scholarly journals Collisions involving antiprotons and antihydrogen: an overview

Author(s):  
S. Jonsell

I give an overview of experimental and theoretical results for antiproton and antihydrogen scattering with atoms and molecules (in particular H, He). At low energies ( 1 keV) there are practically no experimental data available. Instead I compare the results from different theoretical calculations, of various degrees of sophistication. At energies up to a few tens of eV, I focus on simple approximations that give reasonably accurate results, as these allow quick estimates of collision rates without embarking on a research project. This article is part of the Theo Murphy meeting issue ‘Antiproton physics in the ELENA era’.

1987 ◽  
Vol 109 (1) ◽  
pp. 48-54 ◽  
Author(s):  
M. Th. Sideris ◽  
R. A. Van den Braembussche

Detailed velocity measurements, using Laser Doppler Anemometry (LDA) and static pressure measurements in the vane/ess diffuser of a centrifugal compressor, are presented. They show the relation between the circumferential variation of the pressure and the local flow in the diffuser and at the impeller exit. Theoretical calculations using an impeller-diffuser interaction model have been made. A comparison between the theoretical results and experimental data allows an evaluation of the possibilities and shortcomings of such a calculation. It also illustrates the mechanisms by which the variation of the impeller outlet velocity is defined.


1975 ◽  
Vol 53 (21) ◽  
pp. 2415-2420 ◽  
Author(s):  
Serafin Fraga ◽  
K. M. S. Saxena ◽  
Jacek Karwowski ◽  
Brian Bray

A table of all the ionization potentials of the elements lithium through krypton is presented.These values have been derived from the theoretical results obtained, within the Hartree–Fock method and including all the relativistic corrections, for the total energies of the ground states. The characteristics of the theoretical method are briefly outlined.Comparison with available experimental data establishes the excellent predictive value of the theoretical results.


2020 ◽  
Vol 0 (9) ◽  
pp. 16-23
Author(s):  
A. L. Vorontsov ◽  
◽  
I. A. Nikiforov ◽  

The results of an experimental check of the obtained theoretical formulae allowing us to determine the most important parameters of extrusion cartridges with a counterpunch for different hollow radiuses and bottom-most part thicknesses are presented. Characteristics of used tools, geometric parameters of extrusion experiments, strength characteristics of deformed materials and lubricants are described in detail. Both strain-hardening material and strain-unhardening material were studied. Methodology of the theoretical calculations is demonstrated in detail. High accuracy of the obtained design formulae was confirmed.


1990 ◽  
Vol 112 (4) ◽  
pp. 590-595 ◽  
Author(s):  
J. H. Steward

In this paper, the requirements for an accurate 3D model of the tooth contact-line load distribution in real spur gears are summarized. The theoretical results (obtained by F.E.M.) for the point load compliance of wide-faced spur gear teeth are set out. These values compare well with experimental data obtained from tests on a large spur gear (18 mm module, 18 teeth).


1. The equations of motion of viscous fluid (obtained by grafting on certain terms to the abstract equations of the Eulerian form so as to adapt these equations to the case of fluids subject to stresses depending in some hypothetical manner on the rates of distortion, which equations Navier seems to have first introduced in 1822, and which were much studied by Cauchy and Poisson) were finally shown by St. Venant and Sir Gabriel Stokes, in 1845, to involve no other assumption than that the stresses, other than that of pressure uniform in all directions, are linear functions of the rates of distortion, with a co-efficient depending on the physical state of the fluid. By obtaining a singular solution of these equations as applied to the case of pendulums in steady periodic motion, Sir G. Stokes was able to compare the theoretical results with the numerous experiments that had been recorded, with the result that the theoretical calculations agreed so closely with the experimental determinations as seemingly to prove the truth of the assumption involved. This was also the result of comparing the flow of water through uniform tubes with the flow calculated from a singular solution of the equations so long as the tubes were small and the velocities slow. On the other hand, these results, both theoretical and practical, were directly at variance with common experience as to the resistance encountered by larger bodies moving with higher velocities through water, or by water moving with greater velocities through larger tubes. This discrepancy Sir G. Stokes considered as probably resulting from eddies which rendered the actual motion other than that to which the singular solution referred and not as disproving the assumption.


2016 ◽  
Vol 104 (8) ◽  
Author(s):  
Junhua Luo ◽  
Chunlei Wu ◽  
Li Jiang ◽  
Long He

Abstract:The cross sections for (n,x) reactions on samarium isotopes were measured at (d-T) neutron energies of 13.5 and 14.8 MeV with the activation technique. Samples were activated along with Nb and Al monitor foils to determine the incident neutron flux. Theoretical calculations of excitation functions were performed using the nuclear model codes TALYS-1.6 and EMPIRE-3.2 Malta with default parameters, at neutron energies varying from the reaction threshold to 20 MeV. The results were discussed and compared with experimental data found in the literature. At neutron energies 13.5 and 14.8 MeV, the cross sections of the


2018 ◽  
Vol 140 (8) ◽  
Author(s):  
Eduard Amromin

According to several known experiments, an increase of the incoming flow air content can increase the hydrofoil lift coefficient. The presented theoretical study shows that such increase is associated with the decrease of the fluid density at the cavity surface. This decrease is caused by entrainment of air bubbles to the cavity from the surrounding flow. The theoretical results based on such explanation are in a good agreement with the earlier published experimental data for NACA0015.


2013 ◽  
Vol 2013 ◽  
pp. 1-4
Author(s):  
A. Gonzalez-Cisneros ◽  
F. L. Castillo-Alvarado ◽  
J. Ortiz-Lopez ◽  
G. Contreras-Puente

In CdS/CdTe solar cells, chemical interdiffusion at the interface gives rise to the formation of an interlayer of the ternary compoundCdSxCdTe1-x. In this work, we evaluate the effects of this interlayer in CdS/CdTe photovoltaic cells in order to improve theoretical results describing experimentalC-V(capacitance versus voltage) characteristics. We extended our previous theoretical methodology developed on the basis of three cardinal equations (Castillo-Alvarado et al., 2010). The present results provide a better fit to experimental data obtained from CdS/CdTe solar cells grown in our laboratory by the chemical bath deposition (for CdS film) and the close-spaced vapor transport (for CdTe film) techniques.


2014 ◽  
Vol 8 (1) ◽  
pp. 44-48
Author(s):  
Grzegorz Mieczkowski ◽  
Krzysztof Molski

Abstract The increasing application of composite materials in the construction of machines causes strong need for modelling and evaluating their strength. There are many well known hypotheses used for homogeneous materials subjected to monotone and cyclic loading conditions, which have been verified experimentally by various authors. These hypotheses should be verified also for composite materials. This paper provides experimental and theoretical results of such verifications for bimaterial structures with interfacial cracks. Three well known fracture hypotheses of: Griffith, McClintock and Novozhilov were chosen. The theoretical critical load values arising from each hypotheses were compared with the experimental data including uni and multi-axial loading conditions. All tests were carried out with using specially prepared specimens of steel and PMMA.


Sign in / Sign up

Export Citation Format

Share Document