
Akihisa Matsuda
Keyword(s):  
Diffusion Coefficient ◽  
Amorphous Silicon ◽  
Surface Diffusion ◽  
Film Growth ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Device Fabrication ◽  
Surface Diffusion Coefficient ◽  
Hydrogenated Amorphous ◽  
Substrate Temperatures

We present a method to reduce the defect density in hydrogenated amorphous silicon (a-Si:H) deposited at low substrate temperatures similar to those used for device fabrication . Film-growth precursors are energized by a heated mesh to enhance their surface diffusion coefficient and this enables them to saturate more surface dangling bonds.

Improved Light Soaking Stability of R.F. Sputter Deposited Amorphous Silicon

1991 ◽  
Vol 219 ◽  
Author(s):  
A. Wynveen ◽  
J. Fan ◽  
J. Kakalios ◽  
J. Shinar
Keyword(s):  
Amorphous Silicon ◽  
Hydrogen Content ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Dark Conductivity ◽  
Initial Defect ◽  
Optical Gap ◽  
Sputter Deposited ◽  
Staebler Wronski Effect ◽  
Hydrogenated Amorphous

ABSTRACTStudies of r.f. sputter deposited hydrogenated amorphous silicon (a-Si:H) find that the light induced decrease in the dark conductivity and photoconductivity (the Staebler-Wronski effect) is reduced when the r.f. power used during deposition is increased. The slower Staebler-Wronski effect is not due to an increase in the initial defect density in the high r.f. power samples, but may result from either the lower hydrogen content or the smaller optical gap found in these films.

Crystallization of Hydrogenated Amorphous Silicon by Rapid Thermal Method

2010 ◽  
Vol 428-429 ◽  
pp. 444-446 ◽  
Author(s):  
Rui Min Jin ◽  
Ding Zhen Li ◽  
Lan Li Chen ◽  
Xin Feng Guo ◽  
Jing Xiao Lu
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Thermal Annealing ◽  
Raman Spectra ◽  
Rapid Thermal Annealing ◽  
Glass Substrate ◽  
Hydrogenated Amorphous Silicon ◽  
Thermal Method ◽  
Hydrogenated Amorphous ◽  
Electronic Microscope

Amorphous silicon films prepared by PECVD on silex glass substrate has been crystallized by rapid thermal annealing (RTA), From the Raman spectra and scanning electronic microscope (SEM), it was found that the Raman spectra wa best crystallized at 950°C for 5 min. The thin film made by RTA was smoothly and perfect structure.

Sign in / Sign up

Export Citation Format

Share Document